Black Widow BW 3750 Installation Manual

6R / 5-BUTTON SERIES

VEHICLE SECURITY SYSTEM

Button 1 Button 2

Button

Button 3 Button 4

Standard Features:

Two 5-Button Remote Transmitters
Status indicator (LED)
Valet / override switch
Multi-tone siren
Dual stage impact sensor
Remote panic
Remote chirp mute
Remote sensor bypass
Passive or active arming

Optional Features:

Flashing parking lights
Starter disable
Keyless entry
Remote trunk or hatch release
Illuminated entry
Hood and trunk protection
Remote auto start
Power window roll up
Glass break sensor
Microwave sensor

Note: Some features may require additional
parts and labor,and may not be appropriate for
certain vehicles . Consult your authorized dealer.

System Operation

ARMING OPERATION

To arm the system press transmitter button 1:

5

• The siren will chirp once.

• The parking lights will flash once.*

• The doors will lock.*

• The LED will turn solid for 10 seconds
then start flashing slowly. After 10
seconds the system is armed.

After Arming, if the system detects a bad
sensor or an open zone, the siren will chirp
and the parking lights will flash 4 times to
indicate a zone is open. The system will
ignore that input, but keep all other areas
protected.

While Armed, the system will trigger if:

• The doors are opened.

• The shock sensor detects an impact.

• An optional sensor is disturbed.

• The hood or trunk is opened.

When triggered by the door or hood/trunk
input the siren will sound, the horn will
honk, and the parking lights will flash for 45
seconds. If triggered by a sensor, the alarm
cycle will last 30 seconds.

If the same input triggers the system 3 times
during a single arming cycle, the system will
bypass that input, keeping the other zones
protected, until the next time the system is
armed.

If the shock sensor detects a light impact to
the vehicle or an optional sensor is
disturbed, the system will chirp and the
parking lights will flash 5 times to warn away
the potential intruder.

Optional Feature

*

1

P ASSIVE ARMING

The passive arming feature allows the system
to automatically arm after closing all doors.
The Passive Arming feature requires the
ignition to have been on for at least 10
seconds prior to exiting the vehicle. This
enables the key to be turned on then off
quickly to avoid passive arming in the event
of refueling, washing the vehicle, etc. The

Passive Arming feature may be enabled during
installation.

To arm the system passively:

1. Turn the ignition key off (make sure
ignition was on for at least 10 seconds).

2. Exit the vehicle and close all doors.

• The LED flashes rapidly indicating that

the system is preparing to arm.(The
system can be armed at any time by
pressing transmitter button 1.)

• If the optional countdown feature is

programmed, the siren will chirp
every 2 seconds until armed.

• The siren will chirp 30 seconds after

the last door is closed to indicate the
system is armed.NO TE:Opening the
hood/trunk or a door resets the
passive arming timer.

• The doors will lock.†*

† If P assive Locking was enabled during installation.

DISARMING OPERATION

To disarm the system press transmitter
button 2.

• The siren will chirp twice.

• The parking lights will flash twice.*

• The doors will unlock.†*

• The dome light will turn on for 30
seconds.*

If the Passenger Unlock Feature is installed,

†

pressing the unlock button will unlock only the
driver's door. Pressing the unlock button again
unlocks all doors.

T AMPER ALER T

If the alarm was triggered while away from
the vehicle, the siren will chirp 3 times and
the parking lights will flash 3 times on
disarming for tamper indication. After
disarming the alarm, enter vehicle and turn
ignition on. The LED will flash the zone that
was triggered 3 times (see LED TAMPER
ALERT INDICATIONS).

AUTO REARM

The Auto Rearm feature allows the system
to automatically re-arm itself and lock the
doors* in the event the system is disarmed
and a door is not opened within 30
seconds. This programmable feature may
be enabled during installation.

SILENT ARMING/DISARMING

Press transmitter button 5 (the Shift
Button) then the Arm or Disarm button for
one-time silent operation. The system can
also be programmed for full-time silent
operation during installation.

IGNITION LOCK*

The ignition locking feature automatically
locks the doors 5 seconds after the ignition
key is turned on, and automatically unlocks
when the ignition key is turned off. To avoid
locking keys in the vehicle, the ignition
locking feature will be cancelled if a door is
open when the ignition is turned on. This

feature may be disabled during installation.

Optional feature

*

REMOTE PANIC

In the event of an emergency (PANIC)
situation, the system’s siren can be triggered
for 30 seconds to attract attention.To activate
the Panic Feature, press transmitter button 1
for 3 seconds:

2

• The siren will sound.

• The parking lights will flash*.

Press button 1 to exit panic mode and rearm
the system. Press button 2 to exit panic
mode and disarm the system. The Panic
Feature will not
on.

