Autoradio FM/AM à Lecteur CD de Forte Puissance et à Face Amovible
Receptor FM/AM/Reproductor de CD de Alta Potencia y con Panel Extraíble
Rádio FM/AM/CD de Alta Potência
com Face Removível
FRANÇAIS
ESPAÑOL
Robert Bosch Corporation
Sales Group —
Blaupunkt Division
2800 South 25th Avenue,
Broadview, Illinois 60155
http://www.blaupunktUSA.com/
PORTUGUÊS
BPV655_Cover2002.06.17, 14:321
FCC WARNING
Precautions
Handling the Front Panel
This equipment has been tested and found to comply with the
limits for a Class B device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with
radio communications. However, there is no guarantee that
radio interference will not occur in particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to consult the
dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to
operate this equipment.
Features
• Detachable front panel
• Built-in power amplifier
BPV 655
(max. output : 55W × 4ch)
BPV 650
(max. output : 50W × 4ch)
• FM/AM PLL Synthesizer tuner
• 30 Station preset memory
• Travel Store / Scan tuning
• Avoid installing the unit where it would be subject to high
temperatures, such as in direct sunlight or a hot air stream
from the heater, or where it would be subject to dust, dirt, or
excessive vibration.
• Do not turn on the unit if the temperature inside the car is
very high. Always cool down the unit before usage. Parking
your car in direct sunlight will result in a temperature rise.
• If the unit does not turn on, check the connections first. Then
check whether the fuse at the back of the unit is blown.
• Carefully read this manual before using the unit. If you encounter any problems that are not covered in this manual,
please consult the dealer where you purchased the unit or
the dealer nearest to you.
• This unit has been designed specifically for playback of
compact discs bearing the following mark. Other discs can-
not be played.
Handling Compact Discs
• Be careful when removing a compact disk after the playback is completed because the disk may be extremely hot.
• Do not use non-conventional discs such as heart-shaped,
octangonal discs, etc. The player could be damaged.
• Do not expose compact discs to direct sunlight or any heat
source.
• Check all compact discs before playing, and discard
cracked, scratched or warped discs.
• Wipe dirty or damp discs outward from the centre with a
soft cloth.
• Do not use any solvents such as commercially available
cleaners, antistatic spray, or thinner to clean the compact
discs.
Attaching the Front Panel
Place the right hand side of the front panel so that the parts
A of the front panel are engaged with the parts B of the unit
as shown below. Then push the left hand side of the front
panel until it is securely locked.
Detaching the Front Panel
Remove the CD from the unit, if any, and turn off the power of
the unit.
Press the
the front panel as shown below and remove it from the unit.
REL
to unlock the front panel from the unit. Grasp
Security
To avoid theft or loss of the front panel, you can inactivate
the release button
1. Unscrew the bolt marked
unit. (See diagram above)
REL
by installing the screw provided.
at the left front side of the
*
2. Attach the front panel.
3. Select a locking screw from the mounting hardware (See
page 7) and screw it into the same hole to fasten the front
panel.
Notes
• Do not press hard on the front panel when affixing it to the
unit. No more than light to moderate pressure should be
needed.
• Make sure there is no dust or dirt on the electrical terminals
on the back of the front panel as this could cause intermitent
operation or other malfunctions.
ENGLISH
BPV655(EN)_body2002.06.17, 14:331
E-1
Connections
Warning
• To prevent short circuit, remove the key from the ignition
and disconnect the battery’s (–) terminal.
• This unit is designed for negative ground 12 V DC operation
only. You can not use it for 24 V or other types of car batteries.
ENGLISH
Connection procedure
Caution
• DO NOT connect any speaker wires to the metal body or
chassis of the vehicle.
• DO NOT connect the speaker common (–) wires to each
other.
• Connect each speaker wire directly to each speaker terminal.
• All speaker common (–) wires must remain floating.
ie. No common connections or connection to vehicle grd.
• Connect each pair of speaker leads only to a single speaker
(or speaker system) that has an impedance of least 4 ohms,
as well as adequate power-handling capability.
• Do not connect speaker leads to any inputs on external
amplifiers. This will cause damage to the internal amplifier
of this unit.
1 Make sure the car’s ignition key has been removed.
2 Disconnect the negative (–) terminal of the car’s bat-
tery.
