6. Connect all required circuit points
Place the Alpine 8 inch unit in
dash board and x it with 2 OEM
Torx screws
7. Connect switches and place facia
plate to nish installation
• Audi A3 (8P) 07/2008 – 01/2010
(with single switch panel)
Compatible with these Alpine navigation devices
Alpine 8 inch
Installation Manual
Alpine 8 inch Kit
colour / part-no.:
black: KIT-8A3F/FD
This kit can be used for cars which were equipped
with the following factory radios:
• Chorus Gen.II+
• Concert Gen.II+
• Symphony II
• Symphony II+
• RNS-E
• RNS-low (BNS 5.0)
If the car was equipped with a 1 DIN radio like Radio Chorus II, Concert II or
Symphony II, you need to change the center console to 2 DIN.
Your Audi partner can support you.
5
3
4
5
2
Double DIN Kit contents
1
(1) Facia Plate
(2) Mounting Bracket Right
(3) Mounting Bracket Left
(4) Magnet
(5) Hexagon Socket Countersunk Flat Head Screw
Switch panel (sample)
1. Put four radio release keys in the
appropiate slots of the OEM radio
2. Remove OEM head unit by
pulling it towards your direction
3. Remove switch panel.
Remove all switches and put them
into the new facia plate
5. Remove OEM Torx screws
(see arrows)
Cut away plastic (see white lines)
to clear space for Alpine 8 inch
Facia Plate
4. Attach metal mounting
brackets to with 3 at headed
screws on each side to
the Alpine 8 inch unit
Loading...