Zhone Technologies 6610-A1-xxx User Manual

✓ Configuration and

management via RS-232C

✓ Update firmware image

via RS-232C

✓ TFTP download firmware

via an Ethernet
connection

✓ PPPoA

VDSL2 Bridged Modem

6610-A1-xxx

VDSL2 Bridged Modem

✓ PPPoE
✓ Bridged Ethernet over

ATM

✓ Routed IP over ATM

The Zhone 6610 IP-based VDSL2 Ethernet Bridge Modem uses
Conexant Accelity Packet CPE that fully complies ITU-T G.993.2
(VDSL2), G.993.1 (VDSL), ANSI T1-424, ETSI TS 101 270, and China
MII VDSL standards. It supports aggregated data rates up to 100Mbps.
It supports standard 10Base-T/100Base-TX Ethernet interface cards.

The Zhone 6610 seamlessly extends the high-speed Internet
connection, or the existing Ethernet network, to any room in the
building or house with a telephone jack. It provides up to 100Mbps
speed access at distance up to 3.65 km by sharing the existing phone
line with Plain Old Telephone Service (POTS). A serial connector
(RS-232) is provided for user to connect a host computer to configure
or view the link or configurations.

Technical Specifications

Power

■ 12VDC, 800mA

Interfaces

■ 1 x RJ11 - VDSL2 uplink

■ 1 x RJ45 - 10Base-T/100Base-TX Ethernet

■ 1 x RJ11 Built-in POTS filter

■ 1 x RS232 interface for management

■ 1 x ON/OFF Power Switch

VDSL2 Bridged Modem

Standards Support

■ VDSL

- ITU-T G.993.2 (VDSL2)

- ITU-T G.993.1 (VDSL1)

- ANSI T1-424

- ETSI TS 101 270

- China MII VDSL standard

- Long-reach support US0 Band

- ITU-T G.994.1 (G.hs) based hand shaking

- Support Band Plan 998/997,and China Band
Plan; Support 5 Band Plan up to 17.6MHz

- EFM (IEEE802.3ah)

- Extended US0 band up to 276kHz

■ Ethernet Interface

- IEEE 802.3/802.3u compliant

- Support 10/100Mbps operation

- Support half/full duplex operation

- Support IEEE 802.3u clause 28-auto
negotiation

- Support Flow Control

- Support Auto MDI/MDIX

Protocol Support

■ ANSI T1.413 (Full Rate ADSL)

■ ITU-T G.993.2 (VDSL2)

■ ITU-T G.993.1 (VDSL)

■ Profiles supported:

■ 8a

■ 8b

■ 8c

■ 12a

Management

■ RS-232 Interface

Regulatory Compliance

■ FCC Part 15/68

■ CE

■ RoHS Compliant

Operating Requirements

■ Temperature

■ Operating: 0C to 40C / 32F to 104F

■ Non-Operating: -25C to 70C / -13F to 158F

■ Humidity

■ Operating: 30% to 80% Relative Humidity

(Non-Condensing)

■ Non-Operating: 10% to 95% Relative Humidity

(Non-Condensing)

Ordering Information

6610-A1-200 VDSL2 BRIDGED MODEM, NA POWER

6610-A1-300 VDSL2 BRIDGED MODEM, UK POWER

6610-A1-302 VDSL2 BRIDGED MODEM, EURO POWER

2008/03/21 08:17:13