Avanti AR1754B User Manual

540.49 Kb



Model Numbers/ Nos. de Modelos RM1760W / RM1761B / RM1762PS / RM1763SS AR1754B




RM1760W / RM1761B


RM1762PS / RM1763SS



La sección en español empieza en la página 15.

Avanti has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice.

Avanti Products LLC

P.O. Box 520604 - Miami, Florida 33152




Table of Contents


Refrigerator Safety


Important Safeguides


Help Us Help You


Parts and Features


Important Safety Instructions


Installation Instructions


Before Using Your Refrigerator


Installation of Your Refrigerator


Electrical Connection


Operating Your Appliance


Temperature Control


The Chiller Compartment


Care and Maintenance


Reversing the Door of Your Refrigerator


Defrosting Your Unit


Cleaning Your Appliance


Power Failure / Vacation Time


Moving Your Refrigerator


Energy Saving Tips


Troubleshooting Guide


Service for Your Appliance


Wiring Diagram


Your Avanti Products Warranty


Instrucciones en Español

15 - 16

Registration Information and Registration Card






Your safety and the safety of others are very important.

We have provided many important safety messages in this manual for your appliance. Always read and obey all safety messages.

This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words ” DANGER”, “WARNING” or “CAUTION”.

Danger means that failure to heed this safety statement may result in severe personal injury or death.

Warning means that failure to heed this safety statement may result in extensive product damage, serious personal injury, or death.

Caution means that failure to heed this safety statement may result in minor or moderate personal injury, property or equipment damage.

All safety messages will alert to know what potential hazard is, tell you how to reduce the chance of injury, and let you know what can happen if the instructions are not followed.



Before the refrigerator is used, it must be properly positioned and installed as described in this manual so read the manual carefully. To reduce the risk of fire, electrical shock or injury when using the refrigerator, follow basic precaution, including the following:

Plug into a grounded 3-prongoutlet, do not remove grounding prong, do not use an adapter, and do not use an extension cord.

It is recommended that a separate circuit, serving only your refrigerator be provided. Use receptacles that cannot be turned off by a switch or pull chain.

Never clean refrigerator parts with flammable fluids. These fumes can create a fire hazard or explosion. And do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.

Before proceeding with cleaning and maintenance operations, make sure the power line of the unit is disconnected.

Do not connect or disconnect the electric plug when your hands are wet.

Unplug the refrigerator or disconnect power before cleaning or servicing. Failure to do so can result in electrical shock or death.

Do not attempt to repair or replace any part of your refrigerator unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician.


Use two or more people to move and install refrigerator. Failure to do so can result in back or other injury.

To ensure proper ventilation for your refrigerator, the front of the unit must be completely unobstructed. Choose a well-ventilatedarea with temperatures above 60°F (16°C) and below 90°F (32°C). This unit must be installed in an area protected from the element, such as wind, rain, water spray or drips.

The refrigerator should not be located next to ovens, grills or other sources of high heat.

The refrigerator must be installed with all electrical, water and drain connections in accordance with state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in accordance with the National Electrical Code and local codes and ordinances is required.

Do not kink or pinch the power supply cord of refrigerator.

The fuse (or circuit breaker) size should be 15 amperes.

It is important for the refrigerator to be leveled in order to work properly. You may need to make several adjustments to level it.

All installation must be in accordance with local plumbing code requirements.

Make certain that the pipes are not pinched or kinked or damaged during installations.

Check for leaks after connection.

Never allow children to operate, play with or crawl inside the refrigerator.

Although the unit has been tested at the factory, due to long-termtransit and storage, the first batch of cubes must be discarded.

Do not use solvent-basedcleaning agents of abrasives on the interior. These cleaners may damage or discolor the interior.

Do not use this apparatus for other than its intended purpose.



Read this guide carefully.

It is intended to help you operate and maintain your new unit properly.

Keep it handy to answer your questions.

If you don't understand something or you need more assistance, please call:

Avanti Customer Service 800-220-5570

Keep proof of original purchase date (such as your sales slip) with this guide to establish the warranty period.



Write down the model and serial numbers.

You'll find them on a plate located on the rear outside wall of the unit.

Please write these numbers here:


Date of Purchase


Model Number


Serial Number

Use these numbers in any correspondence or service calls concerning your unit.

If you received a damaged unit, immediately contact the dealer (or builder) that sold you the unit.

Save time and money. Before you call for service, check the Troubleshooting Guide. It lists causes of minor operating problems that you can correct yourself.


We're proud of our service and want you to be pleased. If for some reason you are not happy with the service you receive, here are some steps to follow for further assistance.

FIRST, contact the people who serviced your unit. Explain why you are not pleased. In most cases, this will solve the problem.

NEXT, if you are still not pleased, write all the details, including your telephone number, and send it to:

Customer Service

Avanti Products

10880 NW 30 Street

Miami, FL 33172 USA



MODELS: RM1760W / RM1761B / RM1762PS / RM1763SS

1: Temperature Control Knob

5: Leveling Legs

2: Chiller Compartment

6: Upper Hinge with Cover

3: Water Drip Tray

7: Small Door Bin

4: Refrigerator Shelf (Total 1)

8: Large Door Bin with 2-LiterBottle Storage



1: Temperature Control Knob

4: Upper Hinge with Cover

2: Refrigerator Shelves (Total 2)

5: Small Door Bin

3: Leveling Legs

6: Large Door Bin with 2-LiterBottle Storage



To reduce the risk of fire, electrical shock,

WARNING or injury when using your appliance, follow these basic precautions:

Read all instructions before using the refrigerator.

