Avital Diablo Installation Manual
2
Diablo
/AMX 68/AT-58 Installation Manual 3/31/99
Downloaded from: http://www.guardianalarms.net
1
Table of Contents
Required Installation Tools .......................2
Important Information.......................... 2
Wiring Diagram.............................. 3
14 Pin Con nec tor.............................. 4
Starter Dis able Re lay............................4
Installation Procedures..........................5
Con trol Unit................................ 5
An tenna .................................. 5
Wi reloom.................................. 5
1
Zone
Valet Switch ................................6
LED In di ca tor...............................6
Ig ni tion In put................................6
Chan nel 2 Ac ces sory Out put........................6
Park ing Lights...............................6
In te rior Light Trig ger ...........................7
Op tional In te rior Light Il lu mi na tion Out put................ 7
Starter Dis able ............................... 7
Two Pulse Un lock .............................8
Door Lock/Un lock Out puts ........................ 8
Hood/Trunk Pin Switch ..........................8
Si ren .................................... 8
Power and Ground Con nec tions..................... 8, 9
Door Lock Diagrams.......................... 9-11
Programming Alarm System Features.................12
Pro gram ming Ta ble for Alarm Fea tures ................. 12
Programming Your Remote Controls ................. 13
Pro gram ming Ta ble for Re mote Con trols ................ 13
Im pact Sen sor...........................5
2
2
Diablo
/AMX 68/AT-58 Installation Manual 3/31/99
Required Installation Tools
Voltmeter
Wire Strippers
Electric Drill & Bits
Phillips Screw Driver
Convoluted Tubing *
Solder Gun *
Wire Crimpers
Shrink Tube or Electrical Tape
* Op tional
Important Information
1.Test all circuits with a voltmeter.
2. Make all wiring connections with butt connectors. DO NOT twist wires
or use “scotch-lok” connectors.
3. Route RED, RED/WHITE and BLACK wires from the control unit
directly to the battery.
4. Keep extensions as short as possible. Use same gauge wires.
5. Before installing, discuss the placement of the LED indicator and valet
switch with the vehicle owner. DO NOT disconnect the battery cables.
6.Make all connections by removing the lug from the cable clamp
without detaching clamp.
7. Turn off dome light or remove dome light fuse to prevent battery drain.
This device complies with Part 15 of the FCC rules. Any changes or
modifications made to the system without the express approval of Avital
Technologies, Inc. could void the user's authority to operate this
equipment.
3
2
Diablo
/AMX 68/AT-58 Installation Manual 3/31/99
Wiring Diagram
4
2
Diablo
/AMX 68/AT-58 Installation Manual 3/31/99
14 Pin Con nec tor
Wire color De scrip tion
Red/White Parking Light Polarity Select (+) or (-)
Red/Black Parking Light Output
Red Battery (+)
Gray (-) Armed Output for Starter Disable Relay
Black Battery (-)
Violet Siren (-) Output
Tan Hood/Trunk (-) Input
White/Black Interior Light Illumination (-) Output/Requires Optional Relay
Dark Blue Channel 2 (-) Accessory Output
White Door Trigger Input (+) or (-)
Pink Ignition Switched +12 Volt Input Pre-wired to Starter Disable Relay
Blue/White (-) Door Lock Output
Green/White (-) Door Unlock Output
Starter Dis able Re lay
Wire color De scrip tion
14 Ga Yellow Starter Disable Ignition Switch Side
14 Ga Yellow Starter Disable Starter Solenoid Side
5
2
Diablo
/AMX 68/AT-58 Installation Manual 3/31/99
Loading...