AVer FC1320-P, FC1320-PW quick guide

FC1320-P

FC1320-PW

Cube IP Camera

Quick User Guide

Table of Contents

Before Installation ................................................................................................................. 1

I. Camera Introduction .................................................................................................... 1

1. Package Contents ............................................................................................... 1

2. Hardware Installation ........................................................................................... 2

2.1 Factory Default ............................................................................................ 5

3. SD card Compatibility List.................................................................................... 6

II. Monitor Setting ............................................................................................................. 7

III. IP Assignment .............................................................................................................. 8

Finding IP Camera by using “NXU Lite recording software” ............................................ 8

Finding IP Camera by using “AVer IPCam Utility” ......................................................... 11

Using NON-DHCP Server/Router Network ................................................................... 13

IV. Connecting the IP Camera ......................................................................................... 15

COPYRIGHT ...................................................................................................................... 16

NOTICE .............................................................................................................................. 16

WARNING .......................................................................................................................... 16

Limited Warranty .............................................................................................................. 17

Governing Law and Your Rights ..................................................................................... 18

ENGLISH

Before Installation

Before installation, please be sure to read this quick installation guide and user’s manual carefully to
complete the installation.

I. Camera Introduction

The following section introduces package contents, hardware installation, factory default reset, and SD
card Compatibility List of each type camera.

1. Package Contents

Item Descriptions

1. FC1320-P or FC1320-PW

2. Bracket

3. Screw pack

4. Power Adaptor(DC 12V/0.5A) (Optional)

5. CD (User’s Manual and Quick Guide, NVR
software included)

6. Antenna (FC1320-PW model only)

**If any of the above items are missing, please contact your dealer immediately.

1

2.

Hardware Installation

1. Install with bracket
Please refer to the picture for camera installation. Use the screws to lock the bracket to the wall or
ceiling, and then connect the camera to the bracket. There’s a knob on the back of the bracket.
Loosen the knob and you can adjust the angle of camera. Tighten it to fix the angle.

For FC1320-PW wireless model, please install antenna.

2

2. Connector Instruction
The camera connectors are as below. Connect the power and the Ethernet cable with the camera,
and set it according to your network environment.

ENGLISH

3. I/O Configuration
I/O Connection

3

a. Please connect the G & DO pin to the external relay (buzzer) device

When no event happens, DO output is 5V (DO and GND are disconnected). When the camera
detects event happening and triggers external alarm, DO output is 0V (DO and GND are
connected).

b. Please connect the G & DI pin to the external trigger device.

If you select "N.O" in "Input sensor setting", when external devise or circuit makes DI and GND
pin connected, the camera input alarm is triggered, and then camera will execute the action
user has set, for example, send snapshot to E-mail address.
If you select "N.C" in "Input sensor setting", when external devise or circuit makes DI and GND
pin disconnected, the camera input alarm is triggered, and then camera will execute the action
user has set, for example, send snapshot to E-mail address.

4