AutoPage RF-303 Instruction

RF-303 TRANSMITTER PROGRAMING

H. PROGRAMMING THE REMOTE TRANSMITTERS

Recheck all connections in the installation, and reconnect the battery.
The transmitters cannot be programmed without battery voltage.
The RF-303 includes two (2), 2 button transmitters which must be
programmed to the alarm BEFORE any alarm function is possible.

NOTE: EACH TIME THE PROGRAMMING MODE IS ENTERED,
ALL PROGRAMMED TRANSMITTER CODES WILL BE
AUTOMATICALLY DELETED AND MUST BE REPROGRAMMED.
This is an important safety feature. If any transmitter is lost or stolen,
enter the programming mode and reprogram all existing transmitters.

NOTE 1: Transmitters can only be programmed by entering the
programming mode.

NOTE 2: Transmitter codes will remain in memory if power is
disconnected from the RF-303.
To program the RF-303 transmitters, follow the directions as written
below, IN THEIR EXACT ORDER! Have all transmitters readily
available.

1. Flip the VALET/OVERRIDE switch to its “ON” position.

2. Turn the ignition switch to “ON”, then “OFF”, then IMMEDIATELY
flip the VALET/OVERRIDE switch to “OFF”, “ON/OFF, “ON/OFF”.
The vehicle horn or siren will chirp one (1) time.

3. Turn the ignition switch “ON/OFF”, “ON/OFF”. The vehicle horn or
siren will chirp two (2) times. You are now in the programming mode.

4. Press ON/OFF button on one of the remote transmitters until the vehicle
horn or siren responds with a confirming chirp. The first transmitter is
now programmed.

5. WITHIN FIVE (5) SECONDS, press the ON/OFF button on the second
transmitter until the vehicle horn or siren responds with a confirming
chirp. The seconds transmitter is now programmed.

NOTE: If the RF-303 does not receive a second transmitter code to learn
within five (5) seconds, it will automatically close the programming mode
and resume to normal operation. If this happens, it will be necessary to
repeat steps 1 through 5 and reprogram ALL transmitters.

The RF-303 can learn up to four (4) transmitter codes. If later, optional,
third and forth transmitters are to be programmed, follow programming
steps 1 through 5 and reprogram ALL transmitters.

If you are coding three of four transmitters during a new installation,
continue programming transmitters three and four, as described for
transmitter two in step 5.