Alpine KTC-111TN, KTC-111GY Installation Manual
KKTTTT
KK
KKTTTT
KK
CCCC----111111111111GG
CCCC----111111111111TTTTNN
Overhead Console for use with Mobile Overhead Monitor
GG
YYYY 55550000----0000333388889999AAAA----0000000022
NN 55550000----0000333388889999
UNIVERSAL
22
AAAA----0000111144
INSTALLATION MANUAL
44
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care of
product during installation, may be required. Before beginning this installation, carefully read
through the following instructions. Use extreme care when cutting headliner material. Check
for wiring or other componentry above headliner material. Cut only where indicated.
Materials / Tools required for this installation:
1. Phillips screwdriver 2. Powered screwdriver or drill with adapter
3. Awl or scribe point tool or similar 4. Razor knife or similar tool
5. 18 GA wire 9' 6. 1/4" Hex Socket Bit
7. ALPINE TMX-R680A Mobile Overhead Monitor
INSTALLATION INSTRUCTION # 44-0089A
Jan. 5, 2001
Printed in the U.S.A.
MATERIALS PROVIDED FOR
INSTALLATION:
ITEM Description QTY
1
2
3
4
5
6
7
8
9
10
11
12
13
SCREW, 8-32 X 3/8" PPH
SCREW, #10 X 3/4" HWH
SCREW, 8-32 X 1 1/2" PPH
SPLIT LOCK WASHER, # 8
PUSH ON RETAINER
FENDER WASHER
NUT, 8-32, KEPS
SCREW, 8-32 X 3 1/2" PPH
PLASTIC SPACER, 1/4" X 1/2" X 3"
MOUNTING BRACKET ASSEMBLY
CONSOLE, VINYL COVERED
CONSOLE, PLASTIC ONLY
SWITCH, SPDT
4 2
4
4 3
4
4 4
4
4 5
4
4
1 6
1
1
1
1
7
INSTALLATION INSTRUCTION # 44-0089A
Jan. 5, 2001
Printed in the U.S.A.
2
See Photo 1.
"
3. Release LCD monitor panel from locked position.
Lower to viewing position.
4. Determine a suitable mounting location by raising
console into approximate position and checking the
viewing angle from the rear seat, contours in headliner,
and that THE MONITOR CAN NOT BE VIEWED
BY THE DRIVER.
5. Mark location on headliner with masking tape.
I. PREPARATION OF VEHICLE
INTERIOR .
1. Determine which console is to be used, the low profile
vinyl covered console (item 11 pg 2) for relatively flat
headliners or high profile plastic only console (item 12
pg 2) for contoured headliners.
2. Insert the TMX-R680A LCD monitor in the console
and secure using (4) four screws provided with monito
PHOTO 2
6. If mounting location is over the dome light, remove light and disconnect wiring.
7. Locate the vehicle’s roof brace and determine how close it is to the center of the console.
8. If the roof brace is close to center, you can use just the center bracket of the mounting bracket assembly
(item 10 pg 2). If the roof brace is in front of the console, you will need to locate a second roof brace.
The mounting bracket assembly can be adjusted to span up to 29" between braces. If a span of more than 13
is required, the headliner may need to be lowered to gain access to the rear mounting screws.
3
Loading...