Black Widow 1RP 2 Owner’s Manual

OWNERS MANUAL

1RP 2-BUTTON PLATFORM

1

Standard Features

Two 2-button transmitters
Status indicator (red LED)
Valet / override switch
Multi-tone siren (120dB)
Dual stage impact detector
Remote panic
Remote chirp mute
Remote sensor bypass
Passive or active arming

Optional Features

Remote trunk or hatch release
Remote auto start
Power window roll up
Flashing parking lights
Back up battery w/charging circuit
Additional Sensors: Glass break, Microwave
Hood and trunk protection
Illuminated entry
Starter disable
Remote keyless entry
Ignition controlled door locks

Note: Some features and options may require
additional parts and labor, and may not be appro­priate for certain vehicles.

System Operation

ARMING OPERATION:

Active Arming-To activate the
alarm, simply press button #1
on your remote control.You
will hear one chirp from your
siren, your parking lights will
flash one time .Your doors will lock (optional),
and the LED will turn solid for 10 seconds
then it will start flashing slowly, the system is
now armed.

Passive Arming- If your system was installed
to arm passively, simply turn off your ignition
key and exit the vehicle, the system will arm
30 seconds after the last door is closed. After
you close the last door, the LED will start
flashing rapidly to let you know that the sys­tem is in the Pre Arm state.You can always
arm the system at any time by pressing button
#1 on the remote.

DISARMING OPERATION:

To deactivate alarm press but­ton #1 on your remote.The
siren will chirp twice and your
parking lights will flash twice.
The LED will stop flashing, the
doors will unlock (optional), your system is
disarmed. If you have the (optional) illuminated
entry system installed the interior light will
stay on for 30 seconds or until you turn the
ignition on or rearm the system.

VALET MODE:

Valet
mode will
keep your
alarm sys­tem from
passive arming (if programmed to passive
arm), if you need to have your vehicle ser­viced, or run it through the car wash, etc. To
put your system in Valet Mode,disarm system,
turn the ignition key on and press and hold
your valet/override switch in for approximate­ly 3 seconds, the LED will turn solid, and siren
will chirp once. Your vehicle’s system is in
Valet Mode. If you have the keyless entry fea­tures, the remote will still lock and unlock the
doors or pop the trunk while in Valet Mode.To
exit Valet Mode:Turn ignition key on, press and
hold valet/override switch for approximately 3
seconds, LED will turn off and siren will chirp
2 times.

EMERGENCY OVERRIDE:

If you
lose your
trans-mit­ter, or it
fails to

Press

Press

Press

+

Hold

Press

2

ON

ON

+

+