Wolf 821346, 821345 Installation

TEMP

MODE

LIGHT

WATER

TIME

OFF

POWER

ON

OVEN MOUNTING HOLES

Contents

Qty Description

4 Screw, #8-18 x 1/2"

1 Trim Panel Assy, LH

1 Trim Panel Assy, RH

1 Instructions

Convection Steam Oven Trim Installation

wolfappliance.com 800.222.7820

3) Carefully place the oven in the opening. Resting the

oven on the cabinet base support, slide the unit into the
opening until it is approximately 6" (152) from being fully
installed. Guide the power cord through the opening
of the adjacent cabinet or base support as the oven is
slid into position. Verify the power cord is not trapped
between the oven and cabinet wall.

Trim Installation

Trim kits are an optional sales accessory and not required
to install the convection steam oven.

IMPORTANT NOTE: Before moving the oven, protect any

nished ooring and cabinetry to avoid damage.

1) Move the convection steam oven into position near
the installation opening. Remove and discard packing
materials.

2) Position the trim panels as shown below. When
properly oriented, the four mounting holes will be
positioned near the bottom of the four spacers.

SPACER

MOUNTING

HOLE

4) Continue to slide the unit back into position until it is

1

/4" (6) proud of the cabinet face frame. Open the oven
door and locate the four mounting holes on the oven
side trim. Refer to the illustration below. Use a 1/16" drill
bit to drill pilot holes into the cabinet.

5) Locate the four mounting screws provided. Place the
left trim panel behind the oven side trim. Slide the left
side of the oven back and install two of the mounting
screws just far enough to hold the trim in place. Repeat
with the right trim panel.

6) To complete the installation, verify the trim panels align
with oven trim and securely tighten all four mounting
screws.

Failure to install the mounting screws may cause the
oven to tip forward during use.

Trim panel orientation.

Oven installation with trim.

819649 819650 819651 819652

Page 1 of 1819988 REV-A 11/2011