Zeon IN3204 CALIBRE 615 Operation Manual

Calibre 615

Water Resistance Table

Functions

Automatic Movement Operation Manual

-

Hours

Level of

Suitable for

Can

Suitable for

Suitable for

Suitable

Suitable for

Automatic watches can be used only by those who are reasonably active as the automatic

Water

Everyday

withstand

Swimming

Pool Size

for

high board

-

Minutes

Resistance

use

accidental

snorkelling

diving or sub-

splashing

or water

aqua diving

-

Seconds

winding relies on a regular movement of the wrist. The watch must be given an initial manual

sports

-

Day of the Week

wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each

day it will continue to function indefinitely and may be taken off the wrist for a maximum period

None

Yes

No

No

No

No

No

-

Date of the Month and Month

-

24 Hour Dial

of 30 hours. If this period is exceeded the movement will stop and another manual wind will be

3 ATM

Yes

Yes

No

No

No

No

(30m/

-

Water Resistance – Check the back of the watch and refer to the Table.

necessary. It must be remembered that when worn in bed the movement of the wrist is

100ft

insufficient to operate the automatic winding.

5 ATM

Yes

Yes

Yes

Yes

No

No

Important

(50m/

Time Stand Accuracy

150ft)

10 ATM

Yes

Yes

Yes

Yes

Yes

No

Do not set the day & date between 06.00 PM and 06.00 AM, as this may

(100m/

1)

21,600 beats per hours

300 ft)

cause damage to the movement.

2)

Accuracy between -30 to +30 seconds per day worn under normal conditions.

Water resistance is not permanent. In the course of time, the gaskets of the case and

Instructions For Setting Day, Date and Month

crown may become worn and reduce the water resistance of your watch. We recommend

Butterfly Strap Adjusting Instruction

the periodic checking

1)

To achieve an accurate day of the week setting, unscrew and press button A

Normal Crown – always make sure it is pushed fully into case

until a day prior to the day you require is achieve i.e. if today is Wednesday then

set in onto Tuesday.

Screw down Crown – tighten screw down crown completely to screw lock position.

2)

To achieve and accurate date setting pull the crown out to First position and turn

To maintain water –resistance crystal, crown and case must remain intact

the crown anti-clockwise until a date prior to the date you required is achieved

i.e. if today is the 16th then set it onto the 15th

Exposure to Salt Water

3)

Push the crown back to Normal Position.

4)

Unscrew and press button B until you get the month required.

If your watch is designed for sports or working in the water and it becomes exposed to salt

water or significant amounts of perspiration, it should be rinsed in fresh water and dried

Firstly, open the butterfly buckle and then pull out the pin. Adjust the strap to the required

thoroughly with a soft dry cloth.

length, and then push back the pin into the correct hole. Finally, close the butterfly buckle until

Important

it clicks into place.

Buttons must not be operated while in contact with water

Page 1

Page 2

Page 3

Instructions for Time Setting

Calibre 615

1)

Pull the crown out to Second Position and turn the crown anti-clockwise until the

IN2806

day of the week is correct. The day and date will now be corrected, now set the

time but make sure the time is set onto am or pm. Finally push the crown back to

the normal position.

2)

The 24 hour dial will indicate AM and PM.

Page 4

Page 5