Auto Page C3-RS-665 User Manual

THIS PRODUCT IS DESIGNED FOR PROFESIONAL INSTALLATION ONLY

C3-RS-665

PROFESSIONAL REMOTE CAR STARTER

3 CHANNEL SECURITY SYSTEM

OPERATIONS MANUAL

Compatible

Please register your product at:

www.autopageusa.com

SYSTEM OPERATIONS:

WARNINGS:

As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of.

1. Keep the transmitter out of children’s reach.

2. Do not leave anyone in the vehicle while running on remote control.

3. Alert servicing personnel that the vehicle can be started automatically.

4. Do not start the vehicle by remote while it’s in an enclosed area or garage.

5. Always apply the parking brake and lock the vehicle as you exit the vehicle.

6. The vehicle windows must be rolled up.

7. Should the unit malfunction, disconnect the fuse until the problem is corrected.

8. The use and operations of this system is the sole responsibility of the operator.

9. Some areas may have local ordinances that prohibit leaving a vehicle running on public streets.

10. It is not safe to remote start the vehicle if the vehicle is parked on a steep

incline.

Transmitter

Button

Lock Doors & Arm System Panic function Press and Hold for 3 seconds Car Locator Under armed mode Arm and Delete The 2 Stage Shock

Sensor Silent Arming / Disarming Ignition in "off" position.

Unlock Doors & Disarm System Two Steps Door Unlock & Disarm

System Trunk Release (Channel 2) Press and Hold for 2 seconds

Passive Arming By-pass While the system Disarmed. Activate or Turn Off The Remote

Start Channel # 3 Auxiliary Output Press both buttons together Switching code For 2nd Car

Operation.

System Function Remark

Press twice within 3 seconds

Press twice within 3 seconds.

Safety start requires two pushes

For regular remote transmitter Only

CHANGING THE BATTERY IN YOUR TRANSMITTERS XT-33: This transmitter uses two (2) 3-volt lithium ion batteries (#CR2016)

that are sandwiched together with the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the top case from the bottom case. It should snap apart after breaking the seal. Before removing the batteries note the direction of the positive (+) terminal. Place the new batteries in exactly the same manner, being careful not to bend or damage the contact terminal. Snap the cases back together and then test the transmitter to insure it arms and disarms the alarm.

(2) CR2016

3-Volt Batteries

ACTIVE LOCK & ARM:

1. Press button on the transmitter.

2. The siren will chirp once and parking lights will flash once indicating that the system is now armed. The vehicle doors will lock upon arming when interfaced with the keyless entry system.

SILENT ARMING / DISARMING: Pressing the + buttons together on the transmitter will arm or disarm your system, No chirp sound will be heard, arm / disarm confirmation will be through the vehicles parking lights only.

DEFECTIVE SENSOR REMINDER: If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.

SHOCK SENSOR / OPTIONAL SENSOR BY-PASS:

Press the button once: The siren chirps once, The system is armed. Press the button a second time within 5 seconds: The siren chirps

twice, the Shock Sensor is now bypassed. The sensor bypass feature is programmed to activate for one arming cycle only. The security system will return to normal operation during the next arming cycle.

B. PASSIVE ARMING

Active arming / disarming is controlling your security system via the remote transmitter. This security system is equipped with an optional Passive Arming feature, which allows the security system to arm 30 seconds after the last door is closed. Operation is as follows:

1. Turn the ignition to the “OFF” position and exit the vehicle.

2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you re-open any door / hood / trunk, the security system LED will stop flashing. It will begin flashing again once the vehicle all entrances are closed.

After 30-second timer has elapsed, the security system will automatically “ARM”. The siren will chirp [1] time and the parking lights will flash [1] time. PASSIVE ARMING WITH PASSIVE DOOR LOCKING The vehicle doors will automatically lock after passive arming cycle has been completed. Please refer to your installing dealer to activate this feature. PASSIVE ARMING BY-PASS: While the LED is fast flashing for passive arming or Automatic re-arm, Press the buttons twice, the security will respond with [1] chirp and LED will turn “ON”. The security system will remain in this temporary state for as long as you wish.

To exit passive by -pass, press the or button and the system will return to normal status.

ACTIVE UNLOCK & DISARMING:

1. Press button on the transmitter.

2. The siren will chirp twice and parking light will flash twice to indicating that the security system is now disarmed. The vehicle doors will unlock and dome lights will turn on for 30 seconds.

TAMPER DISARMING: If the alarm was triggered in your absence, upon disarming the system, the siren will chirp 4 times, the parking lights will flash 3 times.

PATHWAY ILLUMINATION

+ 9 hidden pages