Zeon IN3201 CALIBRE 615 Operation Manual

0 (0)
Zeon IN3201 CALIBRE 615 Operation Manual

Calibre 615

Water Resistance Table

 

 

 

 

 

 

Functions

 

 

 

 

 

 

 

 

 

 

Automatic Movement Operation Manual

 

 

 

 

 

 

 

 

 

-

Hours

 

 

 

Level of

Suitable for

Can

Suitable for

Suitable for

Suitable

Suitable for

 

Automatic watches can be used only by those who are reasonably active as the automatic

 

Water

Everyday

withstand

Swimming

Pool Size

for

high board

 

-

Minutes

 

Resistance

use

accidental

 

 

snorkelling

diving or sub-

 

 

 

 

splashing

 

 

or water

aqua diving

 

-

Seconds

winding relies on a regular movement of the wrist. The watch must be given an initial manual

 

 

 

 

 

 

 

 

 

 

 

 

sports

 

 

-

Day of the Week

wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each

 

 

 

 

 

 

 

 

 

day it will continue to function indefinitely and may be taken off the wrist for a maximum period

 

None

Yes

No

No

No

No

No

 

-

Date of the Month and Month

 

 

 

 

 

 

 

 

 

-

24 Hour Dial

of 30 hours. If this period is exceeded the movement will stop and another manual wind will be

 

3 ATM

Yes

Yes

No

No

No

No

 

 

(30m/

 

 

 

 

 

 

 

-

Water Resistance – Check the back of the watch and refer to the Table.

necessary. It must be remembered that when worn in bed the movement of the wrist is

 

 

 

 

 

 

 

 

 

100ft

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

insufficient to operate the automatic winding.

 

5 ATM

Yes

Yes

Yes

Yes

No

No

 

 

 

 

 

 

(50m/

 

 

 

 

 

 

 

 

 

Time Stand Accuracy

 

150ft)

 

 

 

 

 

 

 

Instructions For Setting Day, Date and Month

 

10 ATM

Yes

Yes

Yes

Yes

Yes

No

 

 

 

 

(100m/

 

 

 

 

 

 

 

 

 

1)

21,600 beats per hours

 

300 ft)

 

 

 

 

 

 

 

1)

To achieve an accurate day of the week setting, press button B until a day prior

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

to the day you require is achieve i.e. if today is Wednesday then set in onto

2)

Accuracy between -30 to +30 seconds per day worn under normal conditions.

Water resistance is not permanent. In the course of time, the gaskets of the case and

 

 

Tuesday.

 

 

crown may become worn and reduce the water resistance of your watch. We recommend

 

Butterfly Strap Adjusting Instruction

2)

To achieve and accurate date setting pull the crown out to First position and turn

the periodic checking

 

 

 

 

 

 

 

 

 

 

 

 

 

the crown anti-clockwise until a date prior to the date you required is achieved

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Normal Crown – always make sure it is pushed fully into case

 

 

 

 

i.e. if today is the 16th then set it onto the 15th

 

 

 

 

 

3)

Press button A until you get the month required.

 

 

Screw down Crown – tighten screw down crown completely to screw lock position.

 

 

 

 

 

 

To maintain water –resistance crystal, crown and case must remain intact

 

 

If the date is set between 10:00 PM and 02:00 AM, the date will not change

 

 

 

 

correctly.

 

 

 

 

 

 

 

 

 

 

 

 

 

Exposure to Salt Water

 

 

 

 

 

 

The day and date is changed during the period from about 10:00AM to about

 

 

 

 

 

 

 

 

02:00AM.

 

 

If your watch is designed for sports or working in the water and it becomes exposed to salt

 

 

 

 

 

 

water or significant amounts of perspiration, it should be rinsed in fresh water and dried

 

 

Firstly, open the butterfly buckle and then pull out the pin. Adjust the strap to the required

thoroughly with a soft dry cloth.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

length, and then push back the pin into the correct hole. Finally, close the butterfly buckle until

Important

 

 

 

 

 

 

 

 

 

it clicks into place.

Buttons must not be operated while in contact with water

 

 

 

 

 

 

Page 1

 

 

 

 

Page 2

 

 

 

 

 

Page 3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Instructions for Time Setting

1)Pull the crown out to Second Position and turn the crown anti-clockwise until the day of the week is correct. The day and date will now be corrected, now set the time but make sure the time is set onto am or pm. Finally push the crown back to the normal position.

2)The 24 hour dial will indicate AM and PM.

Calibre 615

IN3201

Page 4

Page 5

Loading...