61902006GB.fm Page 12 Thursday, February 22, 2007 10:04 AM
INSTRUCTIONS FOR USE
BEFORE USING THE GLASS-CERAMIC COOKTOP
INSTALLATION ELECTRICAL CONNECTIONS ENERGY SAVING TIPS
SAFEGUARDING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
CARE AND MAINTENANCE OF THE GLASS-CERAMIC COOKTOP
TROUBLESHOOTING GUIDE AFTER SALES SERVICE
12
61902006GB.fm Page 13 Thursday, February 22, 2007 10:04 AM
BEFORE USING THE GLASS-CERAMIC COOKTOP
CAUTION: This cooktop complies with all applicable safety and electromagnetic compatibility legislation.
However, persons with pacemaker should keep at a safe distance from the appliance. This is because it is not possible to guarantee that all pacemakers on the market comply with the standards in compliance with which this appliance was tested so it is not possible to provide an absolute guarantee of the absence of potentially harmful interference.
•To make the most of your new appliance, please read the user instructions carefully and keep them handy for future consultation.
INSTALLATION
Cooktop
•The cooktop must be set into a worktop the thickness of which must be between 30 mm and 50 mm
•For the distance between the underside of the glassceramic cooktop and the cupboard or separating panel beneath it, observe the dimensions given in figure “A”.
•If the cooktop is to be installed next to a column unit, leave a distance of at least 100 mm from the edge of the cooktop.
•Cut an opening in the worktop of the dimensions shown in the Product Description Sheet supplied separately.
•Apply the supplied gasket to the cooktop (unless it has already been fitted), after having cleaned the surface.
Important
In order to prevent the electronic circuits from overheating with consequent damage, we recommend the following:
•Do not install the cooktop near a dishwasher or washing machine, so that the electronic circuits do not come into contact with steam or moisture, which could damage them.
If an oven (manufactured by us) is to be installed under the cooktop, ensure it is equipped with a cooling system and observe the distances given in figure “B”. There must be nothing between the cooktop and the oven (cross rails, panels, brackets, etc.).
If the oven has a self-cleaning function (pyrolysis), do not use the cooktop whilst this function is selected.
If the temperature of the electronic circuits exceeds the maximum permitted value, the cooktop will switch off automatically; in this case, wait for a few minutes until the internal temperature of the electronic circuits reaches a tolerable level, at which point it will be possible to switch the cooktop on again.
• Switch the cooktop off after use.
Rear wall
Front
A
B
13
61902006GB.fm Page 14 Thursday, February 22, 2007 10:04 AM
INSTALLATION
Assembly
A)If the worktop is made of wood, use the appropriate brackets, spring clips and screws provided.
•Position the 4 clips (A) around the cooktop frame, in the slots provided, see Fig. 1
•Measure the centre of the vertical sides of the cut out a shown in Fig. 2.
• Position the centre of the brackets (C) on the centre of the |
Fig. 1 |
A |
side previously identified. |
|
|
•The upper edge of the brackets must be flush with the worktop surface.
•Secure using the 4 screws (B) provided that should screwed into the pre-prepared holes.
•Insert the cook hob into the pre-prepared hole ensuring that
the clips (A) lodge into the bracket slots provided |
|
Fig. 2 |
(C Fig. 4 e 5). |
|
|
|
C |
|
|
|
|
|
|
|
|
B |
|
|
Fig. 3 |
|
A
Fig. 4
B)If the worktop is made of marble or other materials (plastic compounds, ceramics, stone, etc.), the hob must be fitted by ordering the KIT to the Service.
Fig. 5
14
Loading...