Black Widow BW 690C Installation Manual

Before Installing:

1. Read the INSTRUCTIONS!

2. USE A DIGITAL OR ANALOG
VOLT/OHM METER

3. BEFORE MOUNTING THE PRODUCT
CHECK THE POSSIBLE LOCATIONS
FOR THE SIREN, LED,AND MODULE
BEFORE YOU PERMANENTLY INSTALL
THEM.

4. PROTECT THE VEHICLE BY USING
FENDER COVERS.

5. ROLL DOWN THE DRIVER’S WIN­DOW BEFORE STARTING THE INSTAL­LATION.

6.ALWAYS LOOK BEFORE DRILLING.
MAKE SURE YOU WILL NOT CAUSE
DAMAGE TO VEHICLE HOSES, ELECTRI­CAL LOOMS OR PHYSICAL DAMAGE
TO VEHICLE.

7. PROGRAM THE DIP SWITCH ON
THE MODULE FIRST(SEE DIP SWITCH

INFORMATION.)

8. REMOVE DOME LIGHT FUSE TO PRE­VENT BATTERY DRAIN.

Timing Information

Automatic reset time: 30 seconds,
Arming time (when all inputs are moni-

tored): 10 seconds-active arm, passive 30
+10 seconds (40 total)
Door Lock output time: .75 seconds
or 3 seconds (programmable via dip
switch #1)
Armed output: Orange wire will pro­duce a grounded output when system is
armed.

Flashing P

arking Light Output:

Armed: 1 second pulsed,Disarmed: 2-one
second pulses. System triggered: 1 second
pulse on, 1 second off, repeated for 30
seconds.
Dome Light Output: Output is identi­cal to Flashing Parking Light Output.

1

INSTALLATION MANUAL

KEYLESS INTERFACE

2

34567