P-660R-T1/T3 v2 Quick Start Guide
P-660R-T1/T3 v2
ADSL2+ Access Router
Quick Start Guide
Version 3.40
Edition 1
12/2006
0
P-660R-T1/T3 v2 Quick Start Guide
Overview
This Quick Start Guide shows you how to:
1 Connect the Hardware 2 Set Up Internet Access
1 Connect the Hardware
3
1
2
1ETHERNET: Use an Ethernet cable to connect a computer
to the ETHERNET port for Internet access.
2DSL: Use a telephone wire to connect your P-660R-T1/T3
v2’s DSL port to a telephone jack (or to a splitter, if one is
already installed).
3POWER: Use only the included power adaptor to connect
the POWER socket to an appropriate power source.
1
P-660R-T1/T3 v2 Quick Start Guide
After you’ve made the connections, push in the power button
to turn on the P-660R-T1/T3 v2. Look at the LEDs.
•The POWER LED blinks while performing system testing. It
then turns steady on if the testing is successful.
•The DSL LED blinks then turns steady on, and blinks when
there is traffic.
•The ETHERNET LED turns on if the ETHERNET port is
properly connected, and blinks when there is traffic.
V If none of the LEDs are on, unplug the device
and recheck your hardware connections.
2 Set Up Internet Access
You can configure the P-660R-T1/T3 v2 for Internet access in
any one of these ways:
A: Configuration Genie.
B: Zero Configuration.
C: Web Configurator Internet Access Wizard.
2
P-660R-T1/T3 v2 Quick Start Guide
You can also view the connection status, see:
D: View the Status Screen
" Configuration Genie and Zero configuration are
only able to configure the device automatically
for Internet access if you are using PPPoE,
PPPoA or ENET ENCAP encapsulation with a
dynamically-assigned IP address from your ISP.
If you are not using these Internet access settings, then use
the Web Configurator Internet Access Wizard to manually
configure the device.
You will need your Internet access information such as user
name and password, if provided by your ISP.
A: Configuration Genie
From the included CD, click Setup, Multimedia Auto
Provisioner (the installation and configuration assistant) and
then click Installation Tutorial. After you have viewed the
tutorial, click Configuration Genie at the end of the installation
tutorial or from Multimedia Auto Provisioner on the CD.
3
P-660R-T1/T3 v2 Quick Start Guide
B: Zero Configuration
Launch your web browser and navigate to any web site (for
example, www.zyxel.com). The P-660R-T1/T3 v2
automatically detects and configures your Internet
connection. This may take about two minutes.
If you have a PPPoE or PPPoA connection, a screen displays
prompting you to enter your Internet account information.
Enter the username, password and/or system password
exactly as provided. Click Apply.
4
Loading...