therein are owned by ZIH Corp. and/or Zebra’s licensors. Unauthorized reproduction of this manual or the software
and/or firmware in the label printer may result in imprisonment of up to one year and fines of up to $10,000
(17
U.S.C.506). Copyright violators may be subject to civil liability.
ZebraLink and all product names and numbers are trademarks, and Zebra, the Zebra logo, ZPL, ZPL II, Element
Energy Equalizer Circuit, and E
All other brand names, product names, or trademarks belong to their respective holders. For additional trademark
information, please see “Trademarks” on the product CD.
3
Circuit are registered trademarks of ZIH Corp. All rights reserved worldwide.
Proprietary Statement This manual contains proprietary information of Zebra Technologies Corporation and its
subsidiaries (“Zebra Technologies”). It is intended solely for the information and use of parties operating and
maintaining the equipment described herein. Such proprietary information may not be used, reproduced, or disclosed
to any other parties for any other purpose without the express, written permission of Zebra Technologies Corporation.
Product Improvements Continuous improvement of products is a policy of Zebra Technologies Corporation.
All specifications and designs are subject to change without notice.
Liability Disclaimer Zebra Technologies Corporation takes steps to ensure that its published Engineering
specifications and manuals are correct; however, errors do occur. Zebra Technologies Corporation reserves the right
to correct any such errors and disclaims liability resulting therefrom.
Limitation of Liability In no event shall Zebra Technologies Corporation or anyone else involved in the creation,
production, or delivery of the accompanying product (including hard ware and software) be liab le for any damages
whatsoever (including, without limitation, consequential damages including loss of busin ess profi ts, business
interruption, or loss of business information) arising out of the use of, the results of use of, or inability to use such
product, even if Zebra Technologies Corporation has been advised of the possibility of such damages. Some
jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation
or exclusion may not apply to you.
Zebra Technologies Europe Limited
Dukes Meadow
Millboard Road
Bourne End
Buckinghamshire, SL8 5XF
United Kingdom
T: +44 (0) 1628 556000
F: +44 (0) 1628 556001
T: +44 (0) 1628 556039
F: +44 (0) 1628 556003
E: Tseurope@zebra.com
T: +44 (0) 1772 693069
F: +44 (0) 1772 693046
New requests: ukrma@zebra.com
Status updates:
repairupdate@zebra.com
T: +44 (0) 1628 556000
F: +44 (0) 1628 556001
E: Eurtraining@zebra.com
T: +44 (0) 1628 556037
F: +44 (0) 1628 556005
E: mseurope@zebra.com
T: +44 (0) 1628 556032
F: +44 (0) 1628 556001
E: cseurope@zebra.com
Asia Pacific
Zebra Technologies Asia
Pacific Pte. Ltd.
120 Robinson Road
#06-01 Parakou Building
Singapore 068913
T: + 65 6858 0722
F: +65 6885 0838
T: +65 6858 0722
F: +65 6885 0838
E: China:tschina@zebra.com
All other areas:
tsasiapacific@zebra.com
T: +65 6858 0722
F: +65 6885 0838
E: China:tschina@zebra.com
All other areas:
tsasiapacific@zebra.com
T: + 65 6858 0722
F: +65 6885 0838
E: China:tschina@zebra.com
All other areas:
tsasiapacific@zebra.com
E: China: GCmarketing@zebra.com
All other areas:
AP ACChannelmarketing@zebra.com
T: +65 6858 0722
F: +65 6885 0836
E: China: order-csr@zebra.com
All other areas:
csasiapacific@zebra.com
04/22/2009Addendum to the SEH PS105-Z & PS102-Z User Guide P1004197-002
for Zebra Printers
Preface
8
Document Conventions
Document Conventions
The following conventions are used throughout this document to convey certain information:
Alternate Color (online only) Cross-references contain links to other sections in this guide.
If you are viewing this guide online, click the blue text to jump to its location.
Command Line Examples All command line examples appear in Courier New font.
For example, type the following to get to the Post-Install scripts in the
Ztools
Files and Directories All file names and directories appear in Courier New font. For
example, the
Cautions, Important, Note, and Example
Caution • Warns you of the potential for electrostatic discharge.
Zebra<version number>.tar file and the /root directory.
bin directory:
Caution • Warns you of a potential electric shock situation.
Caution • Warns you of a situation where excessive heat could cause a burn.
Caution • Advises you that failure to take or avoid a specific action could result in physical
harm to you.
Caution • Advises you that failure to take or avoid a specific action could result in physical
harm to the hardware.
Caution • Advises you need to wear protective eye wear.
Important • Advises you of informatio n that is essential to complete a task.
Note • Indicates neutral or positive information that emphasizes or supplements important
points of the main text.
Example • Provides an example, often a scenario, to better clarify a section of text.
P1004197-002Addendum to the SEH PS105-Z & PS102-Z User Guide04/22/2009
for Zebra Printers
Preface
1
2
Document Conventions
Illustration Instructions Used when an illustration contains either information about a
dialog box or step(s) to accomplish in a dialog box.
One illustration instruction identifies a section of the dialog box and the other shows steps to
follow .
9
Set Permanent text-box.
1
a. In the Set Permanent text-box, type in the print
2
server’s IP address.
b. When you are finished, click OK.
