AZEK Reserve Connector User Manual
CONNECTOR KIT INSTALLATION GUIDELINES for
AZEK Reserve
In order to ensure beautiful installation of Trademark Reserve railing, we have four easy-to-use decorative
connector kits to fit every angle: In-Line Top Rail Connectors, 22.5 Degree Top Rail Connectors, 45 Degree Top Rail Connectors and Post Connectors. Please see below for information on each application.
CUTTING THE TOP RAIL:
When cutting the top rail, allow for approximately
1/8” gap per side between corresponding top rails
to ensure adequate space for the In-Line, 22.5 Degree or 45 Degree Top Rail Connectors.
CONNECTOR INSTALLATION:
Slide the appropriate Top Rail Connector onto the
top rail. Slide the other top rail into the other end
of the connector with the assembled top rails over
the railing section. Press the top rails onto the
retainer, ensuring that they sit fully onto the retainer. (TIP: If top rail is too snug to easily push on,
22.5 Degree Top Rail Connector
loosen the #14ss screws on the post brackets so
that the rail can be adjusted. Be sure to retighten
the screws when top rail is installed.)
Page 1
In-Line Top Rail Connector
POST CONNECTOR:
The Post Connector allows for a flush clean attachment to the post. Add a liberal amount of
caulking to the post side of the connector inside
the lip to adhere the connector to the post and
slide it onto the pre-cut Top Rail. Install the Top
Rail onto the sub rail Retainer, post side first as
per instructions.
(NOTE: Remove any excess caulking with a damp
cloth.)
45 Degree Top Rail Connector
Post Connector
ARIG_v1_0211
Loading...