ET80/ET85 Power/Vehicle/Office Dock
1
23
Quick Start Guide
Cable Routing
Use the indicated cable tie slots for cable routing to prevent
interference from the keyboard handle.
Port expander
1
DC IN 12-14 VDC
2
Cable tie slots
3
Use only with ET80 and ET85.
Power Only Dock
CRD-ET8X-PWRDK1-01
Vehicle Dock
CRD-ET8X-VEHDK1-01
Office Dock
CRD-ET8X-OFFDK1-01
Provides tablet charging only.
Includes four 10-32 nuts, four screws,
four washers, and two keys.
Supports VESA 100 mm x 100 mm,
100 mm x 50 mm, and 75 mm x 75 mm.
Mount not included.
Provides tablet charging, USB
communication, and Ethernet
communication.
Includes four 10-32 nuts, four screws,
four washers, and two keys.
Supports VESA 100 mm x 100 mm,
100 mm x 50 mm, and 75 mm x 75 mm.
Mount not included.
Provides tablet charging, USB
communication, Ethernet
communication, and HDMI ports.
Includes two keys and stand.
Wall Mounting
Mount the ET80/ET85 Power Only or Vehicle docks on a wall
as shown using the following materials (not included with dock).
• Rear standoffs – 6 mm (1/4 in.) minimum thickness. This
allows the locking lever to fully open.
• Front washers – 15 mm (5/8 in.) minimum outside diameter.
• Screws - #8 x 3 in. Phillips pan head wood screws.
• Hole pattern - four 5.6 mm diameter holes spaced 100 mm x
100 mm apart.
Operating Temperature
Office Dock, AC adapter,
9 port PEM
Operating Temperature
Vehicle Dock, 7 port PEM
ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corp., registered in many jurisdictions
worldwide. All other trademarks are the property of their respective owners. © 2021 Zebra Technologies Corp. and/or
its affiliates. All rights reserved. | zebra.com
-20 °C to 40 °C (-4 °F to 104 °F)
-20 °C to 60 °C (-4 °F to 150 °F)
MN-004253-02EN Rev A
Inserting the Tablet
1
2
1. If previously installed, ensure the keyboard and handle are
closed.
4. Use your thumb to push the tablet into the dock, then push the
lever down to secure the tablet.
2. Insert the bottom of the tablet into the bottom of the dock (1),
aligning the charging contacts on the tablet with the connector
pins on the dock.
3. Rotate the top of the tablet towards the top of the dock (2).
2
Loading...