Aegis Bio 3.0
Quick Start Guide
1
2
LOCK RED LED
UNLOCK GREEN LED
3
4
4
ADMIN BLUE LED
ENROLL Button
Start 
swipe here
Swiping your Finger
To successfully swipe your finger, start your swipe by placing your fingertip on the downward facing arrow at the top of the biometric sensor. Swipe your finger in a downward motion across the sensor. If your swipe is successful the GREEN LED will start to flicker.
Basic LED States
Solid RED = Standby, swipe finger to unlock
Flashing RED = Error
Solid BLUE / Flashing GREEN = Ready to enroll fingerprint
Solid GREEN = Drive unlocked 
Flashing GREEN = Disk activity
Getting Started - Out of the Box
TIP: We highly recommend that you enroll at least three different fingers to ensure access to the drive in the case that your primary finger cannot be used.
1.Attach the integrated USB cable of the Aegis Bio to an available USB port on your computer. The Aegis
Bio LEDs will show Solid BLUE and
Flashing GREEN indicating that the drive is ready to enroll your fingerprint.
2.Swipe your Finger. The BLUE LED will turn off while theGREEN LED starts to flicker briefly as the Aegis Bio processes your fingerprint.
Wait until the BLUE LED turns back to Solid BLUE and the GREEN LED returns to its flashing state.
3.Continue to repeat Step 2 until both the BLUE and GREEN LED are
in a solid state, indicating that your fingerprint is fully enrolled.
NOTE: The number of attempts will vary depending on the quality of the fingerprint read. For most people six swipes will be sufficient.
If there is a problem with a fingerprint read, theBLUE LED will turn off and the RED LED with start to flash.
4.To enroll more fingerprints, press the ENROLL button within 15 seconds from your last successful fingerprint enrollment and repeat the process in steps 2 and 3.
NOTE: A maximum of 5 fingerprints can be stored. There is a 15 second timeout between entering fingerprints. If theENROLL button is not pressed again after the last fingerprint, the unit will assume no more fingerprints will be entered and return to a standby state.
Once 5 fingerprints have been stored, all three LEDs will turn on. After 2 seconds the GREEN and BLUE LED will turn off with just the SolidRED LED showing. At this point no more fingerprints can be enrolled.
NOTE: Once enrolled, fingerprints cannot be un-enrolled individually. To remove enrolled fingerprints, a complete re-set of the drive is required.
Loading...