ALPINE RUE-4135 User Manual
RUE-4135
3
Remote controller for
DVD navigation System
Owner's Manual
S
O
U
ENTER
/
i
POS.
5
8
TEL.
A.PROC.
2
F
U
N
C
O
P
/
C
0
V. SEL.
R
C
E
MENU
B
A
N
D
E
IC
O
V
3
6
.
9
L
T.
. P
M
K
O
.
L
O
V
"
#
$
%
&
(
)
~
+
,
U
M
E
T
LO.PT.
RO
D
ON/OFF
RETURN
UTE
1
4
7
E
S
T
.
B
S
DEL.DEST.
-
Map type Navigation Control Mode
1 Remote Control Transmitter
2 Status indicator
3 Joystick/ENTER Button
4 MODE Button
5 MENU Button
Button
6
7 VOICE Button
8 Numerick Keypad
9 M. PT./OK Button
! DEL. DEST. Button
" Zoom (Wide) Button
# AUDIO/NAV. Button
$ Zoom (Detail) Button
% RETURN/
& LO.PT. Button
( POS. Button
) ROUTE Button
~ + TEL. Button
, DEST./BS Button
- Power ON/OFF Button
i
Button
Arrow type Navigation Control
Mode
1 Remote Control Transmitter
2 Status indicator
3 Joystick/ENTER Button
4 MODE Button
5 MENU Button
6 7 VOICE Button
8 Numerick Keypad
9 M. PT./OK Button
1
2
3
4
5
6
7
8
9
!
! DEL. DEST Button
" -
R
# AUDIO/NAV. Button
$ % RETURN Button
& LO.PT. Button
( POS. Button
) ROUTE Button
~ + , DEST./BS Button
- Power ON/OFF Button
L Installation of Remote Control Holder
• If direct sunlight reaches the remote control mounted on
the holder, remove the remote control from the holder and
Remote Control
Holder
put it in the glove compartment.
• If double-sided adhesive tape cannot install the holder
securely, use screws.
Note: Attach the blue protective paper side of double-sided
tape onto the console box, etc.
Double-Sided
Adhesive Tape
(Before attaching
the tape, make
sure the mounting
locations are free
from dust or dirt)
Reinforcing Screws
Remote
Control
Head Unit Control Mode
1 Remote Control Transmitter
2 Status indicator
3 Radio mode: Preset Selection ( )
CD/MD Player/Changer mode: PLAY/PAUSE (Push),
Tape mode: PLAY/PAUSE (Push)
4 MODE Button
5 SOURCE Button
6 BAND Button
7 8 -
(Display Angle Up) Button
9
! " Volume Up Button
# AUDIO/NAV. Button
$ Volume Down Button
% A.PROC. Button
& MUTE Button
( ) ~ + -
(Display Angle Down) Button
,
- Power ON/OFF Button
SEEK UP/DOWN (
Programme Sensor ( ), REW/FF ( )
)
Disc Selection ( ),
Music Sensor (
BW/FF (
Hold)
),
AV Head Unit Control Mode
1 Remote Control Transmitter
2 Status indicator
3 Radio mode: Preset Selection ( )
CD/MD Player/Changer mode:PLAY/PAUSE or Audio Mode (Push)
Tape mode: PLAY/PAUSE (Push)
4 MODE Button
5 SOURCE Button
6 BAND Button
7 8 Numerick Keypad
(Display Angle Up) Button
9
! V.SEL. Button
" Volume Up Button
# AUDIO/NAV. Button
$ Volume Down Button
% A.PROC. Button
& MUTE Button
( ) ~ FUNC. Button
+ OP./CL. (Display Open/Close) Button
(Display Angle Down) Button
,
- Power ON/OFF Button
Notes:
• Depending on the unit, some operations cannot be performed.
For details, see the Owner’s Manual for the unit.
