ZyXEL Communications P-660W-Tx User Manual

P-660W-Tx v2

ADSL Router over POTS/ISDN

Quick Start Guide

Version 3.40 03/2008 Edition 1

DEFAULT LOGIN

IP Address http://192.168.1.1

Password 1234

P-660W-Tx v2 Quick Start Guide

Overview

The P-660W-Tx v2 lets you:

• Set up a wireless network with IEEE 802.1b and IEEE 802.1g capability

• Set up a DSL connection to the Internet without the need for a modem

• Set up advanced router features, including a firewall and wireless security.

Internet

Follow these steps to set up a DSL connection to the Internet and a wireless network using the P-660W-Tx v2.

1 Set Up Your Hardware, page 2

2 Configure the P-660W-Tx v2 for Internet Access, page 3

3 Set Up a Wireless Network, page 9

See the User’s Guide on the included CD for details on all of the P-660W-Tx v2’s features. Insert the CD into your CD-ROM, if a screen does not pop-up, use Windows Explorer (My Computer) to go to the CD-ROM (commonly drive D) and browse for the User’s Guide.

P-660W-Tx v2 Quick Start Guide

1 Set Up Your Hardware

POWER

ON/OFF

ETHERNET

RESET

DSL

1 Antenna: Point the antenna upwards (perpendicular to the ground).

2DSL: Connect the P-660W-Tx v2 to a telephone jack using a telephone wire.

3ETHERNET: Use an Ethernet cable to connect the Ethernet port on your computer to

the Ethernet port on the P-660W-Tx v2.

4POWER: Use the included power adaptor to connect the POWER socket to an

appropriate power source (see the User’s Guide for power adaptors specifications by region).

5ON/OFF: Push the power switch to the ON position to turn on the P-660W-Tx v2.

P-660W-Tx v2 Quick Start Guide

Look at the LEDs (lights)

The DSL light blinks and then stays on when a DSL connection is detected. The ETHERNET light turns on if your computer is properly connected to the P-660W-Tx v2

using the Ethernet cable. When you connect the power, the POWER light blinks and stays on once the device is ready.

VCheck your connections if the POWER or ETHERNET light does not turn on. If

this doesn’t help, disconnect the P-660W-Tx v2 from its power source, wait for a few seconds and turn it back on.

2 Configure the P-660W-Tx v2 for Internet Access

You may configure the P-660W-Tx v2 for Internet access in one of these ways:

• Use Zero Configuration to set up your Internet connection automatically in section 2.1.

• If Zero Configuration does not detect your Internet access settings, use the Connection Wizard to configure Internet access settings in section 2.2.

2.1 Set up Internet Access with Zero Configuration

Launch your web browser and navigate to any website (for example, www.zyxel.com). The P-660W-Tx v2 automatically detects and configures your Internet connection. This may take about two minutes.

If you have a PPPoE or PPPoA connection, a screen displays prompting you to enter your Internet account information. Enter the user name, password and/or service name exactly as provided. Click Apply.

+ 7 hidden pages