Alpine RUE-4190 User Manual

RUE-4190

Universal Remote Controller

Owner's Manual

WARNING

This symbol means important instructions. Failure to heed them can result in serious injury or death.

DO NOT DISASSEMBLE OR ALTER.

Doing so may result in an accident, fire or electric shock.

KEEP SMALL OBJECTS SUCH AS BATTERIES OUT OF THE REACH OF CHILDREN.

Swallowing them may result in serious injury. If swallowed, consult a physician immediately.

DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY FROM SAFELY DRIVING YOUR VEHICLE.

Any function that requires your prolonged attention should only be performed after coming to a complete stop. Always stop the vehicle in a safe location before performing these functions. Failure to do so may result in an accident.

KEEP THE VOLUME AT A LEVEL WHERE YOU CAN STILL HEAR OUTSIDE NOISE WHILE DRIVING.

Failure to do so may result in an accident.

CAUTION

This symbol means important instructions. Failure to heed them can result in injury or material property damage.

DO NOT MIX NEW BATTERIES WITH OLD BATTERIES. INSERT WITH THE CORRECT BATTERY POLARITY.

When inserting the batteries, be sure to observe proper polarity (+ and –) as instructed. Rupture or chemical leakage from the battery may cause fire or personal injury.

Handling Precautions

Do not drop or apply shock to the unit. It may get permanently damaged.

Keep the unit away from water and moisture, direct sun and heat, and excessive dust.

Never use scouring pads, steel wool, abrasive powders or harsh chemical agents, such as lye solution, for cleaning.

Clean with a soft, lint-free cloth or cotton swab slightly dampened with a mild solution of detergent and water.

Do not operate this unit in a manner that could distract you from driving safely.

Installation of Remote Control Holder

• Do not leave the remote control mounted on the holder, if it is direct sunlight. Remove the remote control from the holder and put it in the glove compartment.

• If double-sided adhesive tape cannot install the holder securely, use screws.

Battery Replacement

Applicable battery: Use two "AAA" sized dry batteries or equivalent.

−

Opening the battery cover.

Push on the cover and slide it as indicated by the arrows then the cover will be removed.

Replacing the batteries.

Remove the old batteries. Insert new ones matching the (+) and (–) polarities as shown in the diagram inside the remote control.

In Case of Difficulty

Problem

Remote Control Inoperative.

Cause

Reverse placement of battery.

Dead battery.

Remote Control not pointed toward the head unit or monitor.

Solution

Place the battery correctly into its cradle in the compartment.

Replace the battery with a new one.

Point the remote control directly toward your head unit or monitor.

Closing the cover.

Push the cover in the arrow direction until a click is heard.

Specifications

Battery Type ....................................... AAA size batteries

Battery Quantity ............................................................. 2

Dimensions (W × H × D) .................. 56 × 142.5 × 37 mm

(2-1/4" × 5-5/8" × 1-7/16")

Weight (without battery) ............................. 72 gr (2.6 oz)

Accessories

Battery (AAA) ................................................................. 2

Remote Control Holder ............................................ 1 set

Double-Sided Adhesive Tape .................................. 1 set

Screw ............................................................................. 2

Double-Sided Adhesive Tape

(Before attaching the tape, make sure the mounting locations are free from dust or dirt)

Protective Paper

Remote Control

Reinforcing Screws

Remote Control Holder

Console Box etc.

ALPINE ELECTRONICS, INC.

Tokyo office: 1-1-8 Nishi Gotanda,

Shinagawa-ku, Tokyo 141-8501, Japan

Tel.: (03) 3494-1101

ALPINE ELECTRONICS OF AMERICA, INC.

19145 Gramercy Place, Torrance,

California 90501, U.S.A.

Tel.: 1-800-ALPINE-1 (1-800-257-4631)

ALPINE ELECTRONICS OF CANADA, INC.

7300 Warden Ave., Suite 203, Markham,

Ontario L3R 9Z6, Canada

Tel.: 1-800-ALPINE-1 (1-800-257-4631)

ALPINE ELECTRONICS OF AUSTRALIA PTY. LTD.

6-8 Fiveways Boulevarde Keysborough,

Victoria 3173, Australia

Tel.: (03) 9769-0000

ALPINE ELECTRONICS GmbH

Kreuzerkamp 7, 40878 Ratingen, Germany

Tel.: 02102-45 50

ALPINE ITALIA S.p.A.

Viale C. Colombo 8, 20090 Trezzano Sul

Naviglio (MI), Italy

Tel.: 02-48 47 81

ALPINE ELECTRONICS FRANCE S.A.R.L.

98, Rue de la Belle Etoile, Z.I. Paris Nord Il,

B.P. 50016 95945 Roissy

Charles de Gaulle Cedex, France

Tel.: 01-48 63 89 89

ALPINE ELECTRONICS OF U.K., LTD.

13 Tanners Drive, Blakelands,

Milton Keynes MK14 5BU, U.K.

Tel.: 01908-61 15 56

ALPINE ELECTRONICS DE ESPAÑA, S.A.

Portal de Gamarra 36, Pabellón 32

01013 Vitoria (Alava)-APDO 133, Spain

Tel.: 945-283588

68P20877Y88-O

Printed in China (Y)

/ : ;

< =

> ?