• After pressing the MODE button, press the following buttons
while the status indicator is blinking:
MAP type navigation: Numerick Keypad (0 to 9), BS button, OK button
Arrow type navigation: Numerick Keypad (0 to 9), BS button, OK button
Head Unit: (Display Angle Up) Button,
AV Head Unit: OP./CL. Button,
SEEK UP/DOWN (
Programme Sensor (
(Display Angle Down) Button
(Display Angle Down) Button
)
Disc Selection ( ),
Music Sensor (
BW/FF (
), REW/FF ( )
(Display Angle Up) Button,
Hold)
),
Handling Precautions
Do not drop or apply shock to the unit. It may get permanently damaged.
Keep the unit away from water and moisture, direct sun and
heat, and excessive dust.
Never use scouring pads, steel wool, abrasive powders or
harsh chemical agents, such as lye solution, for cleaning.
Battery Replacement
Applicable battery: Use two "AAA" sized dry batteries or equivalent.
1
Opening the battery cover.
Push on the cover and slide it as
indicated by the arrows then the
cover will be removed.
In Case of Difficulty
Problem
Remote
Control
Inoperative.
ALPINE ELECTRONICS, INC.
Tokyo office: 1-1-8 Nishi Gotanda,
Shinagawa-ku, Tokyo 141-8501, Japan
ALPINE ELECTRONICS OF AMERICA, INC.
19145 Gramercy Place, Torrance,
California 90501, U.S.A.
Tel.: 1-800-ALPINE-1 (1-800-257-4631)
ALPINE ELECTRONICS OF CANADA, INC.
Suite 203, 7300 Warden Ave. Markham,
Ontario L3R 9Z6, Canada
Tel.: 1-800-ALPINE-1 (1-800-257-4631)
Cause
Reverse placement of battery.
Dead battery.
Remote Control
not pointed toward
the head unit.
Tel.: (03) 3494-1101
Place the battery correctly into
its cradle in the compartment.
Replace the battery with a new
one.
Point the remote control
directly toward your head unit.
2
Replacing the batteries.
Remove the old batteries. Insert new ones
matching the (+) and (–) polarities as shown
in the diagram inside the remote control.
Specifications
Solution
R
ALPINE ELECTRONICS OF AUSTRALIA PTY. LTD.
6-8 Fiveways Boulevarde Keysborough,
Victoria 3173, Australia
Tel.: (03) 9769-0000
ALPINE ELECTRONICS GmbH
Kreuzerkamp 7-11 40878 Ratingen,
Tel.: 02102-45 50
ALPINE ITALIA S.p.A.
Via C. Colombo 8, 20090 Trezzano Sul
Naviglio MI, Italy
Tel.: 02-48 47 81
Battery Type ................................................... AAA size batteries
Battery Quantity ......................................................................... 2
Dimensions (W × H × D) ................................. 51 × 36 × 118 mm
Weight (without battery) ......................................... 60 gr (2.1 oz)
Germany
Protective Paper
Clean with a soft, lint-free cloth or cotton swab slightly
dampened with a mild solution of detergent and water.
Do not operate this unit in a manner that could distract you
from driving safety.
Closing the cover.
Push the cover in the arrow direction
until a click is heard.
ALPINE ELECTRONICS FRANCE S.A.R.L.
(RCS PONTOISE B 338 101 280)
98, Rue De La Belle Etoile, Z.I. Paris Nord Il
Charles De Gaulle Cedex, France
ALPINE ELECTRONICS OF U.K., LTD.
Milton Keynes MK14 5BU, U.K.
ALPINE ELECTRONICS DE ESPAÑA, S.A.
Portal De Gamarra 36, Pabellón 32
01013 Vitoria (Alava)-Apdo. 133, Spain
Console Box etc.
(2 × 1-13/32" × 4-21/32")
B.P. 50016 F-95945, Roissy,
Tel.: 01-48 63 89 89
13 Tanners Drive, Blakelands,
Tel.: 01908-61 15 56
Tel.: 34-45-283588
68P20877Y65-O
Printed in China (Y)
Loading...