Zanussi ZWF1420 USER MANUAL

LAVATRICE

LAVE-LINGE

WASCHAUTOMAT WASHINGMACHINE

ZWF 1220 - ZWF 1420

ZWF 1620

LIBRETTO ISTRUZIONI NOTICE D’UTILISATION GEBRAUCHSANWEISUNG USER MANUAL

I

F

D

132975770

GB

Dear customer,

Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners.

Transport damages

When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre.

The symbols you will see on some paragraphs of this booklet have the following meaning:

The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance.

The information marked with this symbol provides additional instructions and practical tips on the use of the appliance.

Tips and information about economical and ecological use of the machine are marked with this symbol.

Our contribution to the protection of the environment: we use environmentally friendly paper.

Contents

Warnings

75

Temperatures

84

Disposal

76

Before loading the laundry

84

Maximum loads

84

Tips for environmental protection

76

Laundry weights

85

Removing stains

85

 

 

Technical specifications

76

Detergents and additives

85

Installation

77

International wash code symbols

86

Operating sequence

87-89

Unpacking

77

Washing programmes

90

Positioning

77

Maintenance

91

Water inlet

77-78

Door seal

91

Water drainage

78

Bodywork

91

Detergent dispenser drawer

91

Electrical connection

78

Drain pump

91-92

 

 

Description of the appliance

79

Water inlet filter

92

Detergent dispenser drawer

79

Emergency emptying out

92

Frost precautions

92

 

 

Use

80

Something not working?

93-94

Control panel

80

Service Centre List

95

Controls

80-84

 

 

Washing hints

84

 

 

Sorting the laundry

84

 

 

74

Warnings

The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance.

Installation

All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. Refer to the relevant paragraph in the instruction book.

Any electrical work required to install this appliance must be carried out by a qualified electrician.

Any plumbing work required to install this appliance must be carried out by a qualified plumber.

After having installed the machine, check that it is not standing on its electrical supply cable.

If the appliance is placed on a carpeted floor, ensure that air can circulate freely between the feet and the floor.

General safety

Repairs to the machine must be carried out only by qualified personnel. Repairs carried out by inexperienced persons could cause serious danger. Contact your local Service Centre.

Never pull the power supply cable to remove the plug from the socket; always take hold of the plug itself.

During high temperature wash programmes the door glass may get hot. Do not touch it!

Child safety

Children are often not aware of how dangerous electrical appliances can be. When the machine is working, children should be carefully supervised and not be allowed to play with the appliance.

Use

This appliance is designed for domestic use. It must not be used for purposes other than those for which it was designed.

Only wash fabrics which are designed to be machine washed. Follow the instructions on each garment label.

Do not overload the appliance. Follow the instructions in the instruction book.

Make sure that all pockets are empty. Objects such as coins, safety pins, pins and screws can cause extensive damage.

Do not machine wash garments saturated with petroleum, methylated spirits, trichlorethylene, etc. If such fluids have been used to remove stains prior to washing, wait until they have completely evaporated from the fabric before placing garments in the appliance.

Place small items such as socks, belts, etc. in a cloth bag or pillowcase to prevent them getting trapped between the drum and the tub.

Use only the recommended quantities of fabric softener. An excessive amount could damage the laundry.

Leave the porthole door slightly ajar when the appliance is not in use. This preserves the door seal and prevents the formation of musty smells.

Always check that water has emptied out before opening the door. If not, drain the water following the instructions in the instruction book.

Always unplug the appliance and shut the water tap after use.

The packaging components (e.g. plastic film, polystyrene) can be dangerous to children - danger of suffocation! Keep them out of children’s reach.

Keep all detergents in a safe place out of children’s reach.

Make sure that children or pets do not climb into the drum. To avoid this the machine incorporates a special feature. To activate this device, rotate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin.

To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise until the groove is vertical.

P1131

When the appliance is to be scrapped, cut off the electrical supply cable and destroy the plug with the remaining cable. Disable the door catch in order to prevent children from becoming trapped inside while playing.

ENGLISH

75

Disposal

Packaging materials

The materials marked with the symbol are recyclable.

>PE<=polyethylene

>PS<=polystyrene

>PP<=polypropylene

This means that they can be recycled by disposing of them properly in appropriate collection containers.

Machine

Use authorised disposal sites for your old appliance. Help to keep your country tidy!

The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

Tips for environmental protection

To save water, energy and to help protect the environment, we recommend that you follow these tips:

Normally soiled laundry may be washed without prewashing in order to save detergent, water and time (the environment is protected too!).

The machine works more economically if it is fully loaded.

