ET80/ET85 Soft
1
2
3
Handle/Shoulder Strap/Boot
Installation Guide
IMPORTANT: To install the soft handle or shoulder
strap, the ET80/ET85 boot is required. The boot, soft
handle, and shoulder strap are each sold separately.
Boot
Soft handle with
coiled tether
2. Feed the pointed end out of slot two.
3. Feed the end into slot three.
Shoulder strap
with loops
When attaching a shoulder strap, first attach the loops to the
boot.
Attaching the Soft Handle or Shoulder Strap Loops
The following steps apply to attaching the soft handle and the
shoulder strap loops.
If the boot is installed on the tablet, push the top left corner of
the boot off the tablet, then remove the tablet from the boot.
1. Hold the boot upside down and pull the pointed end of the
soft handle or shoulder strap loop into slot one.
MN-004222-01EN Rev A
4. Pull the pointed end all the way out of slot one.
5. Repeat steps 1-4 for the other end of the soft handle or
the other shoulder strap loop.
The straps are tightly secured into place after the boot is
installed on the tablet.
ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corp.,
registered in many jurisdictions worldwide. All other trademarks are the property of
their respective owners. © 2021 Zebra Technologies Corp. and/or its affiliates. All
rights reserved. | zebra.com
Attaching the Shoulder Strap to the Soft Handle
Use the soft handle alone, or attach a shoulder strap to the
soft handle.
1. First attach the soft handle to the boot.
2. Clip both ends of the shoulder strap to the loops on the
soft handle.
Installing the Boot
1. Insert the bottom of the tablet into the bottom of the boot.
2. Push the top of the tablet into the top of the boot.
Attaching the Shoulder Strap to the Boot
1. First attach the shoulder strap loops to the boot.
2. Clip both ends of the should strap to the shoulder strap
loops.
Removing the Boot
Push the top left corner of the boot off the tablet, then remove
the tablet from the boot.
2
Loading...