Zeon IN4504 CALIBRE 545 Operation Manual

0 (0)
Zeon IN4504 CALIBRE 545 Operation Manual

Calibre 545

Water Resistance Table

 

 

 

 

 

 

 

Functions

 

 

 

 

 

 

 

 

 

 

Hours

Automatic Movement Operation Manual

 

 

 

 

 

 

 

 

 

-

 

 

Level of

Suitable for

Can

 

Suitable for

Suitable for

Suitable

Suitable for

 

-

Minutes

Automatic watches can be used only by those who are reasonably active as the automatic

Water

Everyday

withstand

 

Swimming

Pool Size

for

high board

 

-

Seconds

Resistance

use

accidental

 

 

 

snorkelling

diving or sub-

 

 

 

splashing

 

 

 

or water

aqua diving

 

-

Day of the Week Dial

winding relies on a regular movement of the wrist. The watch must be given an initial manual

 

 

 

 

 

 

 

 

 

 

 

 

sports

 

 

-

Date Dial

wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each

 

 

 

 

 

 

 

 

 

day it will continue to function indefinitely and may be taken off the wrist for a maximum period

None

Yes

No

 

No

No

No

No

 

-

Month

 

 

 

 

 

 

 

 

 

-

Year

of 30 hours. If this period is exceeded the movement will stop and another manual wind will be

3 ATM

Yes

Yes

 

No

No

No

No

 

(30m/

 

 

 

 

 

 

 

 

-

12/24 hour - Day/Night dial

necessary. It must be remembered that when worn in bed the movement of the wrist is

 

 

 

 

 

 

 

 

100ft

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

-

Water Resistance – Check the back of the watch and refer to the Table.

insufficient to operate the automatic winding.

5 ATM

Yes

Yes

 

Yes

Yes

No

No

 

(50m/

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Time Stand Accuracy

150ft)

 

 

 

 

 

 

 

 

Important

 

10 ATM

Yes

Yes

 

Yes

Yes

Yes

No

 

 

 

 

(100m/

 

 

 

 

 

 

 

 

 

 

1)

21,600 beats per hours

300 ft)

 

 

 

 

 

 

 

 

Do not set the day & date between 06.00 PM and 06.00 AM, as this may

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

cause damage to the movement.

2)

Accuracy between -30 to +30 seconds per day worn under normal conditions.

Water resistance is not permanent. In the course of time, the gaskets of the case and

 

 

 

Butterfly Strap Adjusting Instruction

crown may become worn and reduce the water resistance of your watch. We recommend

Instructions for Month and Year Setting

the periodic checking

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Normal Crown – always make sure it is pushed fully into case

 

 

 

1) Press button A to set the correct month.

 

 

 

 

 

2) Press button C to set the correct year.

 

 

Screw down Crown – tighten screw down crown completely to screw lock position.

 

 

 

 

 

 

To maintain water –resistance crystal, crown and case must remain intact

 

 

Instructions For Setting Day and Date

 

 

 

 

 

 

 

 

 

 

 

 

 

Exposure to Salt Water

 

 

 

 

 

 

 

1) To achieve an accurate day of the week setting, press button D until a day prior

 

 

If your watch is designed for sports or working in the water and it becomes exposed to salt

 

 

 

to the day you required is achieved i.e. if today is Wednesday then set in onto

 

 

water or significant amounts of perspiration, it should be rinsed in fresh water and dried

 

 

 

 

Tuesday

 

 

thoroughly with a soft dry cloth.

 

 

 

 

 

 

 

Firstly, open the butterfly buckle and then pull out the pin. Adjust the strap to the required

 

 

 

 

 

 

2) To achieve an accurate date setting, press button B until a date prior to the date

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

you required is achieved, i.e. if today is 16th then set it onto the 15th.

length, and then push back the pin into the correct hole. Finally, close the butterfly buckle until

Important

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

it clicks into place.

Buttons must not be operated while in contact with water

 

 

 

 

 

 

Page 1

 

 

 

 

Page 2

 

 

 

 

 

Page 3

 

 

 

 

 

 

 

 

 

 

 

Instruction for Time Setting

 

 

 

Calibre 545

 

 

 

 

 

1)

Pull the crown out to First position and turn the crown anti-clockwise until the

 

 

 

 

 

 

 

 

 

 

 

 

IN4504

 

 

 

 

 

 

 

correct date and day of the week is achieved. The day and date will now be

 

 

 

 

 

 

 

 

 

 

 

corrected, now set the time but make sure the time is set onto am or pm.

 

 

 

 

 

 

 

 

 

 

 

2)Finally push the crown back to the normal position.

3)The 12/24 (AM / PM) dial indicate AM and PM.

Page 4

Page 5

Loading...