ET4X
VESA Mount
Installation Guide
MN-004597-02EN — October 4, 2022
Installation
1
CAUTION: Power off the ET4X before installing or
removing the VESA Mount.
2
CAUTION: Do not use any tool for battery cover
removal. Puncturing the battery or seal may cause a
hazardous condition and a potential risk of injury.
Remove the battery cover and store it in safe place.
3
Insert the tabbed end of the VESA mount into the battery well.
Ensure that the tabs on the VESA mount are aligned with the
slots in the battery well.
Zebra Technologies | 3 Overlook Point |
Lincolnshire, IL 60069 USA
zebra.com | ip.zebra.com
ZEBRA and the stylized Zebra head are
trademarks of Zebra Technologies Corp.,
registered in many jurisdictions worldwide. All
other trademarks are the property of their
respective owners. © 2022 Zebra Technologies
Corp. and/or its affiliates. All rights reserved.
4
Rotate the VESA mount down into the battery well.
5
Carefully press down around the edges of the VESA
mount. Make sure that the cover is seated properly.
6
Using a T5 Torx screwdriver, secure the VESA mount to the
device using four M2 screws.
7
Determine the desired mounting orientation and reroute the
power cable as required. The VESA mount supports portrait
and landscape mounting and provides three cable routing
slots.
8
Mount the device using the included M4 screws. The ET4X
VESA mount supports 75 mm or 100 mm mounting patterns.
9
If using a Zebra DC line cable CBL-DC-388A2-01 (not
included), attach the provided cable clip.
Do not attach the clip if using a third party DC line cable.
10
Attach the VESA mount power cable to the DC line cable.
If using a third party DC line cable, secure the cables using
cable ties or tape
Loading...