[

1 2 3

4 5 6 7

9 ! " # $

(

)

Map type Navigation Control Mode

When operating the navigation, set the EXT DVD/AUDIO/NAV. Switch to the “NAV.” side.

1 Remote Control Transmitter 2 — 3 — 4 — 5 — 6 — 7 MODE button 8 VOICE button 9 Zoom (Wide/Detail) button ! DISP (MP/RG) button " CANC. button # DTR button $ N/H button % Numeric Keypad & OK button ( — ) DEL. DEST. button ~ Status indicator for NAV. mode + — , —

- Power ON/OFF button

. — / — : LIGHT button for Remote Controller ; — < Joystick/ENTER button = MENU button > — ? LIST button @ DEL. button [ — \ EXT DVD/AUDIO/NAV. Switch

TV/MONI. button (Push)

Notes:

• Depending on the unit, some operations cannot be performed.

For details, see the Owner’s Manual for the unit.

• After pressing the MODE button, press the following buttons while the status

indicator is blinking: Numeric Keypad (0 to 9), DEL. button, OK button

Head Unit Control Mode

When operating the Head Unit, set the EXT DVD/AUDIO/NAV. Switch to the “AUDIO” side.

1 Remote Control Transmitter 2 Status indicator for AUDIO mode 3 — 4 BAND button 5 Radio mode: Preset Selection

Changer mode: Disc Selection MP3 mode: Folder Select Tape mode: Program Sensor

6 SOURCE button 7 — 8 — 9 Display Angle UP/DOWN button ! — " — # — $ — % — & — ( — ) — ~ — + A.PROC. button , PLAY/PAUSE button

- Power ON/OFF button

. Radio mode: SEEK UP/DOWN

CD/MD/Changer mode: Music Sensor

Tape mode: REW/FF

/ — : LIGHT button for Remote Controller ; VOLUME UP/DOWN button < — = — > MUTE button ? — @ — [ — \ EXT DVD/AUDIO/NAV. Switch

TV/MONI. button (Push)

Note: Depending on the unit, some operations cannot be performed.

For details, see the Owner’s Manual for the unit.

BW/FF (press and hold)

AV Head Unit Control Mode

When operating the AV Head Unit, set the EXT DVD/AUDIO/NAV. Switch to the “AUDIO” side.

1 Remote Control Transmitter 2 Status indicator for AUDIO mode 3 — 4 BAND button 5 Radio mode: Preset Selection

Changer mode: Disc Selection

6 SOURCE button 7 — 8 — 9 Display Angle UP/DOWN button ! — " — # — $ — % Function button (1 to 7) & — ( — ) — ~ — + A.PROC. button , Audio mode Selection (VOL./BASS/TRE/BAL/FAD)

- Power ON/OFF button . Radio mode: SEEK UP/DOWN

Changer mode: Music Sensor

/ V.SEL. button : LIGHT button for Remote Controller ; VOLUME UP/DOWN, Audio Adjust button < — = — > MUTE button ? — @ — [ — \ EXT DVD/AUDIO/NAV. Switch

TV/MONI. button (Push)

Note: Depending on the unit, some operations cannot be performed.

For details, see the Owner’s Manual for the unit.

BW/FF (press and hold)

DVD Player/DVD Changer Control Mode

When operating the External DVD Player/DVD Changer, set the EXT DVD/AUDIO/NAV. Switch to the “EXT DVD” side.

1 Remote Control Transmitter 2 — 3 Status indicator for EXT DVD mode 4 — 5 DVD Changer mode: Disc Selection 6 Audio SOURCE button

(When connected with the Ai-NET Head Unit)

7 L (STOP) button 8 — 9 — ! Searching by Title/Chapter/elapsed time,

Press and hold for 2 seconds to display the DVD menu/Title menu

" RTN (Return) button # — $ — % Numeric Keypad & — ( ANGLE button ) SUB T. (Subtitle) button

Press and hold this for 2 seconds to turn the subtitles ON and OFF

~ — + A.PROC. button

(When connected with the Digital Audio Processor)

, Playback

Press and hold for 2 seconds to playback the slow motion

- Power ON/OFF button . Chapters and tracks skip

Press and hold for 2 seconds to BW/FF

/ — : LIGHT button for Remote Controller ; VOLUME UP/DOWN button

(When connected with the Ai-NET Head Unit)

< Joystick/ENTER button = MENU button

Press and hold for 2 seconds to display the setup menu

> MUTE button (When connected with the Ai-NET Head Unit) ? — @ — [ AUDIO button \ EXT DVD/AUDIO/NAV. Switch

TV/MONI. button (Push)

Note: Depending on the unit, some operations cannot be performed. For details, see

the Owner’s Manual for the unit.

TV/Monitor Control Mode

When controlling the Monitor, press the EXT DVD/AUDIO/NAV. Switch to activate the TV/MONI. mode.

Check which TV Tuner or Monitor functions corresponds to which buttons on the remote control and attach the appropriate seal (supplied).

Note: Depending on the unit, some operations cannot be performed. For details, see

the Owner’s Manual for the unit.