Zebra Technologies FX7400 User Manual

72-125267-01 Revision A — August 2009

FX7400 Series RFID Reader

Regulatory Information

© 2009 MOTOROLA, INC. All rights reserved. Motorola reserves the right to make changes to any product to improve reliability, function, or design. Motorola does not assume any product liability arising out of, or in connection with, the application or use of any

product, circuit, or application described herein. No license is granted, either expressly or by implication, estoppel, or otherwise under any patent right or patent,

covering or relating to any combination, system, apparatus, machine, material, method, or process in which Motorola products might be used. An implied license exists only for equipment, circuits, and subsystems contained in Motorola products.

Warranty

For the complete Motorola hardware product warranty statement, go to:

http://www.motorola.com/enterprisemobility/warranty.

Patents

This product is covered by one or more patents. For patent information go to:

http://www.motorola.com/enterprisemobility/patents.

Motorola, Inc. One Motorola Plaza Holtsville, New York 11742, USA 1-800-927-9626

http://www.motorola.com/enterprisemobility

MOTOROLA and the Stylized M Logo and Symbol and the Symbol logo are registered in the U.S. Patent and Trademark Office. All other product or service names are the property of their respective owners. © Motorola, Inc. 2009

Regulatory Information

This provides information for the Motorola, FX series RFID Reader products, Regulatory Model No: FX7400.

All Motorola devices are designed to be compliant with rules and regulations in locations they are sold and will be labeled as required. Regulatory information is available from:

http://www.motorola.com/enterprisemobility/support

Motorola devices must be professionally installed. The Radio Frequency Output Power will not exceed the maximum allowable limit for the country of operation. Any changes or modifications to Motorola equipment, not expressly approved by Motorola, could void the authority to operate the equipment.

Antennas: Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications, or attachments could cause damage and may violate regulations.

Regulatory Certification

The device is compliant with the following values and antenna characteristics:

FX Series Products FX Series (US) FX Series (EU)

Max Conducted RF Power Allowed + 30dBm +29.2dBm Max Antenna Gain Allowed (including cable loss) + 6dBiL +6dBiL Max Radiated Power Allowed 4W EIRP 2W ERP Max Antenna Horizontal Beamwidth (3dB) Allowed N/A Per EN 302 208

Antennas

When using antennas not supplied by Motorola, the antennas must comply with all of the appropriate specifications and criteria listed in the Regulatory Certification table.

Country Approvals

Regulatory markings are applied to the device signifying the radio(s) are approved for use in the following countries: United States, Canada and Europe. Local language translations are available at:

http://www.motorola.com/enterprisemobility/support

Please refer to the Motorola Declaration of Conformity (DoC) for details of other country markings. This is available at: http://www2.symbol.com/doc.

Brasil: Declarações Regulamentares para FX7400 - Brasil

Nota: A marca de certificação se aplica ao Transceptor, modelo FX7400. Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário.

Para maiores informações sobre ANATEL consulte o site: www.anatel.gov.br

CHILE:Este equipo cumple con la Resolución No 403 de 2008, de la Subsecretaria de telecomunicaciones, relativa a radiaciones electromagnéticas.

Korea Warning Statement for Class B ITE

기 종 별

B급 기기

( 가정용 방송통신기기 )

이 기기는 가정용 (B 급 ) 으로 전자파적합등록을 한 기기로서 주로 가정에서 사용하는 것을 목적 으로 하며 , 모든 지역에서 사용할 수 있습니다 .

Tai wa n.

Operation of the device without regulatory approval is illegal.

사 용 자 안 내 문

Health and Safety Recommendations

Warning for Use of Wireless Devices

Please observe all warning notices with regard to the usage of wireless devices.

Potentially Hazardous Atmospheres

You are reminded of the need to observe restrictions on the use of radio devices in fuel depots, chemical plants etc. and areas where the air contains chemicals or particles (such as grain, dust, or metal powders).

Safety in Hospitals

Wireless devices transmit radio frequency energy and may affect medical electrical

adjacent equipment is not adversely affected.

