INSTRUCTION MANUAL
MANUAL DE INSTRUCCIONES
MODEL NUMBER / NUMERO DE MODELO:
WD31EC
THERMOELECTRIC WATER DISPENSER
ENFRIADOR DE AGUA TERMOELECTRICO
BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS.
Avanti has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice.
La sección en español empieza en la página 12.
Avanti Products, A Division of the Mackle Co., Ltd.
P.O. Box 520604 - Miami, Florida 33152
www.avantiproducts.com
TABLE OF CONTENTS
HELP US HELP YOU… |
3 |
PARTS AND FEATURES |
4 |
IMPORTANT SAFETY INSTRUCTIONS |
5 |
INSTALLATION GUIDELINES |
5 |
OPERATION INSTRUCTIONS |
5 |
BEFORE USING YOUR WATER DISPENSER |
5 |
OPERATING YOUR WATER DISPENSER |
6 |
ELECTRICAL CONNECTION |
6 |
REPLACING WATER BOTTLE |
6 |
CONTROL AND DISPLAY PANEL |
7 |
WORKING MODES |
7 |
ENERGY SAVING MODE |
7 |
NORMAL MODE |
7 |
CARE AND MAINTENANCE |
8 |
TAKING DISPENSER OUT OF SERVICE |
8 |
PROBLEMS WITH YOUR WATER DISPENSER? |
9 |
TROUBLESHOOTING GUIDE |
9 |
SERVICE FOR YOUR WATER DISPENSER |
9 |
YOUR AVANTI PRODUCTS WARRANTY |
10 |
WIRING DIAGRAM |
11 |
INSTRUCCIONES EN ESPAÑOL |
12~15 |
REGISTRATION INFORMATION / REGISTRATION CARD |
17 |
2
HELP US HELP YOU …
Read this guide carefully.
It is intended to help you operate and maintain your new water dispenser properly.
Keep it handy to answer your questions.
If you don't understand something or you need more assistance, please call:
Avanti Customer Service
800-220-5570
Keep proof of original purchase date (such as your sales slip) with this guide to establish the warranty period.
Write down the model and serial numbers.
You'll find them on a label located on the back side of the unit.
Please write these numbers here:
____________________________________
Date of Purchase
____________________________________
Model Number
____________________________________
Serial Number
Use these numbers in any correspondence or service calls concerning your water dispenser.
If you received a damaged water dispenser, immediately contact the dealer (or builder) that sold you the water dispenser.
Save time and money. Before you call for service, check the Troubleshooting Guide. It lists causes of minor operating problems that you can correct yourself.
IF YOU NEED SERVICE
We're proud of our service and want you to be pleased. If for some reason you are not happy with the service you receive, here are some steps to follow for further assistance.
FIRST, contact the people who serviced your appliance. Explain why you are not pleased. In most cases, this will solve the problem.
NEXT, if you are still not pleased, write all the details, including your telephone number, and send it to:
Customer Service
Avanti Products
10880 NW 30 Street
Miami, FL 33172 USA
3
PARTS AND FEATURES
1 |
Water Intake |
11 |
Water Outlet |
2 |
Energy Saving Mode Indicator |
12 |
Storage Cabinet |
3 |
Normal Mode Indicator |
13 |
Removable Drip Tray |
4 |
Hot Water Indicator |
14 |
Leveling Legs |
5 |
Warm Water Indicator |
15 |
Cold Switch |
6 |
Cold Water Indicator |
16 |
Hot Switch |
7 |
Hot Water Button |
17 |
Cooling Fan Vent |
8 |
Program Selector Button |
18 |
Drain Hole (Cold Water) |
9 |
Cold Water Faucet (Blue) |
19 |
Drain Hole (Hot Water) |
10 |
Hot Water Faucet / Child Guard (Red) |
20 |
Power Supply Cord |
4
IMPORTANT SAFETY INSTRUCTIONS
WARNING |
To reduce the risk of fire, electrical shock, |
|
or injury when using your appliance, follow |
|
these basic precautions: |
•Read all instructions before using the water dispenser.
•Never clean parts with flammable fluids. The fumes can create a fire hazard or explosion.
•Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other water dispenser. The fumes can create a fire hazard or explosion
•Do not plug unit into receptacle until you ensure the water tank switches are off.
-Save these instructions-
INSTALLATION GUIDELINES
•Remove the exterior and interior packing.
•Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance not to perform properly.
•Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.
•This water dispenser is not recommended for outdoor use.
•Do not locate the dispenser in area where the temperature may fall below freezing (32º F).
•Keep area around dispenser free of dust and dirt.
•Keep the reserve supply of water bottles away from excessive heat and light.
OPERATION INSTRUCTIONS
Before Using Your Water Dispenser
•Check to be sure the following parts are included:
1 Instruction Manual
1 Removable Drip Tray
•The water cooler is pre-cleaned at the factory but the reservoir and water lines must be flushed with fresh water before use as follows:
o Keep the unit unplugged.
o Fill water tank with tap water full to capacity (about 20 ounces). Wait for 5 minutes until water settles.
o Proceed to drain the water from both faucets until no more water remains.
o Then, drain any water left in the tanks by opening the water drain caps located on the bottom, until it drains completely.
o Proceed to close the drain caps. Also make sure both faucets are closed.
o Place the water bottle on the water intake; allow water to stand for approximately one minute.
o Open water faucets to insure water flows from both faucets. o Plug dispenser into the electrical outlet.
5
o Turn the cold and hot water switches ON (at the rear). o Now you are ready to use your water dispenser.
IT WILL TAKE APPROXIMATELY 1 HOUR TO REACH OPTIMUM TEMPERATURE. IF YOU CONSUME ONE 8 OZ. CUP, THE RECOVERY TIME IS APPROXIMATELY 25 MINUTES OR LESS. IF YOU CONSUME 2 OR MORE 8 OZ. CUPS, RECOVERY TIME CAN TAKE UP TO 1 HOUR.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the factory, but in case a taste problem develops, place one tablespoon of baking soda and add tap water. Fill water tank again and repeat basic operations previously outlined.
OPERATING YOUR WATER DISPENSER
Electrical Connection
WARNING
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS SERVICE CENTER.
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.
This appliance requires a standard 115/120 Volts A.C. ~/ 60Hz electrical outlet with three-prong ground.
The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance.
Steps To Replace Water Bottle
zUse a clean cloth to wipe off neck of bottle.
zRemove cap (if one is present).
zCarefully lift bottle, do not place hands on the opening of the bottle while placing on the water intake opening.
zInsert the water bottle into the water intake over the reservoir opening so that it settles properly.
zWipe off any water which may have splashed on dispenser top.
6