Alpine KTC-222TN, KTC-222GY Installation Manual

KKTTTT

KK

KKTTTT

KK

CCCC----222222222222GG
CCCC----222222222222TTTTNN

GG

YYYY 55550000----0000333388888888AAAA----0000000022

NN 55550000----0000333388888888

FORD EXCURSION

Overhead Console for use with Mobile Overhead Monitor

22

AAAA----0000111144

INSTALLATION MANUAL

44

These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care of
product during installation, may be required. Before beginning this installation, carefully read through
the following instructions. Use extreme care when cutting headliner material. Check for wiring
or other componentry above headliner material. Cut only where indicated.

Materials / Tools required for this installation:

1. Phillips screwdriver 2. Powered screwdriver or drill with adapter

3. Awl or scribe point tool or similar 4. Razor knife or similar tool

5. 18 GA wire 4' 6. 1/8" Drill Bit

7. Rubbing alcohol 8. ALPINE TMX-R680A Mobile Overhead Monitor

Dec. 31,2000

INSTALLATION INSTRUCTION # 44-0088A

Printed in the U.S.A.

MATERIALS PROVIDED FOR
INSTALLATION:

ITEM Description QTY 1

1
2
3
4
5
6
7
8

9
10
11
12

SCREW, # 6 x 3/8" PPH
SCREW, #8 X 9/16" PWH
SCREW, #8 X 1" PWH
SCREW, 8-32 X 1 1/2" PPH
CONVOLUTED TUBE, 1/2" I.D. X 3"
VELCRO TAPE, 1" X 6"
TEMPLATE
REAR MOUNTING BRACKET
FRONT MOUNTING BRACKET
A/C BLOCK-OFF COVER
CONSOLE
SWITCH, SPDT

7
3 2
1
4
1 3
1
1
1 4
1
1
1

INSTALLATION INSTRUCTION # 44-0088A

Dec. 31, 2000
Printed in the U.S.A.

2

1. Remove and retain rear A/C control assembly.

housing is secured with (2) two spring clips on front of
housing. Pull down to disengage, then slide forward to
clear bracket. See Photo 1. Disconnect wiring and set
assembly in a safe place for re-use later.

PHOTO 1

headliner
by rotating outer ring on louver 90 degrees then pulling
downward.

2. Remove and discard center and rear A/C vent in

I. REMOVAL OF O.E.M.

EQUIPMENT .

Assembly

II. PREPARATION OF VEHICLE

INTERIOR .

3. Using a razor knife, carefully trim headliner as shown,
this will allow clearance for mounting bracket and A/C
block off cover. See Photo 2. Locate template (item 7
pg2) between dome lights and rear edge of O.E. console.
Make sure that arrow is pointing forward. Carefully cut and remove indicated headliner. See Photo2.

PHOTO 2

3