With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a lower temperature.

Measure out detergent according to the water hardness, the degree of soiling and the quantity of laundry being washed.

Technical specifications

DIMENSIONS

Height

85 cm

 

Width

60 cm

 

Depth

63 cm

 

 

 

 

MAXIMUM LOAD

Cotton

5

kg

 

Synthetics

2.5 kg

 

Delicates

2.5 kg

 

Woollens/Handwash

2

kg

 

 

 

SPIN SPEED

 

1200 rpm max. (ZWF 1220)

 

 

1400 rpm max. (ZWF 1420)

 

 

1600 rpm max. (ZWF 1620)

 

 

POWER SUPPLY VOLTAGE/FREQUENCY

220-230 V/50 Hz

TOTAL POWER ABSORBED

 

2200 W

MINIMUM FUSE PROTECTION

 

10 A

 

 

 

WATER PRESSURE

Minimum

0,05 MPa

 

Maximum

0,8

MPa

This appliance complies with the following EEC Directives: 73/23/EEC of 19/02/73 relating to low voltage

89/336/EEC of 03/05/89 relating to electromagnetic compatibility.

76

Zanussi ZWF1420 USER MANUAL

Installation

Unpacking

All transit bolts and packing must be removed before using the appliance.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

1.After removing all the packaging, carefully lay machine on it’s back to remove the polystyrene base from the bottom.

2.Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance.

HEC0008

HEC0001

3.With a suitable spanner unscrew and remove the central rear bolt A. Slide out the relevant plastic spacer.

4.Unscrew and remove the two large rear bolts B and the six smaller bolts C.

HEC0002S

 

 

C

 

 

B

HEC0003S

C

B

5.Remove the bracket D and tighten up the six smaller bolts C.

D

 

C

 

 

HEC0011S

HEC0014

C

6.Open the porthole, take out the inlet hose from the drum and remove the polystyrene block fitted with the adhesive tape on the door seal.

7.Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet.

HEC0010

HEC0005

8.Connect the inlet hose as described under the paragraph “Water Inlet”.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

HEC007S

Water inlet

An inlet hose is supplied and can been found inside the machine drum.

Do not use the hose from your previous machine to connect to the water supply.

1.Open the porthole and extract the inlet hose .

2.Connect the hose with the angled connection to the machine.

Important!

Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap.

ENGLISH

77

HEC0006

3.Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

4.Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance.

P1088

The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying.

This could be done by tying it to the tap with a piece of string or attaching it to the wall.

P0022

In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground.

Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm.

The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked.

P1118

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.

Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.

Connect the machine to an earthed socket.

The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution.

Should the appliance power supply cable need to be replaced, this must be carried out by our Service Centre.

Please ensure that when the appliance is installed the power supply cable is easily accessible.

78

Description of the appliance

1 Detergent dispenser drawer

2 Control panel

3 Door handle

4 Drain pump

5 Adjustable feet

Detergent dispenser drawer

Prewash

Main wash

Fabric softener, starch

1

2

95°C

1200

60°C

900

40°C

700

30°C

500

 

3

 

4

5

ENGLISH

 

C0063

79

Use

Control panel

95°C

1200

60°C

900

40°C

700

30°C

500

 

 

 

 

 

 

 

 

 

 

 

1

2

3

4

5

 

 

7

8

9

11

6

 

 

 

 

 

 

 

 

 

 

10

1 ON/OFF button

Press this button to switch the washing machine on. Press the button again to switch the machine off.

2 MAINS-ON light

This light is connected to the button. It lights up when you press the button, and goes out when you press it again.

3 FABRIC button

Press this button repeatedly to select the programme on the basis of the type of laundry to be washed. The light relevant to the selected programme will light up. The washing machine will propose a temperature and automatically select the maximum spin value provided for the programme you have chosen. You can change these values by operating buttons 4 and 5.

Hand wash

When you select this programme, you obtain a particularly delicate washing, suitable for articles of clothing whose label indicates that they must be hand-washed .

4 TEMPERATURE button

Press this button repeatedly to increase or decrease the temperature, if you want your laundry to be washed at a temperature different from the one proposed by the washing machine. The relevant light will light up.

Maximum temperatures are 95°C for cotton, 60°C for synthetic fabrics, 40°C for delicate fabrics, wool and fabrics to be hand-washed.

Position corresponds to cold wash.

Important!

By depressing and buttons simultaneously, the acoustic signal is switched off in the following cases:

when depressing the buttons

when an incorrect option selection is made

at the end of the programme.

80

Loading...
+ 16 hidden pages