Avaya 1151C2 User Manual
1.26 Mb

1151C1/1151C2 Power Supply

Installation and Safety Instructions


The most careful attention has been devoted to quality standards in the manufacture of your new power supply. Safety is a major factor in the design of every Avaya Product. But, safety is YOUR responsibility too. Please read carefully the helpful tips listed below. These suggestions will enable you to take full advantage of this product. Then, retain these tips for later use.


This product is NOT for residential use. It is for business systems applications ONLY.


When using your power supply, the following safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons.

Read and understand all instructions.

Follow all warnings and instructions marked on the product and contained in its packaging.

The 1151C1/C2 Power Supplies are for use only with specified Avaya equipment as outlined in the attached materials or available on http://www.avaya.com/support. No other use of the 1151C1/C2 Power supplies is recommended or warranted

The equipment must not be connected to TNV-3(standard analog phone lines) orTNV-2circuits.

For Australia, the equipment must not be connected to any TNV circuit.

The equipment must not be installed in proximity to standard phone lines.

This device can be hazardous if immersed in water. Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool. To avoid the possibility of electric shock, do not use it while you are wet. If you accidentally drop the power supply into water, do not retrieve it until you have first unplugged the line cord from the modular wall jack, unplugged the power cord from the AC wall receptacle (or other AC power source), and unplugged the output cable from any device powered by the supply. Then, call service personnel to ask about a replacement.

This product should be operated only from the type of AC power indicated on the product label. If you are unsure of the type of AC power being provided, contact a qualified service person.

Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused, such as by persons walking on it.

Allow adequate ventilation for the product. Do not cover or install in a confined space that may prevent cooling and allow excessive heat build-up.

To reduce the risk of electric shock, do not disassemble this product. There are no user serviceable parts. Opening or removing covers may expose you to hazardous voltages. Incorrect reassembly can cause electric shock when the product is subsequently used.

The Avaya model 1151C2 power supply contains a non-spillablesealedlead-acidbattery. Reasonable care should be taken to avoid puncturing, or otherwise compromising the integrity of the battery housing. Recycle the battery properly.



16-600743Issue 2, February 2006


Before cleaning or removing from service, unplug the power supply from the modular wall jack, unplug the power cord from the AC wall receptacle (or other AC power source), and unplug the output cable from any device powered by the supply. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

Be sure to disconnect all cords from this product and refer servicing to qualified service personnel when these conditions exist:

If the power supply cord is damaged or frayed.

If liquid has been spilled into the product.

If the product has been exposed to rain or water.

If the product has been dropped or the housing has been damaged.

If you note a distinct change in the performance of the product.

Declaration of Conformity

To download the Declaration of Conformity (DoC) for this equipment, visit http://www.avaya.com/support


When you see this warning symbol on the product, refer to this instructions booklet for more information before

! proceeding.