With over 2000 satisfied users of our Shadows Program for the 508, we now offer the opportunity for other 508 owners to try
the ORIGINAL 508 SHADOWS PROGRAM.
There are no conditions attached to installing our patches, we are happy for you to have other suppliers patches installed as well as the SSE patches. Should you
wish to sell your 508 later, there is no need to restore the factory patches as other program suppliers require. All we ask is that if you like our program and back up,
tell others.
When you have the patches installed, go to the next page where you will find the track and patch listings for all of the UB Hank, Casting a Shadow, Marvin Mastertrax
and Workout 1 - 6 backing track CD's
SOUNDS LIKE THE SHADOWS ECHOES PATCHES FOR ZOOM 508
© Sounds like the Shadows Echoes 1998
Instructions for the installation of the Sounds Like The Shadows Echo program for the Zoom 508
1 Connect the power supply to the 508 and then to the power outlet.
2 The display will be showing A1
3 Briefly press the EDIT button - display changes to the ECHO TYPE parameter.
4 Using the right hand + & - buttons, change the parameter to the first letter/number on the program Table below, ie: for patch A1, the display should read n6.
5 Using the LEFT FOOT SWITCH, press once to move to the 100ms parameter.
6 With the + & - buttons, change the parameter to the second number on the sheet, ie for patch A1, the display should read 4.
7 Press the LEFT FOOT SWITCH once and change the 1ms parameter.
8 With the + & - buttons, change the parameter to the third number on the Table, ie for patch A1, the display should read 99.
9 Press the LEFT FOOT SWITCH once and change the F/back parameter.
10 With the + & - buttons, change the parameter to the fourth number on the Table, ie for patch A1, the display should read 25.
11 Press the LEFT FOOT SWITCH once and change the Tone parameter.
12 With the + & - buttons, change the parameter to the fifth number on the Table, ie for patch A1, the display should read 30.
13 Press the LEFT FOOT SWITCH once and change the Mix parameter.
14 With the + & - buttons, change the parameter to the sixth number on the Table, ie for patch A1, the display should read 30.
15 Press the LEFT FOOT SWITCH once and change the Tap mode parameter.
16 With the + & - buttons, change the parameter to the seventh number on the Table, this should be the same for every patch and should read oo.
17 Press the LEFT FOOT SWITCH once and change the Hold/Tap type parameter.
18 With the + & - buttons, change the parameter to the eighth number on the Table, this should be the same for every patch and should read tp.
19 Now you have completed the settings for patch A1 you must press the STORE button TWICE to save the parameters.
Repeat the above steps for each of the 22 patches on the Table
(Note: pressing the + & - buttons together will advance the parameter in steps of 10. To decreas high numbers to low numbers, first press the - button and then while
holding this down press the + plus button. this will decrease the numbers more quickly)
For support or help contact: shadecho@shadowsland.freeserve.co.uk