White Rodgers 760-802, 760-401, 760-56 Installation Instructions

760 Series

WHITE-RODGERS

Operator: Save these instructions for future use!

FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.

The 760 series electrodes are made in various configura­tions to meet the specific requirements of different appli­cations. Depending on electrode design, they may be
used for spark ignition, flame sensing or a combination of
both.

Electrodes

INST ALLA TION INSTRUCTIONS

DESCRIPTION

These electrodes are not universal replacements. They
can only be used to replace the identical type in applica­tions where it was originally installed by the equipment
manufacturer. If the electrode you are replacing is not the
same type number, contact the original equipment manu­facturer (OEM) for a suggested replacement.

TYPICAL ELECTRODE ASSEMBLIES

THESE CONTROLS MUST BE INSTALLED BY A
QUALIFIED INSTALLER.

All wiring must conform to local and national electrical
codes and ordinances.

WARNING

!

Do not use on circuits exceeding specified volt­ages. Higher voltages will damage control and
could cause shock or fire hazard.

Shut off main gas to heating system until installa­tion is complete.

WHITE-RODGERS DIVISION

EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MO 63123-5398
[phone] FAX [phone]

Printed in U.S.A.

PRECAUTIONS

CAUTION

!

To prevent electrical shock and/or equipment
damage, disconnect electric power to system at
main fuse or circuit breaker box until installation
is complete.

Label all wires prior to disconnection when ser­vicing controls. Wiring errors can cause improper
and dangerous operation.

Following installation or replacement, follow
appliance manufacturers’ recommended instal­lation/service instructions to insure proper
operation.

PART NO. 37-5636A

9645

INSTALLATION

If the equipment manufacturer has provided installation
instructions, follow those instructions. If none are avail­able, use the following general replacement instructions
as a guideline.

CAUTION

!

On assemblies with three electrodes, do not dis­assemble ground plate from electrode assembly.
This could change the factory set gap causing
poor ignition.

1. Shut off electric power and gas supply to the heater or
device until installation is complete.

2. Remove existing electrode assembly. Be sure to
label all wires before disconnecting. This will help
when reconnecting leads to the new electrode as­sembly.

3. Install new electrode assembly. Make sure that new
electrode is in the same position relative to the burner
as the old electrode. Attach using screws or hardware
previously removed. Connect all wires.

4. Turn on gas and electrical power to the system.
Check the system for proper operation. Follow the
appliance manufacturer's recommended installation
and/or service instructions to insure proper operation.

2