Wolf 819075, 819076, 819077, 819078, 819079 Installation

Contents

Gas Range Riser Installation

wolfappliance.com 800.222.7820

Gas Range Riser

1 Assembly, stainless steel riser

2 Supports, side

12 Screws, sheet metal

1 Shelf, stainless steel (20" tall riser only)

6 Screws, shoulder (for shelf installation only)

1 Instructions

Riser Installation

INSTALL SIDE SUPPORTS

Place riser assembly on a protected work surface, front
side down and remove the protective material from the
back of the assembly. Limit the amount of material removed
to ensure the stainless steel is protected throughout the
assembly process. Install the side support brackets using
two screws per side, three for 20" (508) tall riser. Refer to
the illustration below.

ISLAND TRIM

INSTALL RISER

Remove the back panel and island trim from the range by
extracting the screws along the top and both sides. Place
the new riser on the range. For ranges with a griddle, verify
the front of the riser is positioned between the griddle vent
and griddle support. With the riser properly positioned,
secure using three screws per side. For 48" (1219) and
60" (1524) risers, insert one screw into the center support
bracket. Once riser is secure, reinstall back panel using
existing screws. Refer to the illustrations below.

RISER FRONT

GRIDDLE

SUPPORT

GRIDDLE

VENT

Range with griddle.

Insert riser supports.

CENTER

SUPPORT BRACKET

Attach side supports.

BACK PANEL

Remove trim and panel.

INSTALL SHELF—20" (508) TALL RISER ONLY

Remove all remaining protective material from the riser.
Install two shoulder screws per side. For the 60" (1524) riser,
install one screw in the center. Align the keyhole slots on
the shelf with the shoulder screws and lower the shelf into
position. Refer to the illustration below.

SHELF

KEYHOLE

SLOTS

SHOULDER

SCREWS

Attach shelf.

Page 1 of 1821270 REV-B 10/2012