Xerox CentreWare DC220, CentreWare DC230ST Quick Install Manual

The Document Company
XEROX
DC220/230ST CentreWare® Internet Services Quick Install
1. Connect the DC220/230 to your network
outlet or cable.
2. Enter System Administrator Setups:
Control Panel.
b) Enter the System Administrator
password by typing #22222 (# key and 22222) on the keypad and pressing [Enter] on the screen.
Note: #22222 is the factory default
password and may be changed by your Xerox service representative to suit your needs.
3. Access the TCP/IP Network Setups
screen:
a) On the screen display, press [Print
Setups].
b) Press [Network Setups]. c) Press [TCP/IP]. If TCP/IP has been
enabled and configured, skip to step 4.
d) IP Address setup (skip this step if
using RARP): Press [IP Address],
then press [Edit] and use the key­board on the display screen to enter the static IP address for the DC220/
230. This number is assigned by the System Administrator
OR
d) RARP setup (skip this step if
using a static IP address): Press
[RARP], then press [Enabled].
e) Press [Save]. f) Press [Gateway Address], then press
[Edit] and use the keyboard on the display screen to enter the Gateway address of your network.
g) Press [Save]. h) Press [Subnet Mask], then press
[Edit], and use the keyboard on the display screen to enter the Subnet Mask for your network (default is
255.255.255.0.
i) Press [Save].
Over
The Xerox DC220/230ST contains an embedded Web Server. CentreWare Internet Services contains tools within the Web Page that allow users to check the status of the queue, submit print ready files as print jobs, scan jobs, configure scanning templates, etc.
In addition, after Internet Services is enabled, machine network configuration and setup can be accomplished from the System Administrator’s desktop (password required).
Before Installation:
Record the following information for use during setup at the DC220/230:
TCP/IP Address:_________________________ Gateway Address:_______________________ Subnet Address:_________________________ Broadcast Address:______________________ Host Name:_____________________________ A minimum configuration of Microsoft Internet
Explorer® 4.x or higher, or Netscape Navigator®
3.x or higher should be used. Other browsers may work, but may not produce expected results.
For assistance, contact your local Xerox Customer Support Center: USA: 1-800-821-2797 Canada: 1-800-939-3769
The Document Company
XEROX
DC220/230ST CentreWare® Internet Services Quick Install
5. Press [HTTP].
6. Enable HTTP:
a) Press [Enablement]. b) Press [Enabled].
Note:The Port Number and the Maximum Num­ber of Connections are predetermined.
7. Press [Save].
8. Press [Exit] on the Network Setups
screen. The DC220/230 will reboot and print a configuration sheet in approxi­mately 3 minutes.
9. Check the settings on the configuration
sheet against those that were entered.
10.At a client workstation on the network,
open the Internet Browser.
11.In the URL field, enter http:// followed
by the IP address of your DC220/230. Example: If the IP address is 127.0.0.1, the URL would be http://127.0.0.1.
Refer to the CentreWare manual, Getting Started with Print and Fax Services for addi­tional information.
Additional information on network installation can be found in the DC220/230 System
Administration Guide.
j) Press [Broadcast Address], then
press [Edit] and use the keyboard on the display screen to enter the Broadcast Address of your network.
Note: The Broadcast Address is the address where all host bits are set to either zero (0) or one (1).
k) Press [Save]. l) Press [Host Name], then press [Edit]
and use the keyboard on the display screen to enter the Host Name you want your DC220/230 to use.
m) Press [Save]. n) Press [Save] on the TCP/IP screen to
save all the network settings.
o) Press [Exit] on the Network Setups
screen.
4. Press [Additional Setups] in the upper
right corner of the screen.
©1998 Xerox Corporation 701P97996 Version 1.1, 5-98
For assistance, contact your local Xerox Customer Support Center: USA: 1-800-821-2797 Canada: 1-800-939-3769
Loading...