S10/S20
规章指南
法规信息
监管标记
本设备是获得 Zebra Technologies Corporation 认可的产品。
本指南适用于以下型号：
• S10
• S20
所有 Zebra 设备的设计均严格遵守各个销售地点所制定的法律和规章，并按照要求标示。
Local language translation / Tradução do idioma local / Übersetzung in die lokale Sprache / Raduccion de
idioma local / Traduction en langue locale / Prijevod na lokalni jezik / Traduzione in lingua locale / 現地語の
翻訳 / 현지 언어 번역 / Перевод на местный язык / 本地語言翻譯 / 本地语言翻译 / Yerel dile çeviri
/Tłumaczenie na język lokalny: zebra.com/support
未经 Zebra 明确批准而擅自对 Zebra 设备作出更改或修改，将有可能令用户操作设备的权利失效。
声称的最高工作温度：45°C。
监管标记 （以认证为准）适用于设备，表示获准使用无线电。要详细了解其他国家 / 地区的标记，请参阅
符合声明 (DoC)。可从以下网址查看符合声明：zebra.com/doc 。
健康和安全建议
人体工程学建议
为了避免人体工程学方面的潜在伤害风险或将此类风险减至最低，务必遵循良好的人体工程学工作场所实
践。请咨询机构内部的健康与安全经理，确保您参加公司为预防员工发生意外伤害而设立的安全计划。
LED 设备
按照 IEC 62471:2006 和 EN 62471:2008 的规定，属于 “ 豁免风险组 ”。
白色的 脉冲持续时间：1.5 ms 或 CW 豁免风险组
紅色的脉冲持续时间：1.5 ms 或 CW 豁免风险组
重量和度量等级认证
电源
本设备可由外部电源供电或以太网供电 (PoE) 802.3af 或 802.3at 电源供电。确保遵循适用的说明。
触电警告：只能使用 Zebra 认可的、具有适当电气额定值的 ITE 认证 SELV 电源。使用其他电源将使对此
设备的任何授权作废，并且可能带来危害。
本设备必须使用满足当地法规要求且符合 802.3af 或 802.3at 标准的电源供电。
ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corp., registered in many jurisdictions
worldwide. All other trademarks are the property of their respective owners. © 2020 Zebra Technologies Corp. and/or
its affiliates. All rights reserved. | www.zebra.com
MN-004023-01ZHCN 版本 A
S10/S20 规章指南
连接至 LAN 网络
请注意，本设备未经测试或授权可在室外条件下通过以太网电缆连接到局域网 (LAN)。它只能连接到室内
LAN。
标记和欧洲经济区 (EEA)
符合声明
Zebra 特此声明，本设备符合 2014/30/EU、2014/35/EU 和 2011/65/EU 指令要求。
欧盟符合声明的全文见：zebra.com/doc 。
废弃电子电气设备指令 (WEEE)
对于欧盟客户：对于已报废的产品，请参阅以下网址的回收 / 处置建议：zebra.com/weee 。
United States and Canada Regulatory
Radio Frequency Interference Notices
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radio Frequency Interference Requirements – Canada
Innovation, Science and Economic Development Canada ICES-003 Compliance Label: CAN ICES-3
(B)/NMB-3(B)
Brasil
中国
Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar
interferência em sistemas devidamente autorizados.
通过访问以下网址可下载当地语言支持的产品说明书 zebra.com/support
2
Loading...