Black Widow BW 2450 User Manual
1
Standard Features:
Two 4-Button Remote Transmitters
Status indicator (LED)
Valet / override switch
Multi-tone siren (115dB)
Dual stage impact detector
Flashing parking lights
Remote panic
Remote sensor bypass
Passive or active arming
Anti-carjacking mode
Optional Features:
Starter disable
Keyless entry
Auxiliary Function
2nd Auxiliary Function
Remote trunk or hatch release
Illuminated entry
Hood and trunk protection
Remote auto start
Power window roll up
Back-up battery w/charging circuit
Perimeter sensor
Note: Some features may require additional
parts and labor, and may not be appropriate for
certain vehicles. Consult your authorized dealer.
System Operation
ARMING OPERATION
To arm the system press transmitter button 1:
• The siren will chirp once.
• The parking lights will flash once.*
• The doors will lock.*
• The LED will start flashing within 5
seconds and the system will be armed.
After Arming, if a bad sensor or an open
zone is detected, the siren will chirp and the
parking lights will flash 4 times to indicate a
zone is open. The system will ignore that
input, keeping all other areas protected.
While Armed, the system will trigger if:
• The doors are opened.
• The shock sensor detects an impact.
• The hood or trunk is opened.
When triggered, the siren will soundand the
parking lights will flash* for 50 seconds.
If the same input triggers the system 3 times
during a single arming cycle, the system will
bypass that input, keeping other zones
protected, until the next arming cycle.
If the shock sensor detects a light impact to
the vehicle, the siren will chirp and the
parking lights will flash 3 times to warn away
the potential intruder.
*
Optional Feature
PASSIVE ARMING
The passive arming feature allows the system
to arm itself automatically without user
intervention. The Passive Arming feature may be
enabled during installation.
1 RELAY / 4 BUTTON SERIES
VEHICLE SECURITY SYSTEM
Button 1 Button 2
Button 3 Button 4
Transmitter styles may vary
BW2450.qxd 6/11/2009 4:12 PM Page 1
2
To arm the system passively:
1. Turn the ignition key off.
2. Exit the vehicle and close all doors.
• The LED flashes rapidly indicating
that the system is preparing to arm.
• The siren will chirp 30 seconds after
the last door is closed to indicate the
system is now armed.
• The doors will lock.†*
† If Passive Locking was enabled during installation.
DISARMING OPERATION
To disarm the system press button 1 again (or
button 2 on 4-button systems).
• The siren will chirp twice.
• The parking lights will flash twice then
remain on for 10 seconds.*
• The doors will unlock.* If using the
Driver Priority unlock feature only the
driver door will unlock. Press button 2
again to unlock all doors.
• The dome light will turn on for 30
seconds.*
TAMPER ALERT
If the alarm was triggered while away, the
siren will chirp and the parking lights flash 3
times on disarm for tamper indication.
SILENT ARMING/DISARMING
Press buttons 1&2 then button 1 or 2 to Arm
or Disarm for one-time silent operation.
The system can also be programmed for fulltime silent operation during installation.
IGNITION CONTROLLED LOCKS*
The ignition locks feature automatically locks
and unlocks the doors when the ignition is
cycled on or off. To avoid locking keys in the
vehicle, the ignition locking feature will be
cancelled if a door is open when the ignition
is turned on. This feature may be disabled
during installation.
REMOTE PANIC
In the event of an emergency, the system’s
siren can be triggered for 60 seconds to
attract attention.To activate the Panic Feature,
press transmitter Button 1 for 3 seconds:
• The siren will sound.
• The parking lights will flash*.
Press button 1 again to exit panic mode. For
4-button systems press button 1 or 2 to exit
panic mode (pressing button 2 will unlock
the doors and disarm the system).The Panic
Feature will not operate when ignition is on.
*
Optional feature
EMERGENCY OVERRIDE
If the transmitter becomes lost or fails to
operate, the system can be disarmed by
using the emergency override feature.
To override the system:
1. Enter the vehicle.
• Because the system is armed, the
siren will sound.
2. Turn on the ignition key.
3. Press the Valet switch for 5 seconds.
• The siren will stop sounding.
• The starter defeat will be bypassed.
• The system will enter valet mode.
VALET MODE
When the system is placed into the Valet
Mode the security system will be disabled.
However, the optional keyless entry and
trunk release features will still function.
To enter or exit valet mode:
1. Be sure the system is disarmed.
2. Turn the ignition key on.
3. Press and hold the valet switch for 5
seconds.
• The siren will chirp 5 times to enter
valet or twice for exit.
• The LED will turn on solid indicating
BW2450.qxd 6/11/2009 4:12 PM Page 2
3
LED INDICATIONS
On Solid = Valet Mode
On Solid when not in valet = Open Zone
Slow Flash = System Armed
Rapid Flash when disarmed = Passive
Arming
Rapid Flash when armed = Tamper Alert
PARKING LIGHT INDICATIONS
1 Flash = System Armed
2 Flashes then on solid for 10 seconds =
System Disarmed
3 Flashes = Tamper Alert
4 Flashes = Open Zone Indication (after
arming)
the system is in valet mode, or turn
off indicating valet mode exit.
OPTIONAL TRUNK RELEASE
Press button 3 for approximately 3 seconds
to open the trunk.
OPTIONAL 2ND AUX/CAR FINDER
Press button 4 for approximately 3 seconds
to activate the second auxiliary output/car
finder feature. When second auxiliary
function is activated, the parking lights will
flash 5 times and the siren will chirp as
confirmation. This output can be connected
to a relay to control additional functions like
power window roll-up, or an optional device
such as a remote car starter. If the output is
not connected, it still serves as a car finder
feature to identify the vehicle in a large
parking area.
OPTIONAL ANTI-CARJACK MODE
For added security while driving the vehicle,
the optional anti-carjacking feature will
activate whenever a door is opened after the
ignition has been turned on. This feature must
be enabled during installation.
If the anti-carjack feature is triggered:
• The system will provide no indications
for 60 seconds.
• After 60 seconds, the siren will chirp for
10 seconds providing time to press the
valet switch and deactivate the system.
• If not deactivated with 10 seconds, the
system will enter full trigger mode.
• The parking lights will flash and the
siren will sound in full alarm.
• The starter defeat will turn on and until
the anti-carjack mode is deactivated.
To deactivate the anti-carjack when triggered:
1. Turn the ignition key off then back on.
2. Press the valet switch once.
• The siren will pause briefly.
3. Turn the ignition key off.
4. Press the transmitter button 2.
• The system will disarm.
BW2450.qxd 6/11/2009 4:12 PM Page 3
Loading...