Black Widow BW RAS 400 User Manual

1

Standard Features

The System has the following standard features:

• (2) 4-button remote transmitters*

• Status indicator (LED)

• Valet/Service mode switch

• Remote Start capabilities

• Extended Range Receiver

• Valet mode

• Stop & Go Feature

• Auto Cold Start

• Flashing parking lights

• Safety Inputs (Brake & Hood)

• Remote Shutdown Operation

• Remote Heater/AC Capabilities
*

S-models provided with single transmitter

Optional Features

This System has many optional features that
may require additional parts and/or labor. Please
contact your dealer for more details.

• Remote keyless entry (Door lock/unlock)

• Trunk/hatch release

• Window roll-up

Note: Some features may not be appropriate
for certain vehicles. Automatic transmission
and electronic fuel injection are required on
vehicles for use with this system.

4-BUTTON REMOTE START SYSTEM

OWNERS MANUAL

REMOTE TRANSMITTER FUNCTIONS

Actual transmitter cosmetics may vary, but button layout and
functionality remains the same.

Button 1 Locks the doors.*
Button 2 Unlocks the doors.*
Button 3 Activates Trunk Release feature.*
Button 4 Activates the Remote Start Feature.

* Optional feature

Remote Start Operation

Important: The system should be placed
into the valet mode when parked inside a
garage or being left for service. Only start
the vehicle in a well ventilated area. Do
not use in a closed garage or indoors. Be
sure to familiarize yourself with all
features prior to using this product.

REMOTE STARTING THE VEHICLE

To remote start the vehicle:
Press button 4 on the transmitter.

• The parking lights turn on.

• Approximately 2 seconds later the

system will attempt to start the vehicle.

• Once the car has started, the heater or

air conditioner will turn on and run for
the preprogrammed time (12 or 24
minutes). If the engine fails to start on
the first attempt, it will repeat the
starting procedure 2 more times. If the
vehicle fails to start after a total of 3
times the siren will chirp 4 times.

Driving vehicle after Remote Starting:

Unlock the door by pressing button 2 on the
remote transmitter. Enter vehicle, turn
ignition key to the on position (

Note: Do not

turn the key all the way to the start position as
you may damage the starter

).

Once the ignition key is turned on position,
press the brake pedal and shift the car into
the proper gear and you may now drive the
vehicle (

Note: If brake pedal is pressed prior to

turning on ignition, engine will turn off

).

REMOTE ENGINE SHUTDOWN

If the vehicle has been remotely started and
you desire to turn the vehicle off,simply press
and hold button 4 on the remote transmitter
for 3 seconds. After the motor has turned off
the doors will relock.

This feature must be

programmed during installation

.

AUTO COLD START

This feature allows the system to start and
run the vehicle every 2 hours for a period of
24 hours. This allows the engine to remain at
an operational temperature in extremely
cold weather.

Engaging the Auto Cold Start feature:

To turn Auto Cold Start on:
While holding the program switch, press
transmitter button 2 for 5 seconds.

• The parking lights will flash five times.

2

Button 1

Button 3

Button 2LED

Button 4