Zeon IN1605 CALIBRE 721 Operation Manual

0 (0)
Zeon IN1605 CALIBRE 721 Operation Manual

Calibre 721

Water Resistance Table

 

 

 

 

 

 

Functions

 

 

 

 

 

 

 

 

 

 

Automatic Movement Operation Manual

 

 

 

 

 

 

 

 

 

-

Hours

 

 

 

Level of

Suitable for

Can

Suitable for

Suitable for

Suitable

Suitable for

 

Automatic watches can be used only by those who are reasonably active as the automatic

 

Water

Everyday

withstand

Swimming

Pool Size

for

high board

 

-

Minutes

 

Resistance

use

accidental

 

 

snorkelling

diving or sub-

 

 

 

 

splashing

 

 

or water

aqua diving

 

-

Seconds Hand Dial

winding relies on a regular movement of the wrist. The watch must be given an initial manual

 

 

 

 

 

 

 

 

 

 

 

 

sports

 

 

-

Date

wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each

 

 

 

 

 

 

 

 

 

day it will continue to function indefinitely and may be taken off the wrist for a maximum period

 

None

Yes

No

No

No

No

No

 

-

Power Reserve Dial

 

 

 

 

 

 

 

 

 

-

Water Resistance – Check the back of the watch and refer to the Table.

of 30 hours. If this period is exceeded the movement will stop and another manual wind will be

 

3 ATM

Yes

Yes

No

No

No

No

 

 

(30m/

 

 

 

 

 

 

 

 

 

necessary. It must be remembered that when worn in bed the movement of the wrist is

 

 

 

 

 

 

 

 

 

 

 

100ft

 

 

 

 

 

 

 

 

 

insufficient to operate the automatic winding.

 

5 ATM

Yes

Yes

Yes

Yes

No

No

 

Instructions for Time and Date Setting

 

 

 

(50m/

 

 

 

 

 

 

 

Time Stand Accuracy

 

150ft)

 

 

 

 

 

 

 

 

 

 

10 ATM

Yes

Yes

Yes

Yes

Yes

No

 

1)

To achieve an accurate date setting, by using a point device, press button A until

 

 

 

(100m/

 

 

 

 

 

 

 

1)

21,600 beats per hours

 

300 ft)

 

 

 

 

 

 

 

 

a date prior to the date you required is achieved. i.e. if today is the 16th then set

 

 

 

 

 

 

 

 

 

 

Water resistance is not permanent. In the course of time, the gaskets of the case and

 

it onto the 15th.

2)

Accuracy between -30 to +30 seconds per day worn under normal conditions.

2)

Unscrew the crown cover and pull the crown out, and turn the crown anti-

 

 

crown may become worn and reduce the water resistance of your watch. We recommend

Butterfly Strap Adjusting Instruction

 

clockwise until the correct date is achieved. Now set the time but make sure the

the periodic checking

 

 

 

 

 

 

 

 

 

 

 

 

 

 

time is set onto AM or PM. Finally push the crown back to Normal Position.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Normal Crown – always make sure it is pushed fully into case

 

 

 

Power Reserve Dial

 

 

Screw down Crown – tighten screw down crown completely to screw lock position.

 

 

 

 

 

 

To maintain water –resistance crystal, crown and case must remain intact

 

 

This watch has a Power Reserve Indicator Dial to show amount of power remaining within the

 

 

 

 

movement. Wind the watch until the indicator hand on Power Reserve dial reaches the “40”

 

 

 

 

 

 

 

 

 

 

 

 

 

Exposure to Salt Water

 

 

 

 

 

 

position, which means that it is now in full power. If the watch is not in use and Power Reserve

 

 

 

 

 

 

 

 

Indicator hand showing “40” position the watch will continue to function until the indicator

 

 

If your watch is designed for sports or working in the water and it becomes exposed to salt

 

 

finally reaches “0”. At this stage the power indicator needs to be rewound until it reaches “40”

 

 

water or significant amounts of perspiration, it should be rinsed in fresh water and dried

 

 

position stage.

 

 

thoroughly with a soft dry cloth.

 

 

 

 

 

Firstly, open the butterfly buckle and then pull out the pin. Adjust the strap to the required

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

length, and then push back the pin into the correct hole. Finally, close the butterfly buckle until

Important

 

 

 

 

 

 

 

 

 

it clicks into place.

Buttons must not be operated while in contact with water

 

 

 

 

 

 

Page 1

 

 

 

 

Page 2

 

 

 

 

 

Page 3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Calibre 721

 

IN1604, IN1605

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 4

Page 5

Loading...