3 Connect the wiring harness wires in the following
order : Ground wire (Black), +12V Constant Power
Supply (Yellow), +12V Accessory/Switched (Red) and
Power Antenna/Amplifier Turn On (Blue), and tape
each so they do not come in contact with each other.
4 Connect the speaker wires of the wiring harness.
5 Connect the car’s antenna terminal to the antenna
socket of the unit.
6 Connect the detachable wire harness to the unit.
7 Reconnect the negative (–) terminal of the car’s bat-
tery.
8 Start the car’s engine.
9 Make sure the unit operates properly.
E-8
Connection procedure
Preamp Out/Line Out Connections
• Since this unit has Line Level Outputs, you can use an amplifier to upgrade your vehicle stereo system.
RCA Line-out Jacks
White (Left)
Red (Right)
RCA Line-out Jacks (For Rear Speakers)
• Connect a patch cable (not supplied) from the White (left rear channel) and Red (right rear channel) RCA line output jacks of
the unit to the line input terminals of the external amplifier.
External Amplifier
Rear Speaker
BPV655(EN)_body2002.06.17, 14:338
Maintenance
Replacing the Fuse
If the fuse is blown, check the power connection first and
then replace the fuse. If the fuse blows again under normal
conditions, the unit may be defective.
Back of the unit
Warning
Use only a fuse with the specified amperage (10 A).
Use of another type of fuse can result in a fire or unit damage.
Cleaning the Connectors
If the connectors of the unit and the front panel are contaminated, malfunctions may occur.
Detach the front panel and clean the connectors with an alcohol dampened cotton swab as shown below.
Main unitBack of the front panel
Returning to the Initial Settings
When the Eject button is pressed for more than 10 seconds,
the microcomputer of the unit returns to the initial settings. If
the display window is not properly shown or the unit malfunctions, press the Eject button for more than 10 seconds.
Removing the Unit
Use the supplied release keys when you need to remove the
unit from the car.
Insert them into the unit as shown below. This will unlock the
unit from the sleeve, allowing for removal of the unit.
Note
• Handle the release keys carefully to avoid injuring your fingers.
• Keep the release keys in a safe place for future use.
ENGLISH
BPV655(EN)_body2002.06.17, 14:339
E-9
Troubleshooting Guide
Specifications
The following check will assist in the correction of most problems which you may encounter with your unit. Before going
through the check list below, refer back to the connection and
operating procedures.
General
Trouble
ENGLISH
• Memorized stations and
correct time are erased.
• The fuse has blown.
• Radio works when the igni-
tion key is the ON, ACC and
OFF positions.
• No power is being supplied
to the unit.
• The power is continuously
supplied to the unit.
Cause/Solution
Leads are not matched
correctly with the car’s
accessory power
connector.
Check wiring for short
circuits.
The car doesn't have an
ACC position.
Radio reception
Trouble
Preset stations are not receivable.
Seek tuning is not possible
Travel Store feature does
not complete storing of six
stations.
Also make sure that antenna is connected, extended and dry
inside.
If the above mentioned solutions do not help to improve the
situation, consult your nearest Blaupunkt dealer or in the
United States call 1-800-266-2528 for technical assistance,
parts and service. Call 1-800-950-2528 for dealer referral or
to request product brochure.
Cause/Solution
The broadcast signal is too
weak.
The broadcast signal is too
weak. → Use manual tuning.
Not enough broadcast frequencies are receivable.
CD Player Troubleshooting
When problems occur with CD playback, an error message
appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists, contact your
nearest Blaupunkt dealer.
Message Possible causeRecommended action
E-01Dirty disc.Clean the disc.
E-02Focus error.Try ejecting and re-insert-
E-03Data and focus error. Under normal temperature
E-04Mechanical problem. Eject and re-insert.
E-05Loading/Eject error. Eject and re-insert.
Scratched disc.Replace the disc.
Up-side-down.Check the disc.
ing under normal temperature conditions.
conditions, eject and insert
clean, undamaged disc
properly.
GENERAL
Dimensions: Approx. 178 mm × 50 mm × 155 mm
Power requirements : 12 volts DC car battery
Output Power: RMS and Peak Power ratings (188
Output Wiring: Floating-ground type designed for 4
Output Impedance : Compatible with 4-8 ohm speakers.
Low - Level Output : 2 V.