Blaupunkt BM 1402 CM4 User Manual

VELOCITY POWER
BMW PLUG & PLAY SPEAKER UPGRADE
BM 1402 CM4 BM 1402 CU4
Operating and Installation Instructions
INTRODUCTION SPECIFICATION
Proper system planning is vital in order to maximize the device’s performance and road safety. Plan your instal lation carefully to avoid compromising performance reliability of the system. Consult an authorized Blaupunkt delaler for installation or reparation. Read the manual carefullt before operating the device for the rst time.
Safety Notes
Ensure to folow below safety notes during installation and wiring connection: -
Disconnect the negative terminal of the battery. Refer to the safety notes of the vehcle manufacturer.
Ensure positions of the holes are nowhere near the ve hicle component to avoid any damage during drilling.
Ensure cross section of the cable is no less than
2.5mm if the positive and negative cables are too long.
Incorrect installation may result in malfunction of the
• device or the car sound system.
Installation and Connection Instructions
Select a dry and well-ventilated location to install
the device.
The device must not be installed in overly exposed
location such on therear shelf, rear seat etc.
The installation location must be suitable for screw
holes and have stable ground support.
Disclaimer
In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages to property or life and whatsoever arising out of or connected with the use or misuse of our products.
USA & CANADA: This product is not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased on as-is basis. No warranty, whether expressed or implied is provided in the U.S. or Canada.
-
Voltage Supply
Use the supplied power extension cable to connect to
• the positive battery terminal.
Firmly and carefully connect the ground lead to a bare
• metal point on the vehicle chassis.
The control of the device should be a two-channel
• control, either via the preamplier output of the car sound system.
A control solely via the right or left channel is also
• possible since the low-frequency portion of the music
-
is generally identical on both channels.
Recycling and Disposal
Do not dispose of your old unit in the household trash! Use the return and collection systems available to dispose of the old device.
This manual may be updated from time to time without any notice.
BM 1420 CM4
Pair of 4” BMW direct t plug & play subwoofer to upgrade OE speaker installed for selected BMW models with paper cone material including installation instruction.
Normal output power (RMS) : 30W
Max. output power : 60W
Sensitivity : 86dB
Impedance : 4ohms
Frequency response : 80Hz – 20,000Hz
Surround : Rubber
Magnet type : Neodymium magnet
Mounting depth : 39mm
Diameter hole : 129.5mm
Overall height : 55mm
Tweeter
Mid-range
BM 1420 CU4
Pair of 4” BMW direct t plug & play subwoofer to upgrade OE speaker installed for selected BMW models with paper cone material including installation instruction.
Normal output power (RMS) : 30W
Max. output power : 60W
Sensitivity : 86dB
Impedance : 4ohms
Frequency response : 80Hz – 20,000Hz
Surround : Rubber
Magnet type : Neodymium magnet
Mounting depth : 44.5mm
Diameter hole : 114.3mm
Overall height : 55mm
Tweeter
Mid-range
Loading...
+ 3 hidden pages