Specifications and Main Features
- Engine Type: 4 Valve Engine (2 for intake and 2 for exhaust)
- Cylinder Configuration: DOHC with balance shaft
- Fuel System: YDI (Yamaha Dual Intake System)
- Carburetor: Primary and Secondary Carburetors with Vacuum Operated Piston Throttle Valves
- Oil Change: Every 6,000 km (4,000 miles)
- Ignition Timing: 12° Before Top Dead Center (BTDC) at 1.4krpm
- Valve Adjustment:
- Intake: 0.08 ~ 0.12 mm (0.003 ~ 0.005 in)
- Exhaust: 0.13 ~ 0.17 mm (0.005 ~ 0.007 in)
- Clutch Unit: It has a coasting enricher
- Front Fork: Air pressure/spring: nominal chamber pressure 0 kPa , chamber pressure 20 kPa
- Braking Unit: The front brake is equipped with DOT#3 brake fluid and brake pads but not less than a wear limit of 0.8 mm.
- Electrical Partition:
- Battery Type: GM3-38/FB3L-B
- Battery Voltage: 12 V 3 AH
- Density: 1,260
- Charging Device: The charging coil has a resistance of 0.460 plus or minus 10 % at 20 degrees Celsius.
Frequently Asked Questions
2) Common Queries
- What sort of engine is XT350 equipped with?
- The XT350 is equipped with a 4 Valve DOHC engine configured with a dual intake system.
- What is the appraised and allowable gap of the intake and exhaust valves?
- The recommended intake valve gap is 0.08 to 0.12 mm while the recommended exhaust valve gap is 0.13 to 0.17 mm.
- When is the Appropriate Time for lubrication servicing and care?
- It is recommended that the lubrication system is serviced every 6000 km or every 4000 miles.
- Which brake fluid is suggested for use in the front brake system of the XT350?
- It is recommended that the front brake system of the XT350 uses DOT #3 brake fluid.
- At a temperature of 20 degrees Celsius, what is the recommended ohmic value of a charging coil?
- At 20 degrees Celsius, the coil charging resistance is estimated to be 0.460 plus or minus 10 percent.
User Manual
Page 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
Page 12
Page 13
Page 14
Page 15
Page 16
Page 17
Page 18
Page 19
Page 20
Page 21
Page 22
Page 23
Page 24
Page 25
Page 26
Page 27
Page 28
Loading...