Baby Lock BLJY User Manual
UPGRADING YOUR MACHINE’S SOFTWARE
Note
Note
Note
UPGRADING YOUR MACHINE’S SOFTWARE
You can use USB media or a computer to upgrade software for your sewing machine.
When an upgrade program is available on “ www.babylock.com
the instructions on the website and steps below.
• When using USB media to upgrade the software, check that no data other than the upgrade file is
saved on the USB media being used before starting to upgrade.
Upgrade Procedure Using USB
Media
While pressing the “Automatic Threading”
a
button, turn the main power to ON.
→ The following screen will appear on the LCD.
d
”, please download the files following
• The access lamp will begin blinking after
inserting USB media, and it will take about 5
to 6 seconds to recognize the media. (Time
will differ depending on the USB media).
Press .
A
1
Maintenance and Troubleshooting
Press .
b
Insert the USB media into the USB port for
c
media/mouse on the machine. The media
device should only contain the upgrade file.
→ The upgrade file is loaded.
• If an error occurs, a red text error message
will appear. When the installation is
performed successfully, following message
will appear.
a USB port for mouse/media (USB 2.0)
b USB media
Remove the USB media, and turn the
e
machine off and on again.
Appendix A-21
UPGRADING YOUR MACHINE’S SOFTWARE
Note
Note
Upgrade Procedure Using
Computer
• Do not connect any additional USB media
devices to your computer when using the
USB cable.
While pressing the “Automatic Threading”
a
button, turn the main power to ON.
→ The following screen will appear on the LCD.
Press .
b
Plug the USB cable connector into the
c
corresponding USB ports for the computer
and for the machine.
→ “Removable Disk” will appear in “Computer (My
computer)”.
Copy the upgrade file to “Removable Disk”.
d
When the message disappears, press
e
.
→ The upgrade file is loaded.
• If an error occurs, a red text error message
will appear. When the installation is
performed successfully, following message
will appear.
A-22
→ The following message will appear.
Unplug the USB cable, and turn the
f
machine off and on again.
Loading...