Black Widow BW 3650 User Manual

1

5-BUTTON / 6 RELAY SERIES

VEHICLE SECURITY SYSTEM

Standard Features:

Status indicator (green LED)
Valet / override switch
Multi-tone siren
Dual stage impact detector
Remote panic
Remote chirp mute
Remote sensor/trigger bypass
Passive or active arming

Optional Features:

Flashing parking lights
Starter disable
Keyless entry
Remote trunk or hatch release
Illuminated entry
Hood and trunk protection
Remote auto start
Power window roll up
Back-up battery w/charging circuit
Glass break sensor
Plug-in radar sensor

Note: Some features may require additional parts
and labor, and may not be appropriate for certain
vehicles. Consult your authorized dealer.

System Operation

ARMING OPERATION

To arm the system press transmitter button 1:

• The siren will chirp once.

• The parking lights will flash once.*

• The doors will lock.*

• The LED will turn solid for 10 seconds
then start flashing slowly. After 10
seconds the system is armed.

After Arming,if the system detects a bad sensor
or an open zone, the siren will chirp 4 times to
indicate a zone is open. The system will ignore
that input, but keep all other areas protected.

While the system is Armed, the system will
trigger if:

• The doors are opened.

• The shock sensor detects an impact to
the vehicle.

• An optional sensor is disturbed.

• The hood or trunk is opened.

When triggered, the siren will sound, the horn
will honk, and the parking lights will flash. If the
system is triggered by the ignition, doors,hood,
or trunk, the system will alarm for 30 seconds.

If the same input triggers the system 4 times
during a single arming cycle,the system will bypass
that input, keeping the other zones protected,
until the next time the system is armed.

If the shock sensor detects a light impact to the
car or the radar sensor detects an exterior
zone disturbance, the system win sound 5
chirps to warn away the potential intruder.

*

Optional Feature

Owner’s Manual

5-Button

Transmitter

Button 1

Button 3

Button 2

Button 4

Button 5

2

PASSIVE ARMING

The passive arming feature allows the system to
arm automatically without user intervention.

This programmable feature may be enabled during
installation.

To arm the system passively:

1. Turn the ignition key off.‡

2. Exit the vehicle and close all doors.

• The LED flashes rapidly indicating that
the system is preparing to arm. (The
system can be armed at any time by
pressing transmitter button 1.)

• The siren will chirp 30 seconds after
the last door is closed to indicate the
system is now armed.

• The doors will lock.†*

‡ The ignition must have been on for at least 5 seconds

prior to exiting the vehicle or Passive Arming will be
bypassed.

† If the Passive Locking feature was enabled during

installation.

DISARMING OPERATION

To disarm the system press transmitter button 2.

• The siren will chirp twice.

• The parking lights will flash twice.*

• The doors will unlock.†*

• The dome light will turn on for 30
seconds.*

†

If the Passenger Unlock Feature is installed,pressing
the unlock button will unlock only the driver's door.
Pressing the unlock button again unlocks all doors.

* Optional feature

TAMPER ALERT

If the alarm was triggered while away from the
vehicle, the siren will chirp 3 times and the
parking lights will flash 3 times on disarming for
tamper indication. After disarming the alarm,
enter vehicle and turn ignition on.The LED will
flash the zone that was triggered 5 times (see
LED TAMPER ALERT INDICATIONS).

AUTO REARM

The Auto Rearm feature allows the system to
automatically re-arm itself in the event the
system is disarmed and a door is not opened
within 30 seconds. This programmable feature may

be disabled during installation. The Passive Arming
feature and Auto Rearm feature are related.In order
to disable the Auto Rearm feature,the Passive Arming
feature must also be disabled during installation.

NOTE: This feature will not work on vehicles with
the illuminated entry feature enabled.

SILENT ARMING/DISARMING

Press transmitter button 5 (the Shift Button)
then the Arm or Disarm button for one-time
silent operation. The system can also be
programmed for full-time silent operation
during installation.

CHIRP DELETE

For full time silent operation, the ARM/ DISARM
chirps can be permanently disabled. This feature

must be programmed during installation.

IGNITION LOCK*

The ignition locking feature allows the doors to
automatically lock 3 seconds after the ignition
key is turned on,and automatically unlock when
the ignition key is turned off.This feature may be

disabled during installation.

*

Optional feature

REMOTE PANIC

In the event of an emergency (PANIC) situation,
the system’s siren can be triggered for 30
seconds to attract attention.To activate the Panic
Feature, press transmitter button 1 for 3
seconds:

• The siren will sound.

• The parking lights will flash*.