13
the machine is performing the countdown, after having
done so and having
closed the door, press
START/PAUSE
again, in order to
allow the machine to
complete the remaining countdown time.
Indicator lights
These lights indicate
the following functions:
• Drying light
This light indicates
that the appliance
is in the drying
phase.
• End of programme light
This light is on at
the end of the
cooling phase,
during the anticreasing phase
and at the end of
the programme.
• Water reservoir
full light
This light indicates
that the appliance
is in the drying
phase.
This light comes
on at the end of
the programme to
remind you that
the water reservoir must be emptied out. If this
light illuminates
during a programme this
means that the
water reservoir is
full. The buzzer
sounds, the programme stops,
the light of the
Start/Pause
button flashes.
This light comes
on also when the
water reservoir is
not inserted correctly.
• Filter cleaning
This light illuminates at the end
of the programme
to remind you that
the filters must be
cleaned.
• Condenser
cleaning
It comes on every
80 cycles to
remind you that
the condenser
must be cleaned.
Cancelling a
programme
Turn the selector dial
to “O” to cancel a programme which is running. Now you can
select a new programme.
At the end of the
programme
If the laundry is not
removed at the end of
the cycle, the dryer
performs an anticreasing phase (duration: 30 minutes maximum).
If you do not remove
the laundry, the dryer
will stop automatically
at the end of the anticreasing phase.
Lights End/Anticrease
, and remain lit
and the buzzer
sounds for 2 minutes.
Turn the programme
selector dial to “O” to
switch the machine
off. Remove the laundry from the drum and
carefully check that
the drum is empty.
If you do not intend to
carry out another
wash, close the water
tap. Leave the door
open to prevent the
formation of mildew
and unpleasant
smells.
Turn the programme
selector dial to “O”; all
the lights go out. The
appliance is switched
off.
Remove the laundry.
If you open and then
close the door before
turning the selector
dial to “O” all the
lights corresponding
to the phases making
up the performed programme come on.
After each use
• Clean the filters.
• Empty the water
reservoir.
Important!
If the drying programme has to be
stopped before it
reaches the end, we
recommend that you
turn the programme
selector dial to position Cooling and
wait until the end of
this cooling phase
before removing the
laundry. This will
avoid a build-up of
heat inside the appliance.To do this first
turn the dial to “O”
and then to Cooling
and depress Start button.
Modifying
the programme
To change a programme which is running, first cancel it by
turning the programme selector dial
to “O”. Select the new
programme and press
the Start button.