Use With Hearing Aids

When some wireless devices are used near some hearing devices (hearing aids and cochlear implants), users may detect a buzzing, humming, or whining noise. Some hearing devices are more immune than others to this interference noise, and wireless devices also vary in the amount of interference they generate. In the event of interference you may want to consult your hearing aid supplier to discuss solutions.

Other Medical Devices

Please consult your physician or the manufacturer of the medical device, to determine if the operation of your wireless product may interfere with the medical device.

equipment. When installed adjacent to other equipment, it is advised to verify that the

FCC / EU RF Exposure Guidelines

Safety Information

Reducing RF Exposure - Use Properly

Only operate the device in accordance with the instructions supplied.

International

The device complies with internationally recognized standards covering human exposure to electromagnetic fields from radio devices. For information on "International" human exposure to eletromagnic fields refer to the Motorola Declaration of Conformity (DoC) at http://www2.symbol.com/ doc/.

US and Canada

To comply with FCC RF exposure requirements, antennas that are mounted externally at remote locations or operating near users at stand-alone desktop of similar configurations must operate with a minimum separation distance of 24 cm from all persons.

To comply with EU RF exposure requirements, antennas that are mounted externally at remote locations or operating near users at stand-alone desktop of similar configurations must operate with a minimum separation distance of 24 cm from all persons.

Power Supply

Use only a Motorola approved power supply output rated at 24Vdc and minimum 3.25A. The power supply shall be Listed to UL/CSA 60950-1; and certified to IEC60950-1 and EN60950-1 with SELV outputs. Use of alternative power supply will invalidate any approval given to this device and may be dangerous. This device is powered from a 802.3af compliant power source which is certified by the appropriate agencies.

Battery

Caution: Risk of Explosion if Battery is replaced by an incorrect Type. Dispose of Used Batteries According to the Instructions.

Wireless Devices Country Approvals

ȠɅɅɁɇɃɄȶaa

Regulatory markings, subject to certification, are applied to the device signifying the radio is approved for use in the following countries: United States, Canada and Europe

Please refer to the Motorola Declaration of Conformity (DoC) for details of other country markings. This is available at http://www2.symbol.com/doc/.

Operation of the device without regulatory approval is illegal.

Note1: Europe includes, Austria, Belgium, Bulgaria, Czech Republic, Cyprus, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovak Republic, Slovenia, Spain, Sweden, Switzerland and the United Kingdom.

Country Selection - Worldwide Version Only

Select only the country in which you are using the device. Any other selection will make the operation of this device illegal.

Frequency of Operation - FCC

The range of channels is limited by firmware.

Radio Frequency Interference Requirements - FCC

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio

instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna

•

Increase the separation between the equipment and receiver

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

•

Consult the dealer or an experienced radio/TV technician for help

Radio Transmitters (Part 15)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Radio Frequency Interference Requirements - Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that permitted for successful communication.

This device has been designed to operate with the antennas listed below , and having a maximum gain of 6dBi. Antennas not included in this list or having a gain greater than 6dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.

frequency energy and, if not installed and used in accordance with the

Radio Transmitters

This device complies with RSS 210 of Industry & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

Label Marking: The Term “IC:” before the radio certification only signifies that Industry Canada technical specifications were met.

This device has been designed to operate with antennas having a maximum gain of 6dBi. Antennas having a gain greater than 6dBi are strictly prohibited for use with this device. The required antenna impedance is 50ohms.

Marking and European Economic Area (EEA)

RFID devices for use through the EEA have the following restrictions:

•

Maximum radiated transmit power of 2W ERP in the frequency range 865.6-867.6MHz

Statement of Compliance

Motorola/Symbol hereby, declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A Declaration of Conformity may be obtained from http://www2.symbol.com/doc/..

Waste Electrical and Electronic Equipment (WEEE)

English: For EU Customers: All products at the end of their life must be returned to Motorola for recycling. For information on how to return product, please go to: http://www.motorola.com/recycling/weee.