EMERGENCY OVERRIDE

If the transmitter becomes lost or fails to
operate, the system can be disarmed by
using the emergency override feature.

To override the system:

1. Enter the vehicle.

• Because the system is armed, the

2. Turn on the ignition key.

3. Press the Valet switch for 3 seconds.

• The siren will stop sounding.

• The starter defeat will be bypassed.

• The system will enter valet mode.

VALET MODE

When the system is placed into the Valet
Mode the security system will be disabled.
However, the optional keyless entry and
auxiliary features will still function if
installed. The valet feature may be accessed
using the valet switch or using the remote
transmitter.

To enter or exit valet mode using the switch:

1. Be sure the system is disarmed.

2. Turn the ignition key on.

3. Press and hold the valet switch for 3
seconds.

• The siren will chirp once to enter

• The LED will turn on solid indicating

operate when the ignition is

siren will sound.

valet or twice for exit.
the system is in valet mode, or turn

off indicating valet mode exit.

To enter or exit valet mode using the
remote:

1. Be sure the ignition key is off.

2. Press transmitter button 2 then button
1 and hold for 3 seconds..

• The siren will chirp once to enter

valet or twice for exit.

• The LED will turn on solid indicating

the system is in Valet Mode, or turn
off indicating Valet Mode exit.

OPTIONAL TRUNK RELEASE

Press button 3 for approximately 2 seconds
to open the trunk.

OPTIONAL TRUNK DISARM

The trunk disarm feature allows the alarm to
disarm automatically whenever transmitter
button 3 is used to activate the optional
trunk release. This eliminates having to first
disarm the alarm before activating the trunk
release. This feature must be programmed

during installation.

REMOTE SENSOR BYPASS

To arm the system and bypass the shock
sensor, press button 1 to arm,then within 2
seconds press button 4. The siren will chirp
once and sensors will be ignored until the
system is disarmed and rearmed.

OPTIONAL ANTI-CARJACK FEATURE

The optional anti-carjacking feature provides
added security with three operating modes:
Active, Passive, and Full-time. The Anti-

Carjacking feature may be enabled during
installation.

Active. Press transmitter button 4 with the

ignition on to manually activate the anti­carjacking feature. Press button 4 again to
deactivate the Activ

e carjack feature.

3

Passive. When selected, the anti-carjacking
feature will activate whenever a door is
opened while the ignition is on. Press the
valet switch 3 times to deactive the Passiv

e

carjack feature.
Full-time. When selected, the anti-carjacking

feature will automatically activate each time
the ignition is turned on. Press the valet
switch 3 times to deactive the Full-time
carjack feature.

If the carjack feature is triggered:

• The parking lights will flash two times.

• 90 seconds later the parking lights will
flash, the horn will honk, and the siren
will sound for 5 minutes.

• The starter kill will turn on and remain
on until the carjack feature is
deactivated.

TRANSMITTER FUNCTIONS

Button 1 Arm; press 3 seconds for panic
Button 2 Disarm; press twice for optional

Passenger Unlock feature
Button 3 Auxiliary function 1
Button 4 Auxiliary function 2

Transmitter Functions with Shift Key

(Button 5) pressed 1 time:

Button 1 Silent Arm
Button 2 Silent Disarm
Button 3 Auxiliary function 3
Button 4 Car Locator feature (flashes

parking lights,chirps siren,and honks horn
5 times)

Transmitter Functions with Shift Key

(Button 5) pressed 2 times:

Button 1 Arm car 2; press 3 seconds for

panic

Button 2 Disarm car 2; press twice for

optional Passenger Unlock feature
Button 3 Auxiliary function 1 for car 2
Button 4 Auxiliary function 2 for car 2

Transmitter Functions with Shift Key

(Button 5) pressed 3 times:

Button 1 Silent Arm car 2
Button 2 Silent Disarm car 2
Button 3 Auxiliary function 3 for car 2
Button 4 Car Locator feature for car 2

STATUS INDICATOR (LED)

FUNCTION

On Solid = Valet Mode
Slow Flash = System Armed
Rapid Flash when disarmed =

Passive Arming

Rapid Flash when armed =

T amper Alert

On Solid when not in valet =

Open Zone

S

LED T AMPER ALERT

INDICATIONS

(after turning on ignition)

1 Flash = optional sensor
2 Flashes = shock sensor
4 Flashes = door
5 Flashes = hood or trunk
Example:flash-flash-pause-

flash-flash-pause = shock
sensor

4

PARKING LIGHT

INDICATIONS

1 Flash = System Armed
2 Flashes = System Disarmed
3 Flashes = Tamper Alert
4 Flashes = Open Zone

Indication (after arming)
5 Flashes = Warn Away
On Solid = System Disarmed

(optional programming for 30

second output on disarm)