Important safety instructions
CAUTION: High voltage! Risk of death! High voltages of up to 500 V DC may be present inside the casing for long
periods after being disconnected from the mains. To avoid lethal electric shock, do not open the casing. There are no
user-serviceable components inside. Refer all maintenance to qualied service personnel. Remove the mains cable
when the unit is not in use.
WARNING: To eliminate the risk of re and electric shock, do not expose this unit to rain or moisture and splashing or
dripping liquid, which might enter the device. Do not place any objects lled with liquid, such as vases, on the unit.
This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage
inside the enclosure—voltage that may be sufcient to constitute a risk of shock.
*
This symbol, wherever it appears, alerts you to important operating and maintenance instruc-
tions in the accompanying literature. Please read the manual.
!
Read these instructions.1)
Keep these instructions.2)
Heed all warnings.3)
Follow all instructions.4)
Do not use this apparatus near water.5)
Clean only with dry cloth.6)
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.7)
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus 8)
(including ampliers) that produce heat.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two 9)
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your safety. If the provided plug does not
t into your outlet, consult an electrician for replacement of the obsolete outlet.
Protect the power cord from being walked on or pinched particularly at plugs, convenience recep-10)
tacles, and the point where they exit from the apparatus.
The apparatus shall be connected to a MAINS socket outlet with a protective earthing connection.11)
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect de-12)
vice shall remain readily operable.
Only use attachments/accessories specied by the manufacturer.13)
Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the 14)
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
injury from tip-over.
Unplug this apparatus during lightning storms or when unused for long periods of time.15)
Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been 16)
damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
CAUTION - These service instructions are for use by qualied service personnel only. To reduce the 17)
risk of electric shock do not perform any servicing other than that contained in the operation instructions unless you are qualied to do so.
CAUTION! During use, the valves get very hot and high surface temperatures may be reached at the 18)
rear of this unit. To avoid burning yourself, make all connections while the unit is still cold.
Table of contents
IMPORTANT NOTICE! ........................................................................ 4
Introduction ..................................................................................... 4
Before you get started .......................................................................................................4
Online registration .............................................................................................................4
Control elements .............................................................................. 5
Front panel .......................................................................................................................5
Rear panel ........................................................................................................................6
Footswitch ........................................................................................................................6
Inside the BUGERA ............................................................................................................7
Instructions for qualied service personnel only .....................................................................7
Wiring the BUGERA .......................................................................... 8
Audio connections ............................................................................ 9
Specications ................................................................................. 10
Limited warranty ............................................................................ 11
IMPORTANT NOTICE!
FAILURE TO OBSERVE THE FOLLOWING POINTS MAY RESULT IN DAMAGE TO THE AMPLIFIER OR LOUDSPEAKERS. DAMAGES CAUSED IN SUCH A WAY ARE NOT COVERED BY WARRANTY.
Before you start, always make sure that your
$
Bugera Valve Amplier is connected to a suitable loudspeaker. Observe the correct impedance for your loudspeaker and use the appropriate output socket.
Always use loudspeaker cables for connection
$
between the amplier and the loudspeaker.
Never use other types of cable, like instrument cable or microphone cable.
Please ensure proper disposal of all packing
$
materials.
Ensure adequate air supply and to avoid overheating do
not place the unit near radiators etc.
Please make sure that all devices are properly
$
grounded. For your own safety, never remove
or disable the ground conductors from the devices or on the power cords. The unit must always be connected to the mains outlet with a
protective grounding connection.
The tone quality may diminish within the
$
range of powerful radio broadcasting stations
and high-frequency sources. Increase the distance between the transmitter and the unit,
and use shielded cables for all connections.
Switching the amplier on and off:
Before connecting the amplier to a power out-
$
let, make sure that both POWER and STANDBY
switches are set to the OFF position.
Power on (mandatory):
Switch the POWER switch on—wait for 60 sec-
$
onds—then switch the STANDBY switch on.
Power off (recommended):
Switch the STANDBY switch off—wait for 30
$
seconds—then switch the POWER switch off.
Note—after powering off we recommend that the ampli-
er is allowed to cool down for ten minutes before any
attempt is made to move the amplier. This reduces the
risk of mechanical damage to the sensitive valve elements.
ATTENTION! TO AVOID DAMAGE TO YOUR
AMP, NEVER USE THE BUGERA VALVE AM-
!
PLIFIER WITHOUT A LOUDSPEAKER CONNECTED!
Introduction
Congratulations! By purchasing the BUGERA, you have
chosen a state-of-the-art valve amplier.
This 120-Watt full-valve amp offers you 2 full-edged
channels with 3 tone controls, a separate switchable Effects Loop plus integrated Reverb, a Crunch function on
the Clean channel and much more. This way you’re in full
control and can get down to the nitty-gritty—your music!
Discover the killer sound of the BUGERA and be inspired
by its versatility. Whatever style you play, this monster
amp gives you the full valve power that you require.
Online registration
Please do remember to register your new BUGERA equipment right after your purchase by visiting www.bugeraamps.com and kindly read the terms and conditions of
our warranty carefully.
Should your BUGERA product malfunction, our goal is
to have it repaired as quickly as possible. To arrange for
warranty service, please contact the retailer from whom
the equipment was purchased. Should your BUGERA
dealer not be located in your vicinity, you may directly
contact the BEHRINGER company nearest to you. This
contact information is included in the original equipment packaging (Global Contact Information/European
Contact Information). Should your country not be list-
ed, please contact our exclusive distributor BEHRINGER
Singapore (BEHRINGER Holdings (Pte) Ltd., 1 Kim Seng
Promenade #08-08, Great World City West Tower, Sin-
gapore 237994, Tel.: +65 6845 1800, Fax: +65 6214
0275).
Registering your purchase and equipment with us helps
us process your repair claims quicker and more efciently.
Thank you for your cooperation!
CAUTION!
Please note that high volume levels may cause
$
permanent damage to your hearing and/or
your loudspeakers. Turn all LEVEL controls to
the left before switching on the unit. Be sure
to keep the volume at an appropriate level.
Before you get started
Your product was carefully packed at the factory to en-
sure safe transport. Nevertheless, if the box is damaged
inspect the unit immediately for signs of damage.
If the unit is damaged please do NOT return it
$
to us, but notify your dealer and the shipping
company immediately; otherwise, claims for
damage or replacement may not be granted.
Always use the original box to prevent dam-
$
age during storage or transport.
Make sure that children cannot play unsuper-
$
vised with the unit or its packaging.