Bulgarish: За клиенти от ЕС: След края на полезния им живот всички продукти трябва да се връщат на Motorola за рециклиране. За информация относно връщането на продукти, моля отидете на адрес: http:// www.motorola.com/recycling/weee.

Dansk: Til kunder i EU: Alle produkter skal returneres til Motorola til recirkulering, når de er udtjent. Læs oplysningerne om returnering af produkter på: http://www.motorola.com/recycling/weee.

Deutsch: Für Kunden innerhalb der EU: Alle Produkte müssen am Ende ihrer Lebensdauer zum Recycling an Motorola zurückgesandt werden. Informationen zur Rücksendung von Produkten finden Sie unter http:// www.motorola.com/recycling/weee.

Eesti: EL klientidele: kõik tooted tuleb nende eluea lõppedes tagastada taaskasutamise eesmärgil Motorola'ile. Lisainformatsiooni saamiseks toote tagastamise kohta külastage palun aadressi: http://www.motorola.com/recycling/weee.

Español: Para clientes en la Unión Europea: todos los productos deberán entregarse a Motorola al final de su ciclo de vida para que sean reciclados. Si desea más información sobre cómo devolver un producto, visite: http:// www.motorola.com/recycling/weee.

Français : Clients de l'Union Européenne : Tous les produits en fin de cycle de vie doivent être retournés à Motorola pour recyclage. Pour de plus amples informations sur le retour de produits, consultez : http://www.motorola.com/ recycling/weee.

Italiano: per i clienti dell'UE: tutti i prodotti che sono giunti al termine del rispettivo ciclo di vita devono essere restituiti a Motorola al fine di consentirne il riciclaggio. Per informazioni sulle modalità di restituzione, visitare il seguente sito Web: http://www.motorola.com/recycling/weee.

Magyar: Az EU-ban vásárlóknak: Minden tönkrement terméket a Motorola vállalathoz kell eljuttatni újrahasznosítás céljából. A termék visszajuttatásának módjával kapcsolatos tudnivalókért látogasson el a http://www.motorola.com/ recycling/weee weboldalra.

Nederlands: Voor klanten in de EU: alle producten dienen aan het einde van hun levensduur naar Motorola te worden teruggezonden voor recycling. Raadpleeg http://www.motorola.com/recycling/weee voor meer informatie over het terugzenden van producten.

Português: Para clientes da UE: todos os produtos no fim de vida devem ser devolvidos à Motorola para reciclagem. Para obter informações sobre como devolver o produto, visite: http://www.motorola.com/recycling/weee.

Românesc: Pentru clienţii din UE: Toate produsele, la sfârşitul duratei lor de funcţionare, trebuie returnate la Motorola pentru reciclare. Pentru informaţii despre returnarea produsului, accesaţi: http://www.motorola.com/recycling/weee.

Slovenski: Za kupce v EU: vsi izdelki se morajo po poteku življenjske dobe vrniti podjetju Motorola za reciklažo. Za informacije o vraèilu izdelka obišèite: http://www.motorola.com/recycling/weee.

Suomi: Asiakkaat Euroopan unionin alueella: Kaikki tuotteet on palautettava kierrätettäväksi Motorola-yhtiöön, kun tuotetta ei enää käytetä. Lisätietoja tuotteen palauttamisesta on osoitteessa http://www.motorola.com/recycling/weee.

Svenska: För kunder inom EU: Alla produkter som uppnått sin livslängd måste returneras till Motorola för återvinning. Information om hur du returnerar produkten finns på http://www.motorola.com/recycling/weee.

Tur key : EEE Yönetmeliğine Uygundur

Service Information

If you have a problem using the equipment, contact your facility’s Technical or Systems Support. If there is a problem with the equipment, they will contact Motorola Enterprise Mobility Support at:

http://www.motorola.com/enterprisemobility/contactsupport.

For the latest version of this guide go to:

http://www.motorola.com/enterprismobility/manuals