04/22/2009Addendum to the SEH PS105-Z & PS102-Z User Guide P1004197-002
for Zebra Printers
Preface
10
Related Documents
Related Documents
The following documents might be helpful references:
• SEH Print Server PS105-Z Hardware Installatio n Gu id e
• SEH Print Server PS Series Quick Installation Guide
• SEH Print Server Installation Manual
•Installation In Mac OS 9/8 Systems
•Installation In Novell Netware
•Installation In UNIX Systems
•Installation In Windows Systems
• SEH Print Server PS Series User Manual
• ZPL II
• ZebraNet™ Bridge Enterpr ise Printer Management User Guide
• SEH PS102-Z Internal Print Server Kit for Xi4™ Printers Installation Instructions
®
Programming Guide For x.14 Firmware and Above
• SEH PS102-Z Internal Print Server Kit for S4M Printers Installation Instructions
• SEH IPv6 Print Server Quick Reference Guide
• SEH Print Server CD
P1004197-002Addendum to the SEH PS105-Z & PS102-Z User Guide04/22/2009
for Zebra Printers
1
Introduction
This chapter provides a high-level overview of the SEH IPv6 PS device, minimum
requirements, installation types, and specifications.
04/22/2009Addendum to the SEH PS105-Z & PS102-Z User Guide P1004197-002
for Zebra Printers
Introduction
ZebraLink-enabled printer,
with SEH IPv6 PS
ZebraNet Utilities
1
2
12
Overview
Overview
The SEH IPv6 Print Server (PS) is an optional factory- or field-installed device that connects
the network and your ZebraLink-enabled printer. If you use the ZebraNet Utilities, you can
easily access many of the specialized features of a ZebraLink enabled printer. For details, see
Software Tools on page 43.
Important • You can download the most recent version of ZebraNet Utilities from
http://www.zebra.com/printer_management.
Illustration
Figure 1 shows the flow of components that work with the SEH IPv6 PS. The table that
follows identifies the compon ents and how they enhance each respective device:
Figure 1 • Components
P1004197-002Addendum to the SEH PS105-Z & PS102-Z User Guide04/22/2009
for Zebra Printers
Introduction
Overview
13
1
ZebraLink-enabled printer with SEH IPv6 PS—A ZebraLink-enabled
printer with SEH IPv6 PS gives you the following features:
•Printer alerts
•Print server setup using a browser
•Remote monitoring and configuration capability of the SEH
IPv6 PS using a browser
•The ability for you to send unsolicited printer status messages via
raw TCP/IP.
The SEH IPv6 PS can be either field- or factory-installed. For details, see
Installation Types on page 16.
2
ZebraNet Utilities—ZebraNet Utilities is a suite of software programs
that work with SEH IPv6 PS and enhance the features of ZebraLink
resident within ZPL-based printers. The features include:
•ZebraNet Bridge allows you to discover and manage a print server
on a network.
•ZebraNet View allows you to locate printers automatically.
ZebraNet View searches on parameters such as IP address, subnet,
printer model, printer status, and many other user-defined
characteristics.
•ZebraNet View Java Applet is a Java-based version of the popular
ZebraNet View. It gives you ZebraNet View capabilities in a
non-Windows en viro nmen t.
04/22/2009Addendum to the SEH PS105-Z & PS102-Z User Guide P1004197-002
for Zebra Printers
Introduction
14
Requirements
Requirements
Hardware
This section lists the minimum requirements for SEH IPv6 PS, which include hardware and
firmware.
The following are the SEH IPv6 PS options available for different printer models:
Supported Firmware Versions After an SEH IPv6 PS is installed, your printer must be
running a supported firmware version to access the features in this manual. See Table 1 for the
firmware versions.
P1004197-002Addendum to the SEH PS105-Z & PS102-Z User Guide04/22/2009
for Zebra Printers
Supported Printer Models and Firmware Versions
Ta ble 1 lists the supp orted Zebra printer or print engines and their associated firmware
versions when using an SEH IPv6 print servers.
Table 1 • Supported Printer Models and Firmware Versions
Introduction
Compatibility
15
Printer
Firmware
Version
105SLV60.16.5Z or later
110PAX4,
V60.16.5Z or later
170PAX4
R110Xi,
R60.16.5Z or later
R170Xi
RZ400,
R53.16.5Z or later
RZ600
S4MV53.16.5Z or later
XiIIIPlusV60.16.5Z or later
Xi4V53.17.x or later
Z4Mplus,
V60.16.5Z or later
Z6Mplus
ZM400,
V53.16.5Z or later
ZM600
Compatibility
This section identifies the various components that are compatible with SEH IPv6 PS.
• ZebraNet Wireless Print Server
• ZebraNet Wireless Plus Print Server
• ZebraNet Internal Wireless Plus Print Server
04/22/2009Addendum to the SEH PS105-Z & PS102-Z User Guide P1004197-002
for Zebra Printers
Introduction
16
Installation Types
Installation Types
SEH IPv6 PS can be factory- or field-installed, as follows:
Factory Factory installations are for new Zebra printers that are built with the internal SEH
IPv6 PS (PS102-Z) option.
Field Field installations are for Zebra printers already in the field that do not have the SEH
IPv6 PS device installed. The SEH IPv6 PS option can be installed on existing printers, as
follows:
•External SEH IPv6 PS (PS105-Z) — attaches to the printer parallel port
Internal SEH IPv6 PS(PS102-Z) — for the appropriate Zebra printers, this option
•
connects directly to the main logic board
Caution • A qualified service technician must perform this installation.
P1004197-002Addendum to the SEH PS105-Z & PS102-Z User Guide04/22/2009