Avital AVISTART 3000 Installation Manual
AviStart 3000 Installation Manual
AviStart 3000 Installation Manual
Table of Contents
Important Information ........................... 2
Recommended Installation Tools .................... 2
Recommended Procedures ....................... 2
Main Wiring Diagram .......................... 3
12 Pin Connector............................ 4
6 Pin Connector............................. 4
Installation Procedures...........................5
Control Unit............................... 5
RangeMaster™ Super Heterodyne Receiver Module ........... 5
Wireloom ................................ 5
Valet Switch...............................6
Brake Lights (Mandatory)........................6
Parking Lights..............................6
Reverse Light..............................7
Remote Start Activated (-) Output .................... 7
Factory Alarm Disarm (-) Output..................... 7
Ignition Switch Connections....................... 7
Remote Engine Start Neutral Safety Switch Bulletin........... 9
Door Lock/Unlock ........................... 12
Door Lock Diagrams..........................12
Tach Wire (RPM Monitoring)...................... 15
Hood Switch (Mandatory) ....................... 15
Power and Ground Connections .................... 16
Mandatory RPM Programming .....................16
Programmable Features.......................... 17
Programming Table for System Features ................ 18
Programming Table for Remote Controls................ 18
AviStart 3000 Installation Manual
1
Important Information
Recommended Installation Tools
Voltmeter
Wire Strippers
Electrical Drill & Bits
Phillips Screwdriver
Convoluted Tubing *
Solder Gun *
Wire Crimpers
Shrink Tube or Electrical Tape
* Optional
Recommended Procedures
1. Test all circuits with a voltmeter.
2. Make all wiring connections with the supplied solderless crimp
connectors. DO NOT twist wires or use scotch-lok connectors.
3. Route the small and large RED, RED/WHITE and BLACK wires from the
control unit directly to the battery.
4. Keep extensions as short as possible. Use same gauge wires for short
extensions and larger gauge wires for longer extensions.
5.. DO NOT disconnect the battery cables. Make all connections by
removing the bolts from the cable clamps without detaching the clamp.
6. Turn off dome light or remove dome light fuse to prevent battery drain.
This device complies with Part 15 of the FCC rules. Any changes or modifications
made to the system without the express approval of Avital Technologies, Inc.
could void the user’s authority to operate this equipment.
2
AviStart 3000 Installation Manual
Main Wiring Diagram
AviStart 3000 Installation Manual
3
12 Pin Connector
Pin Number Wire Color Description
1 BLUE/WHITE Lock (-) Output
2 GREEN/WHITE Unlock (-) Output
3 GROUND Battery (-)
4 WHITE/GREEN Tachometer Input
5 YELLOW Brake Switch (+) Input
6 YELLOW/BLACK Reverse Light (+) Input
7 TAN Hood Switch (-) Input
8 RED/BLACK Parking Light Output
9 GRAY/BLACK Remote Start Activated (-) Output
10 GRAY/WHITE Factory Alarm Disarm (-) Output
11 RED/WHITE Parking Light Polarity Input, (+) or (-) Select
12 RED Battery (+)
6 Pin Connector
Pin Number Wire Color Description
1 PINK Ignition Output
2 RED Battery +12 Volts
3 PINK Ignition Output
4 VIOLET Starter Output
5 GRAY Heater/AC Output
6 Not Used
4
AviStart 3000 Installation Manual
Loading...