Fixed RFID Tunnel
Installation Guide
MN-004421-01EN
Copyright
© 2022 ZIH Corp. and/or its aliates. All rights reserved. ZEBRA and the stylized Zebra head are
trademarks of ZIH Corp., registered in many jurisdictions worldwide. All other trademarks are the property of
their respective owners.
COPYRIGHTS & TRADEMARKS: For complete copyright and trademark information, go to: www.zebra.
com/copyright
WARRANTY: For complete warranty information, go to: www.zebra.com/warranty
END USER LICENSE AGREEMENT: For complete EULA information, go to: www.zebra.com/eula
Terms of Use
Proprietary Statement This manual contains proprietary information of Zebra Technologies Corporation
and its subsidiaries (“Zebra Technologies”). It is intended solely for the information and use of parties
operating and maintaining the equipment described herein. Such proprietary information may not be used,
reproduced, or disclosed to any other parties for any other purpose without the express, written permission
of Zebra Technologies.
Product Improvements Continuous improvement of products is a policy of Zebra Technologies. All
specications and designs are subject to change without notice.
Liability Disclaimer Zebra Technologies takes steps to ensure that its published Engineering specications
and manuals are correct; however, errors do occur. Zebra Technologies reserves the right to correct any
such errors and disclaims liability resulting therefrom.
Limitation of Liability In no event shall Zebra Technologies or anyone else involved in the creation,
production, or delivery of the accompanying product (including hardware and software) be liable for any
damages whatsoever (including, without limitation, consequential damages including loss of business
prots, business interruption, or loss of business information) arising out of the use of, the results of use
of, or inability to use such product, even if Zebra Technologies has been advised of the possibility of such
damages. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you.
Contents
Introduction .......................................................................................................................................... 1
Included Hardware ........................................................................................................................................................... 1
Typical Tool Requirements ............................................................................................................................................... 1
Installation ............................................................................................................................................ 2
Feet .................................................................................................................................................................................. 2
Connecting the A-Panel Cables .......................................................................................................................................3
Connecting the Internal Panel Cables .............................................................................................................................3
Panel Assembly ...............................................................................................................................................................4
Mounting ..........................................................................................................................................................................6
Connecting Power ............................................................................................................................................................ 6
Cleanup ................................................................................................................................................ 7
iii
Introduction
Built especially for inline conveyor operations, these units automatically read tagged assets as they
move along the line and through the tunnel, improving workow accuracy. Specialized antennas
provide superior performance optimized for accurate, reliable reads of conveyor-based throughput.
This document describes how to perform a typical installation of the Zebra Tunnel RFID Portal.
Included Hardware
y A-Panel with control box and one antenna
y B-panel with one antenna
y C-panel with 2 antennas
y L-brackets
y Feet
y 40 @ 1/4-20 x 2-inch screws (panel feet assembly, panel to panel assembly)
y 3/8-inch x 3-inch Screw Anchor (oor mounting)
Typical Tool Requirements
y Box Cutter
y Snips
y Tape Measure
y Speed Square
y Hammer Drill
3/8-inch Concrete Drill Bit
y Impact Driver
3/8-inch Socket
y Extension Cord(s)
y Vacuum or Broom
1
Loading...