DANGER or WARNING: Risk of child entrapment.

Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous. . . even if they will “just sit in the garage a few days.”

Before you throw away your old refrigerator: Take off the doors. Leave the shelves in place so that children may not easily climb inside.

Never allow children to operate, play with, or crawl inside the refrigerator.

Never clean refrigerator parts with flammable fluids. The fumes can create a fire hazard or explosion.

Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other refrigerator. The fumes can create a fire hazard or explosion.

-Savethese instructions-


Before Using Your Unit

Remove the exterior and interior packing.

Check to be sure you have all of the following parts:

1 Water Drip Tray (Only on models RM1760W / 1761B / 1762PS / 1763SS)

1 Shelf (Only on models RM1760W / 1761B / 1762PS / 1763SS)

1 Ice Cube Tray (Only on models RM1760W / 1761B / 1762PS / 1763SS)

2 Shelves (Only on model AR1754B)

1 Instruction Manual

Before connecting the unit to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

Installing Your Unit

This appliance is designed to be free standing only, and should not be recessed or built-in.

Place your unit on a floor that is strong enough to support the unit when it is fully loaded. To level your unit, adjust the leveling legs at the bottom of the unit.

Allow 5 inches of space between the back and sides of the unit, which

allows the proper air circulation to cool the compressor and condenser.

Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.

Avoid locating the unit in moist areas.

Plug the unit into an exclusive, properly installed-groundedwall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.

After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3hours before placing food in the refrigerator compartment.




Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized Avanti Products service center.

This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prongplug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.

Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded.

This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground outlet with three-prong.Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard2-prongwall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded3-prongwall outlet.

The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury.

The appliance should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating label on the appliance. This provides the best performance and also prevent overloading house wiring circuits that could cause a fire hazard from overheated. Never unplug the appliance by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle. Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end. When moving the appliance, be careful not to damage the power cord.


Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this appliance. However, if you must use an extension cord it is absolutely necessary that it be a UL/CUL-Listed,3-wiregrounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes.


Most electrical appliances use a series of electric control boards to operate. These boards are very susceptible to power surges and could be damaged or destroyed.

If the appliance is going to be used in an area or if your city / country is prone to power surges / outages; it is suggested that you use a power surge protector for all electrical devices / appliances you use. The surge protector that you select must have a surge block high enough to protect the appliance it is connected to. If you have any questions regarding the type and size of surge protector needed contact a licensed electrician in your area.

Damages due to power surges are not considered a manufacturer covered defect and will void your product warranty.



Setting the Temperature Control

Your unit has only one control for regulating the temperature in the compartment. The temperature control is located on the upper right hand side of the compartment.

The first time you turn the unit on, set the temperature control to “6”.

The range of the temperature control is from position "OFF” to “6”. After 24 to 48 hours, adjust the temperature control to the setting that best suites your needs. The setting of “3” should be appropriate for home or office use.

To turn the appliance off, turn the temperature control to ”OFF”.


Turning the temperature control to “OFF” position stops the cooling cycle but does not shut off the power to the unit.

If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the unit will not start.

The Chiller Compartment (Only on Models RM1760W / 1761B / 1762PS / 1763SS)

This compartment is designed for production of ice cubes and short-termstorage(3-4days at most) of some commercially frozen foods.

The temperature in this compartment does not get cold enough to freeze food safely for long periods of time and works best when the food is already frozen.

Be design, this chiller compartment is not a true freezer, and may not keep ice cream frozen, or freeze items.

A colder setting may be used for these items, but other items in the refrigerator may also be affected.

The chiller door is susceptible to breaking due to excessive ice build up. This part is not covered under your warranty. Be sure to defrost when the ice reaches 1/4 inch thick.


Reversing the Door Swing of Your Appliance

This appliance has the capability of the door opening from either the left or right side. The unit is delivered to you with the door opening from the left side. Should you desire to reverse the opening direction, please call customer service for reversal instructions.

Defrosting Your Unit (Only on models RM1760W / 1761B / 1762PS / 1763SS)

Defrost the unit when the frost accumulated on the evaporator is about 5mm (1/5 inch) thick. Set the thermostat dial to “OFF” position.

Remove frozen or perishable foods from the chiller compartment and place it in a cooler to protect the food.

During the defrost cycle, the ice melts into the water drip tray.

To remove the water, either remove the water drip tray and/or place a collection container under the tray. Use a sponge or towel to pick up the melting ice off the unit floor.

Dry the water collection tray and place back under the chiller compartment. Defrosting usually takes a few hours. After defrosting, return the thermostat dial to the desired position. To defrost quickly remove all foods from the unit and leave the door open. Never use a knife or other metal instrument to scrape ice/frost from the evaporator.


Do not use boiling water because it may damage the plastic parts. In addition, never use a sharp or metallic instrument to remove frost as it may damage the cooling system and will void the warranty. We recommend using a plastic scraper.