P-870HW-I Series
802.11g Wireless VDSL2 4-port Gateway
Quick Start Guide
Version 3.50
6/2006
Edition 1
Copyright © 2006 ZyXEL Communications Corporation. All rights reserved.
P-870HW-I Series Quick Start Guide
Overview
The P-870HW-I Series (“P-870HW-I”) is a VDSL router that provides super high-speed Internet access
through a telephone line. The P-870HW-I supports high bandwidth applications such as video streaming,
movies on demand, on-line gaming, video and Voice over IP (VoIP). The P-870HW-I also has a built-in switch
that allows you to connect up to four network devices and a built-in wireless network for additional devices.
1 Hardware Connections
1 If you want to use your P-870HW-I and your telephone together on the same telephone jack or wall
outlet,
• Use a telephone wire to connect the P-870HW-I DSL port to the splitter DSL (or MODEM) port.
• Use a telephone wire to connect the splitter LINE port to the telephone jack or wall outlet.
• Use a telephone wire to connect the splitter PHONE port to your telephone. (Optional.)
Otherwise, use a telephone wire to connect the P-870HW-I DSL port to the telephone jack or wall outlet.
2
P-870HW-I Series Quick Start Guide
2 Use an Ethernet cable to connect any P-870HW-I LAN port (1 - 4) to your computer. Use Ethernet cables
to connect other P-870HW-I LAN ports to computers too, if you have more computers.
3 Use the included power adaptor to connect the P-870HW-I POWER socket to an appropriate power
source.
4 Push in the power button. Look at the
lights on the front panel. The PWR/SYS
light blinks for a while and then stays on.
When it stays on, check the other lights.
LAN (1-4) If the corresponding LAN port is properly connected, they blink or stay on.
WLAN/OTIST It blinks or stays on.
DSL It stays on.
INTERNET It stays off, blinks, or stays on.
If the lights behave differently or if any light is red, see Troubleshooting.
2 Connection Wizard
Use a web browser on your computer to set up your P-870HW-I. See Troubleshooting if you have any
problems.
1 Launch your web browser. 2 Enter http://192.168.1.1 as the address or URL.
3 Click Login. 4 Follow the directions in this screen. If you
change the password, you have to log in again.
3