Yamaha YBA-10 Owners manual
YBA-10
Bluetooth Wireless Audio Receiver
Récepteur Audio Sans Fil Bluetooth
Bluetooth ワイヤレス オーディオ レシーバー
OWNER’S MANUAL
MODE D‘EMPLOI
BEDIENUNGSANLEITUNG
BRUKSANVISNING
MANUALE DI ISTRUZIONI
MANUAL DE INSTRUCCIONES
GEBRUIKSAANWIJZING
ИНСТРУКЦИЯ ПО ЗКСПЛУАТАЦИИ
使用说明书
사용 설명서
取扱説明書
English
Français
Deutsch
Svenska
Italiano
Español
Nederlands
Русский
中文
한국어
日本語
FCC INFORMATION (for US customers)
1 IMPORTANT NOTICE : DO NOT MODIFY
THIS UNIT!
This product, when installed as indicated in the
instructions contained in this manual, meets FCC
requirements. Modifications not expressly
approved by Yamaha may void your authority,
granted by the FCC, to use the product.
2 IMPORTANT : When connecting this product to
accessories and/or another product use only high
quality shielded cables. Cable/s supplied with this
product MUST be used. Follow all installation
instructions. Failure to follow instructions could
void your FCC authorization to use this product in
the USA.
3 NOTE : This product has been tested and found to
comply with the requirements listed in FCC
Regulations, Part 15 for Class “B” digital devices.
Compliance with these requirements provides a
reasonable level of assurance that your use of this
product in a residential environment will not r esult
in harmful interference with other electronic
devices.
This equipment generates/uses radio frequencies and,
if not installed and used according to the instructions
found in the users manual, may cause interference
harmful to the operation of other electronic devices.
Compliance with FCC regulations does not guarantee
that interference will not occur in all installations. If
this product is found to be the source of interference,
which can be determined by turning the unit “OFF”
and “ON”, please try to eliminate the problem by using
one of the following measures:
Relocate either this product or the device that is being
affected by the interference.
Utilize power outlets that are on different branch
(circuit breaker or fuse) circuits or install AC line
filter/s.
In the case of radio or TV interference, relocate/
reorient the antenna. If the antenna lead-in is 300 ohm
ribbon lead, change the lead-in to coaxial type cable.
If these corrective measures do not produce
satisfactory results, please contact the local retailer
authorized to distribute this type of product. If you can
not locate the appropriate retailer, please contact
Yamaha Electronics Corp., U.S.A. 6660 Orangethorpe
Ave, Buena Park, CA 90620.
The above statements apply ONLY to those products
distributed by Yamaha Corporation of America or its
subsidiaries.
COMPLIANCE INFORMATION STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not cause harm ful interference, and
2) this device must accept any interference received including interference that may cause undesired operation
of this device.
See user manual instructions if interference to radio reception is suspected.
i En
This equipment compiles with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meets
the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply
without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and
operated with at least 20 cm and more between the radiator and person’s body (excluding extremities: hands,
wrists, feet and ankles).
NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING
Change or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
ii En
■ Precautions
Read this before using this unit.
To assure the finest performance, please read this manual carefully. Keep it in a safe place for future
reference.
1 Install this unit in a cool, dry, clean place away
from direct sunlight, heat sources, and sources
of excessive vibration, dust, moisture, and/or
cold. (Do not use/keep this unit in a car etc.)
2 Locate this unit away from other electrical
appliances, motors, or transformers to avoid
humming sounds.
3 Do not expose this unit to sudden temperature
changes from cold to hot, and do not locate
this unit in an environment with high humidity
(i.e. a room with a humidifier) to prevent
condensation inside this unit, which may cause
an electrical shock, fire, damage to this unit,
and/or personal injury.
If there should be color blotching or noise when used near a TV, move this unit away from the
TV when using it.
Do not use this unit within 22 cm (9 inches) of persons with a heart pacemaker implant or
defibrillator implant.
We, the manufacturer Yamaha hereby declare that the YBA-10 is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
The user shall not reverse engineer, decompile, alter, translate or disassemble the software
used in this unit, whether in part or in whole. For corporate users, employees of the
corporation itself as well as its business partners shall observe the contractual bans stipulated
within this clause. If the stipulations of this clause and this contract cannot be observed, the
user shall immediately discontinue using the software.
This symbol mark is according to the EU directive 2002/96/EC.
This symbol mark means that electrical and electronic equipment, at their end-oflife, should be disposed of separately from your household waste.
Please act according to your local rules and do not dispose of your old products
with your normal household waste.
iii En
4 Do not clean this unit with chemical solvents;
this might damage the finish. Use a clean, dry
cloth.
5 Do not attempt to modify or fix this unit.
Contact qualified Yamaha service personnel
when any service is needed. The cabinet
should never be opened for any reason.
6 Be sure to read the “Troubleshooting” section
regarding common operating errors before
concluding that the unit is faulty.
Loading...